2008 MITSUBISHI SHOGUN oil level

3-10 Instruments and controls
3
Indicator and warning lamps
E00501501353
1- Turn-signal indication lamps/Hazard warning indication
lamps
→ p. 3-12
2- Rear fog lamp indication lamp
→ p. 3-12
3- Position lamp indication lamp
→ p. 3-12
4- Front fog lamp indication lamp*
→ p. 3-12
5- Automatic headlamp levelling warning lamp*
→ p. 3-64
6- High-beam indication lamp
→ p. 3-12
7- Active stability control function OFF indication lamp
→ p. 4-67
8- Active stability control function indication lamp/Active trac-
tion control function indication lamp
→ p. 4-67, 4-69
9- Anti-lock brake system (ABS) warning lamp
→ p. 4-60
10- Brake warning lamp
→ p. 3-13
11- Supplemental restraint system (SRS) warning lamp
→ p. 2-75
12- Seat belt warning lamp
→ p. 2-40
13- A/T fluid temperature warning lamp (vehicles with A/T)
→ p. 4-31
14- CRUISE indication lamp*
→ p. 4-72
15- “SONAR OFF” indication lamp*
→ p. 4-84
16- Diesel particulate filter (DPF) warning lamp*
→ p. 4-22
17- Diesel preheat indication lamp (diesel-powered vehicles)
→ p. 3-12
18- Fuel filter indication lamp (diesel-powered vehicles)
→ p. 3-13
19- Check engine warning lamp
→ p. 3-15
20- Charge warning lamp
→ p. 3-16
21- Oil pressure warning lamp
→ p. 3-16
22- Low fuel warning lamp
→ p. 3-8
23- 2WD/4WD operation indication lamp
→ p. 4-38
BK-BK2008E1ENUK.en-uk-Section6.fm Page
10 Wednesday, January 9, 2008 4:32 PM

3-16 Instruments and controls
3
Charge warning lamp
E00502700472
This lamp illuminates when the ignition switch is turned to the “ON” position, and goes off after the engine has started.
Oil pressure warning lamp
E00502800529
This lamp illuminates when the ignition switch is turned to the “ON” position, and goes off after the engine has started. If it illuminates while the engine is running, the oil pressure is too low.Turn the engine off and have it inspected.
CAUTION
!●
If it illuminates while the engine is run- ning, there is a problem in the charg- ing system. In this case, immediatelypark your vehicle in a safe place and we recommend you to have it checked.
CAUTION
!●
This warning lamp does not indicate the amount of oil le
vel in the engine.
This must be determined by checking the oil level on the
dipstick, while the
engine is switched off.
●
If this lamp illum
inates when the
engine oil level is not low, have itinspected.
●
If you continue driving with low engine oil level or with this warning lamp illu-minated, engine seizure may occur.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
16 Wednesday, January 9, 2008 4:32 PM

Starting and driving
4-53
4
Inspection and main
tenance following
rough road operation
E00606700048
After operating the vehicle in rough road conditions, be sure to perform the following inspection and maintenance procedures: ●
Check that the vehicle has not been damaged by rocks, gravel, etc.
●
Carefully wash the vehicle with water. After washing, drive the vehicle slowly while lightlydepressing the brake pedal in order to dry out the brakes. If the brakes still do not function properly, we recommend you to have the brakes checked as soon as possible.
●
Remove the insects, dried grass, etc. clogging the radiator core.
●
After crossing a stream, be sure to have the following items inspected at a MITS
UBISHI MOTORS Authorized
Service Point and take the necessary measures. • Check the brake system and,
if necessary, have it serv-
iced. • Check the engine, transmissi
on, transfer, and differential
oil or grease level and turbid
ity. If the oil or grease is
milky, it indicates water co
ntamination. Replace it with
new oil or grease. • Grease the propeller shaft.• Check the inside of the vehi
cle. If ingress of water is
found, dry the carpet etc. • Inspect the headlamps. If th
e headlamp bulb is flooded
with water, we recommend you to have it drained.
Cautions on handling
of 4-wheel drive
vehicles
E00606800401
Tyres and wheelsSince the driving torque can be
applied to the 4 wheels, the per-
formance of the vehicle when
operating in 4-wheel drive is
greatly affected by th
e condition of the tyres.
Pay close attention to the tyres. ●
Install specified tyres on all
wheels. Refer to “Tyres and
wheels” on page 9-13.
●
Be sure to fit all 4 tyres an
d wheels of the same size and
type. When replacement of any of th
e tyres or wheels is neces-
sary, replace all of them.
●
All tyres should be rotated
whenever the wear difference
between the front and rear tyres is recognizable.
BK-BK2008E1ENUK.en-uk-Section7.fm Page
53 Wednesday, January 9, 2008 4:36 PM

6-8 For emergencies
6
5. Check the coolant level in the reserve tank (A). 6. Add
coolant to the radiator and/or reserve tank if neces-
sary. (Refer to the “Maintenance” section.)
7. Examine the radiator hoses
for coolant leakage and the
drive belt for looseness or damage. If there is anything wrong with the cooling system ordrive belt, we recommend you to have it check and repaired.
WARNING
!●
If there is none, make sure that the engine has cooled down before removi
ng the radiator cap (B),
because hot steam or boiling water otherwise will gush from the filler port and may scald you.
CAUTION
!●
Do not add coolant while the engine is hot. Suddenly adding cold coolant coul
d damage the engine. Wait
for the engine to cool down
, then add coolant a little
at a time.
BK-BK2008E1ENUK.en-uk-Section9.fm Page 8 Wednesday, January 9, 2008 4:46 PM

8-6 Maintenance
8
Engine oil
E01000401171
To check and refill engine oil
The engine oil used has a signifi
cant effect on the engine’s per-
formance, service life and startabi
lity. Be sure to use oil of the
recommended quality and appropriate viscosity. All engines consume a certain amount of oil during normal operation. Therefore, it is important to check the oil level atregular intervals or before starting a long trip.
3200 models
3800 models
BK-BK2008E1ENUK.en-uk-Section11.fm Page
6 Wednesday, January 9, 2008 4:50 PM

Maintenance
8-7
8
1. Park the car on a horizontal surface. 2. Switch off the engine. 3. Wait a few minutes. 4. Remove the dipstick and wi
pe it with a clean cloth.
5. Reinsert the dipstick as far as it goes. 6. Remove the dipstick and read the oil level, which should
always be within the range indicated.
7. If the oil level is below the specified limit, remove the cap
located on the cylinder head cover and add enough oil to raise the level to within the specified range. Do not over-fill to avoid engine damage. Be sure to use the specified engine oil and do not mix various types of oil.
8. After adding oil, cl
ose the cap securely.
9. Confirm the oil level by repeating step 4 to 6. Use only the recommended oils wi
th an ACEA or API classifi-
cation as specified in this manual.
NOTE●
Engine oil consumption is greatly influenced by payload, engine speed, etc. It may
reach 1.0 lit./1,000 km depend-
ing on style of driving.
●
The engine oil will deterior
ate rapidly if the vehicle is
subjected to severe conditions, requiring earlier oil replacement. Please refer to the maintenance schedule.
●
For handling of used engine oils, refer to page 8.
BK-BK2008E1ENUK.en-uk-Section11.fm Page
7 Wednesday, January 9, 2008 4:50 PM