2008 MITSUBISHI SHOGUN door lock

Locking and unlocking
1-17
1
NOTE●
Repeated operation with the engine stopped will run down the battery. Operate the window switches only while the engine is running.
Driver’s switchesThe driver’s switches can be us
ed to operate a
ll door windows.
A window can be opened or closed by operating the corre- sponding switch. Press the switch down to open the window, and pull up theswitch to close it. If the switch is fully pressed down/pulled up, the door window automatically opens/closes completely.If you want to stop the window movement, operate the switch lightly.
Passenger’s switchesThe passenger’s switches can be used to operate the corre- sponding passenger’s door windows. Press the switch down for opening the window, and pull up the switch for closing.NOTE●
The rear door windows only open halfway.
Passenger’s switch
BK-BK2008E1ENUK.en-uk-Section4.fm Page
17 Wednesday, January 9, 2008 4:22 PM

1-18 Locking and unlocking
1
Lock switch
E00303100501
When this switch is operated, the passenger’s switches cannot be used to open or close the door windows. To unlock, press it once again.NOTE●
The driver’s switch always can open or close any door windows.
NOTE●
It is possible to prevent the driver’s door switches from being used to open and close the front passenger’s door window and rear door windows (5-door models) while thelock switch is pressed in the “LOCK” position. For details, we recommend you to consult a MITSU- BISHI MOTORS Authorized Service Point.
Timer function
E00302400086
The door windows can be opened or closed for 30 seconds after the ignition switch is turned off. If the driver’s door is opened during this period, the door window can be opened orclosed for another 30 seconds. However, once the driver’s door is closed, the windows cannot be operated.
1- Lock 2- Unlock
WARNING
!●
A child may tamper with the sw
itch at the risk of its
hands or head being trapped in the window. Whendriving with a child in the vehicle, please press the window lock switch to
disable the passenger’s
switches.
BK-BK2008E1ENUK.en-uk-Section4.fm Page
18 Wednesday, January 9, 2008 4:22 PM

Locking and unlocking
1-19
1
Safety mechanism
E00302500218
If a hand or head is trapped in the closing window, it will lower automatically. Nonetheless, make sure that nobody puts their head or hand out of the window when closing a window.The lowered window will become
operational after a few sec-
onds.
NOTE●
The safety mechanism can be
activated if the driving con-
ditions or other circumstances cause the door windows to be subjected to a physical shock similar to that caused by a trapped hand or head.
●
If the safety mechanism is ac
tivated three or more times in
a row, the safety mechanism will be cancelled and the door window will not close correctly.In such a case, the following
procedure should be imple-
mented to rectify this situation. If the window is open, repeatedly raise the appropri
ate window switch until that
window has been fully closed. Following this, release the switch, raise the switch once again and hold it in this con- dition for at least 1 second, then release it. You shouldnow be able to operate all windows in the normal fashion.
WARNING
!●
If the safety mechanism is activated three or more times successively, the safety mechanism will be tem- porarily cancelled.If a hand or head got trap
ped, a serious injury could
result.CAUTION
!●
The safety mechanism is cancelled just before the window is fully closed. This allows the window toclose completely. Therefore
be especially careful that
no fingers are trapped in the window.
BK-BK2008E1ENUK.en-uk-Section4.fm Page
19 Wednesday, January 9, 2008 4:22 PM

Locking and unlocking
1-21
1
Sunroof
*
E00302700832
The sunroof can only be operated with the ignition switch in the “ON” position. To open, press the switch (3). To stop the moving sunroof, press the switch (1) or (2).NOTE●
The sunroof automatically stop
s just before reaching the
fully open position. Press the switch again to fully open it.
To close, press switch (2). To stop the moving sunroof, press switch (1) or (3).
To tilt up, press switch (1). The rear sunroof raises for ventilation.NOTE●
When the sunroof is tilted up, the sunshade is automati- cally opened slightly.
To tilt down, press switch (2).Timer functionThe sunroof can be opened or closed for 30 seconds after the ignition switch is turned off. If the driver’s door is opened dur- ing this period, the sunroof can be opened or closed for another 30 seconds.However, once the driver’s door is closed, the sunroof cannot be operated.
1- Tilt up 2- Close, Tilt down3- Open
BK-BK2008E1ENUK.en-uk-Section4.fm Page
21 Wednesday, January 9, 2008 4:22 PM

1-22 Locking and unlocking
1
Lock switchWhen this switch is operated
, the sunroof switch cannot be
used to open or close the sunroof.To unlock, press it once again.NOTE●
If the sunroof switch is operated with the lock switch pressed, a buzzer sounds to
indicate the sunroof cannot be
opened or closed.
●
With the lock switch presse
d, operation of the electric
window control with switches other than the driver’s door switches is also prevented.
Safety mechanismIf a hand or head is trapped in
the closing sunroof, it will re-
open automatically.Nonetheless, make sure that nobody puts their head or hand out of the sunroof when opening or closing. The opened sunroof will become
operational after a few sec-
onds. If the safety mechanism should be activated 5 or more times consecutively, normal closing of the sunroof will be aborted. In such an event, the followi
ng steps should be taken:
1. Press switch (2) repeatedly, setting the sunroof in the tilt
up condition.
2. Once the tilt up condition
has been reached, press and
hold switch (2) for a period of at least 3 seconds.
3. Press switch (2) once again
to fully close the sunroof.
1- Lock 2- Unlock
BK-BK2008E1ENUK.en-uk-Section4.fm Page
22 Wednesday, January 9, 2008 4:22 PM

Seat and seat belts
2-11
2
To get in and out of the rear seat (3-door models, passenger’s seat)
E00401000044
The lever can be used to make getting in and out easier. Pull up the lever (A) or depress the pedal (B), tilt the seatbackforward. Then slide the entire s
eat forward. To
return the seat,
raise the seatback, then slide
the entire seat backward until
there is a “click” in a locked po
sition. Adjust the seat position.
WARNING
!●
Do not drive the vehicle
with the seatback folded
forward. The seat is not retained with the seatbackin this position, so seriou
s injuries could be suffered
in the event of hard
braking or a collision.
CAUTION
!●
The reclining mech
anism of the seatback is spring
loaded, causing it to return
to the vertical position
when the lock lever is
operated. When using the
lever, sit close to the seatback or hold it with your hand to control its return motion.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
11 Wednesday, January 9, 2008 4:28 PM

Seat and seat belts
2-13
2
Rear seats (3-door models)*/ Second seats (5-door models)*
E00402000184
To recline the seatback
E00402200157
In order to recline the seatback
, lean forward slightly, pull the
seatback lock lever up, and then
lean backward to the desired
position and release the lever.
The seatback will lock in that
position.
WARNING
!●
When a person is sitting in
the middle seating posi-
tion of the rear seats (3-door models)/second seats (5-door models), pull up the head restraint to a height at which it locks in
position. Be sure to make
this adjustment before starting to drive. Serious injuries could otherwise be
suffered as the result of
an impact. Refer to “Head restraints” on page 2-16.
3-door models 5-door models
BK-BK2008E1ENUK.en-uk-Section5.fm Page
13 Wednesday, January 9, 2008 4:28 PM

2-14 Seat and seat belts
2
NOTE●
Each seatback can be adjusted by the lever on its side.
●
On 5-door models, each of the
second seat’s sidebacks (A)
is foldable. When either side
of the seatback is reclined to
a new position, its sideback automatically folds inward accordingly.
Armrest
E00402400218
For rear seats (3-door models)Press the button (A) at the top
of the armrest and allow the
armrest to drop down.
CAUTION
!●
The reclining mechanism of
the seatback is spring
loaded, causing it to return
to the vertical position
when the lock lever is
operated. When using the
lever, sit close to the seat
back or hold it with your
hand to control its return motion.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
14 Wednesday, January 9, 2008 4:28 PM