2008 MITSUBISHI SHOGUN inflation pressure

ForewordE09200101932
Thank you for selecting a SHOGUN as your new vehicle.
This owner’s manual will add to your understanding and full
enjoyment of the many fine features of this vehicle.
It contains information prepared to acquaint you with the
proper way to operate and maintain your vehicle for the utmost
in driving pleasure.
MITSUBISHI MOTORS Europe B.V. reserves the right to
make changes in design and specifications and/or to make
additions to or improvements in this product without obligation
to install them on products previously manufactured.
It is an absolute requirement for the driver to strictly observe
all laws and regulations concerning vehicles.
This owner’s manual has been written in compliance with
such laws and regulations, but some of the contents may
become contradictory with later amendment of the laws and
regulations.
Please leave this owner’s manual in this vehicle at time of
resale. The next owner will appreciate having access to the
information contained in this owner’s manual.
Repairs to your vehicle:
Vehicles in the warranty period:
All warranty repairs must be carried out by a MITSUBISHI
MOTORS Authorized Service Point.
Vehicles outside the warranty period:
Where the vehicle is repaired is at the discretion of the owner.
Throughout this owner’s manual the words WARNINGand
CAUTIONappear.
These serve as reminders to be especially careful. Failure to follow
instructions could result in personal injury or damage to your vehicle.
indicates a strong possibility of severe personal injury or
death if instructions are not followed.
means hazards or unsafe practices that could cause minor
personal injury or damage to your vehicle.
You will see another important symbol:
NOTE: gives helpful information.
*: indicates optional equipment.
It may differ according to the sales classification; refer to
the sales catalogue.
Abbreviations used in this owner’s manual:
LHD: Left-Hand Drive
RHD: Right-Hand Drive
M/T: Manual Transmission
A/T: Automatic TransmissionInformation for station service
E09300100486
OBKX08E1
BL071501
8
WARNING
CAUTION
Fuel tank capacity3-door models 69 litres5-door models 88 litres
Petrol-powered vehicles
Unleaded petrol octane number (EN228)
95 RON or higher
FuelDiesel-powered vehicles
Fuel requirementsVehicles to comply with the Euro 4 regulation
Cetane number (EN590)
51 or higher
Vehicles to comply with the Euro 3 regulation
Cetane number
45 or higher
Refer to the “Fuel selection” for details.
Engine oil Refer to the “Maintenance” section of this owner’s manual for the SAE viscosity.
Tyre inflation pressure Refer to the “Maintenance” section for the tyre inflation pressure.
© 2007 Mitsubishi Motors Corporation
Mitsubishi Motors Europe B.V.
eng_CV_SHOGUN_Pajero08.qxd 26-12-2007 15:55 Page 2

Overview
Outside (Rear)
E00100502564
Rear turn-signal lamps* p. 3-65, 8-36, 8-44
Fuel tank filler p. 3
Reversing lamps p. 8-36, 8-44
Licence plate lamps p. 3-58, 8-36, 8-49
Spare wheel p. 6-17
Backdoor p. 1-13
High-mounted stop lamp p. 8-36, 8-48
Rear window wiper and washer p. 3-75
Tyre inflation pressure p. 8-19 Changing tyres p. 6-16 Tyre rotation p. 8-21Tyre chains p. 8-23
Rear fog lamp p. 3-67, 8-36, 8-47
Stop and tail lamps* p. 3-58, 8-36, 8-44 Stop lamps* p. 8-36, 8-44
Spare wheel garnish p. 6-18
Tail lamps* p. 3-58, 8-36, 8-44
3-door models 5-door models Rear turn-signal lamps* p. 3-65, 8-36, 8-44
Rear turn-signal lamps*
p. 3-65, 8-36, 8-44
Stop and tail lamps* p. 3-58, 8-36, 8-44 Stop lamps* p. 8-36, 8-44
Reversing lamps p. 8-36, 8-44
Rear-view camera* p. 4-84
Corner and back sensor* p. 4-78
BK-BK2008E1ENUK.en-uk-Section2.fm Page 9 Wednesday, January 9, 2008 4:26 PM

4-2 Starting and driving
4
Economical driving
E00600100561
For economical driving, there ar
e some technical requirements
that have to be met. The prerequisite for low fuel consumption is a properly adjusted engine. In order to achieve longer life ofthe vehicle and the most econo
mical operation, we recommend
you to have the vehicle checked
at regular intervals in accord-
ance with the service standards.Fuel economy and generation of exhaust gas and noise are highly influenced by personal driving habits as well as the par- ticular operating conditions. The following points should beobserved in order to minimize w
ear of brakes, tyres and engine
as well as to reduce environmental pollution.StartingAvoid rapid acceleration and sudden starts; such operation will result in higher fuel consumption.ShiftingShift only at an appropriate
speed and engine speed. Always
use the highest gear possible. The transfer shift lever should be set to “2H” when driving on normal roads and express ways to obtain best possible fueleconomy.City trafficFrequent starting and stopping
increases the average fuel con-
sumption. Use roads with smooth
traffic flow whenever possi-
ble. When driving on congested
roads, avoid use of a low gear
at high engine speeds.
IdlingThe vehicle consumes fuel even during idling. Avoid extended idling whenever possible.SpeedAt higher vehicle speed, more fu
el is consumed. Avoid driving
at full speed. Even a slight re
lease of the accelerator pedal will
save a significant amount of fuel.Tyre inflation pressureCheck the tyre inflation pressure
s at regular intervals. Low tyre
inflation pressure increases ro
ad resistance and fuel consump-
tion. In addition, low tyre pres
sures adversely affect tyre wear
and driving stability.LoadDo not drive with unnecessary articles in the luggage compart- ment. Especially during city dr
iving where frequent starting
and stopping is necessary, the increased weight of the vehicle will greatly affect fuel consumption. Also avoid driving with unnecessary luggage or carriers,
etc., on the roof; the increased
air resistance will increase fuel consumption.Cold engine startingStarting of a cold engine consumes more fuel. Unnecessary fuel consumption
is also caused by keeping a hot
engine running. After the engine is started, commence driving as soon as possible.Air conditioningThe use of the air conditioning
will increase the fuel consump-
tion.
BK-BK2008E1ENUK.en-uk-Section7.fm Page 2 Wednesday, January 9, 2008 4:36 PM

4-54 Starting and driving
4
Good vehicle performance cannot be expected if there is a dif- ference in wear between tyres. Refer to “Tyre rotation” on page 8-21. ●
Check the tyre inflation pressure regularly.
●
If the tyre inflation pressure
is inappropriate, the transfer
gear may make some noise and shock while changing the drive mode.
To w i n gIf towing is necessary, we recommend you to have it done byyour MITSUBISHI MOTORS Authorized Service Point or acommercial tow
truck service.
In the following cases, transpor
t the vehicle using a tow truck.
●
The engine runs but the vehicle does not move or abnor- mal noise is produced.
●
Inspection of the vehicle’s und
erside reveals that oil or
some other fluid is leaking.
Only when you cannot receive a towing service from a MIT- SUBISHI MOTORS Authorized
Service Point or commercial
tow truck service, tow your ve
hicle carefully in accordance
with the instructions given in “Towing” on page 6-29.
CAUTION
!●
Always use tyres of the same size, same type, and same brand, and which have no wear differences.Using tyres which differ in size, type, brand or the degree of wear will cause excessive loading, resulting in possible damage to the drive system.
CAUTION
!●
Be sure to shift the tran
sfer shift lever to the “2H”
position. Never try to tow with the transfer shift lever in the “4H”, “4HLc” or “4LLc” positions and with any of the wheels on
the ground (Type A or B).
This could result in damage to the vehicle’s driving system, or the vehicle could become separated from the tow truck and unexpected
accident might result.
If you cannot shift the tr
ansfer shift lever to “2H”
position or the transmission is malfunctioning or damaged, transport the ve
hicle with all the wheels
on a carriage (Type C or D) as illustrated.
BK-BK2008E1ENUK.en-uk-Section7.fm Page
54 Wednesday, January 9, 2008 4:36 PM

6-18 For emergencies
6
To remove the spare tyre
E00803300016
1. Open the backdoor. 2. Open the lids (A) inside of the backdoor.
CAUTION
!●
Grasp the spare wheel firmly when removing or attaching it.
●
When removing the spare wheel, put on gloves. Removing the spare wheel with your bare hands may cause injury to the fingers.
●
The tyre pressure should
be periodically checked
and maintained at the speci
fied pressure while the
tyre is stowed.Driving with an insufficient tyre pressure can lead to an accident. If you have no choice but to drive with an insufficient tyre pres
sure, keep your speed down
and inflate the tyre to the
correct pressure as soon as
possible. (Refer to “Tyre
inflation pressures” on
page 8-19.)
BK-BK2008E1ENUK.en-uk-Section9.fm Page
18 Wednesday, January 9, 2008 4:46 PM

6-28 For emergencies
6
13. Check your tyre inflation pressure at the next gasstation.
The correct pressures are shown
on the door label. See the
illustration.
To store the flat tyre or spare tyre
E00803400075
1. Attach the wheel to the spare wheel hanger (A) while
aligning the holes in the wheel with the bolts on the spare wheel hanger. Using the wheel nut wrench,
tighten the spare wheel nuts
firmly. Tightening torque 37 to 54 Nm (Achieved by applying a force of 140 to 200 N at the end of the wheel nut wrench s
upplied with the vehicle.)
CAUTION
!●
After changing the tyre
and driving the vehicle
about 1,000 km (620 miles)
, retighten the wheel nuts
to make sure that they have not come loose.
●
If the steering wheel vibr
ates when driving after
changing the tyre, we recommend you to have thetyres checked for balance.
●
Do not mix one type of tyre with another or use a different size from the one listed. This would causeearly wear and poor handling.
BK-BK2008E1ENUK.en-uk-Section9.fm Page
28 Wednesday, January 9, 2008 4:46 PM

Maintenance
8-19
8
Tyres
E01001300239
Tyre inflation pressures
E01001401064
Check the tyre inflation pressure of all th
e tyres while they are cold; if insufficient
or excessive, adjust to the specified v
alue.
After the tyre inflation pressure has been
adjusted, check the tyres for damage and ai
r leaks. Be sure to put caps on the valve
s.
WARNING
!●
Driving with tyres that are worn, damaged or improperly inflated can lead
to a loss of control or
blow out of the tyres which can result in a collision with serious or fatal injury.Ty r e s i z e
To 5 passengers
To max. load
At trailer towing
Front
Rear
Front
Rear
Front
Rear
265/65R17 112H 265/60R18 110H
2.2 bar (220 kPa) 2.4 bar (240 kPa) 2.4 bar (240 kPa)
2.8 bar (280 kPa) 2.6 bar (260 kPa) 3.0 bar (300 kPa)
BK-BK2008E1ENUK.en-uk-Section11.fm Page
19 Wednesday, January 9, 2008 4:50 PM

Alphabetical index
7
Stop lamps Bulb capacity 8-36Replacement 8-44Storage spaces 5-92Sun visors 5-77Sunglasses holder 5-98Sunroof 1-21Super select 4WD II 4-34Supplemental restraint system 2-58How the supplemental restraint system works 2-59Servicing 2-76Warning lamp 2-75
T
Tachometer 3-2Tail lampsBulb capacity 8-36Replacement 8-44Tank capacity 3Third seat 2-16Tools 6-12Storage 6-11Towing 6-29Trailer towing 4-90Transfer oil 9-16TransmissionAutomatic transmission 4-25Manual transmission 4-23Tripmeter 3-3
Turn-signal indication lamps 3-12 Turn-signal lever 3-65Tyres 8-19How to change a tyre 6-16Inflation pressures 8-19Rotation 8-21Size (tyre and wheel) 9-13Snow tyres 8-22Tyre chains 8-23
U
Used engine oils safety instructions and disposal information 8
V
Vanity mirror 5-78Vanity mirror lampsBulb capacity 8-38Replacement 8-55Vehicle care precautions 7-2Vehicle dimensions 9-4Vehicle identification number 9-2Vehicle identification number plate 9-3Vehicle information code plate 9-2Vehicle labeling 9-2Vehicle performance 9-6Vehicle weight 9-7Ventilators 5-2
BK-BK2008E1ENUK.en-ukIX.fm Page 7 Thursday, January 10, 2008 7:53 AM