2008 MITSUBISHI SHOGUN sensor

Overview
Outside (Front)
E00100502434
Front fog lamps* p. 3-66, 8-36, 8-42
Engine compartment p. 9-16 Bonnet p. 8-3
Windscreen wiper and washer p. 3-68
Headlamps p. 3-58, 8-36, 8-38
Electric window control p. 1-16
Outside rear-view mirrors p. 4-11 Approach lamps* p. 1-12
Sunroof* p. 1-21
Front turn-signal lamps p. 3-65, 8-36, 8-41
Side turn-signal lamps* p. 3-65
Position lamps p. 3-58, 8-36, 8-41
Locking and unlocking p. 1-7 Keyless entry system* p. 1-5
Rear side/quarter window p. 1-20 Antenna p. 5-77
Headlamp washer* p. 3-76
Rain sensor* p. 3-71
BK-BK2008E1ENUK.en-uk-Section2.fm Page 8 Wednesday, January 9, 2008 4:26 PM

Overview
Outside (Rear)
E00100502564
Rear turn-signal lamps* p. 3-65, 8-36, 8-44
Fuel tank filler p. 3
Reversing lamps p. 8-36, 8-44
Licence plate lamps p. 3-58, 8-36, 8-49
Spare wheel p. 6-17
Backdoor p. 1-13
High-mounted stop lamp p. 8-36, 8-48
Rear window wiper and washer p. 3-75
Tyre inflation pressure p. 8-19 Changing tyres p. 6-16 Tyre rotation p. 8-21Tyre chains p. 8-23
Rear fog lamp p. 3-67, 8-36, 8-47
Stop and tail lamps* p. 3-58, 8-36, 8-44 Stop lamps* p. 8-36, 8-44
Spare wheel garnish p. 6-18
Tail lamps* p. 3-58, 8-36, 8-44
3-door models 5-door models Rear turn-signal lamps* p. 3-65, 8-36, 8-44
Rear turn-signal lamps*
p. 3-65, 8-36, 8-44
Stop and tail lamps* p. 3-58, 8-36, 8-44 Stop lamps* p. 8-36, 8-44
Reversing lamps p. 8-36, 8-44
Rear-view camera* p. 4-84
Corner and back sensor* p. 4-78
BK-BK2008E1ENUK.en-uk-Section2.fm Page 9 Wednesday, January 9, 2008 4:26 PM

2-58 Seat and seat belts
2
Seat belt inspection
E00406300475
●
Check the belts for cuts, worn
or frayed webbing and for
cracked or deformed metallic parts. Replace the belt assembly if it is defective.
●
A dirty belt should be cleaned with neutral detergent in warm water. After rinsing in water, let it dry in the shade. Do not attempt to bleach or
re-dye the belts because this
will affect their characteristics.
Supplemental restra
int system (SRS) -
airbag
E00407201407
The information written in this supplemental restraint system (SRS) section contains important points concerning the driver, front passenger, side and curtain airbags.The SRS driver and front passe
nger airbags are designed to
supplement the primary protection of the driver and front pas- senger side seat belt systems by providing those occupantswith protection against head and
chest injuries in certain mod-
erate-to-severe frontal collisions. The SRS driver and front passenger airbags employ a dualstage airbag system. The SRS
driver and front passenger air-
bags are controlled by the imp
act sensors (at the front of the
vehicle) and the control unit (n
ear the centre of
the vehicle at
floor level). The SRS side airbag (if so equipped) is designed to supplement properly worn seat belts and provide the driver and front pas-senger with protection against ches
t injury in certain moderate-
to-severe side impact collisions. The SRS curtain airbags (if so
equipped) are designed to sup-
plement properly worn seat belts and provide the driver andpassenger with protection against head injuries in certain mod- erate-to-severe side
impact collisions.
The SRS is NOT a substitute for the seat belts; for maximum protection in all types of cras
hes and accidents, seat belts
should ALWAYS be worn by everyone who drives or rides in this vehicle.
WARNING
!●
We recommend you have al
l seat belt assemblies
including retractors and attaching hardware inspected after any collision. We recommend that seat belt assemblies in use during a collision bereplaced unless the collis
ion was minor and the belts
show no damage and contin
ue to operate properly.
●
Do not attempt to repair or replace any part of the seat belt assemblies; we recommend you have this work done by a MITSUB
ISHI MOTORS Author-
ised Service Point. Incorrect repair or replacementcould reduce the effectivene
ss of the belts and could
result in serious injury in
the event of a collision.
●
Once the pre-tensioner has b
een activated, it cannot
be re-used. It must be replaced together with the retractor.
BK-BK2008E1ENUK.en-uk-Section5.fm Page
58 Wednesday, January 9, 2008 4:28 PM

Instruments and controls
3-59
3
Type 2Rotate the switch to turn on the lamps.
NOTE●
The sensitivity of the automatic on/off control can be adjusted. For further information, we recommend you to consult a MITSUBISHI MOTORS Auth
orized Service Point.
●
When the headlamps are turned off by the automatic on/off control with the ignition switch in the “ON” posi- tion, the front fog lamps (if so equipped) and rear foglamps also go off. When the headlamps are subsequently turned back on by the automatic on/off control, the front fog lamps also come on but the rear fog lamps stay off. Ifyou wish to turn the rear fo
g lamps back on, operate the
switch again.
●
Do not cover the sensor (A) for the automatic on/off con- trol by affixing a sticker or label to the windscreen.
OFF All lamps off AUTO
With the ignition switch in the “ON” position, head- lamps, position, tail, licence plate, and instrument panel lamps turn on and off automatically in accord-ance with outside light level. All lamps turn off auto-matically when the ignition switch is turned to the “OFF” position. Position, tail, licence plate and instrument panel lamps on Headlamps and other lamps go on
BK-BK2008E1ENUK.en-uk-Section6.fm Page
59 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-69
3
Windscreen wipers
E00516900068
Except for vehicle with rain sensorThe windscreen wipers can be operated with the ignition switch in the “ON” or “ACC” position. If the blades are frozen to th
e windscreen or rear window, do
not operate the wipers until th
e ice has melted and the blades
are freed, otherwise the wiper motor may be damaged.
To adjust intermittent intervalsWith the lever in the “INT” (speed-sensitive) position, the intermittent intervals can be adjusted by turning knob (A).NOTE●
The speed-sensitive-operation function of the windscreen wipers can be deactivated. For furher information, we recommend you to consult a MITSUBISHI MOTORS Auth
orized Service Point.
MIST- Misting function
The wipers will operate once.
OFF- OffINT- Intermittent (Speed sensitive) LO- Slow HI- Fast
1- Fast2- Slow
BK-BK2008E1ENUK.en-uk-Section6.fm Page
69 Wednesday, January 9, 2008 4:32 PM

3-70 Instruments and controls
3
Misting functionThe misting function can be used when the ignition switch is in the “ON” or “ACC” position. The wipers will operate once if th
e wiper lever is raised to the
“MIST” position and released. Th
is operation is useful when it
is drizzling, etc. The wipers will continue to operate while the lever is held in the “MIST” position.
Vehicle with rain sensor
E00526400011
The windscreen wipers can be operated with the ignitionswitch in the “ON” or “ACC” position. If the blades are frozen to th
e windscreen or rear window, do
not operate the wipers until the
ice has melted and the blades
are freed, otherwise the wiper motor may be damaged.MIST- Misting function
The wipers will operate once.
OFF- OffAUTO- Auto-wiper control
Rain sensor The wipers will automatically operate depending on the degree of wetness on the windshield.
LO- Slow HI- Fast
BK-BK2008E1ENUK.en-uk-Section6.fm Page
70 Wednesday, January 9, 2008 4:32 PM

Instruments and controls
3-71
3
Rain sensor
E00517000066
Can only be used when the ignition switch is in the “ON” posi- tion. If the lever is put in the “AUTO” position, the rain sensor (A)will detect the extent of rain (or snow, other moisture, dust, etc.) and the wipers will
operate automatically.
CAUTION
!●
With the ignition switch in the “ON” position and the lever in the “AUTO”
position, the wipers may
automatically operate in the situations described below. If your hands get trapped, you could suffer injuriesor the wipers could malfunct
ion. Be sure to turn the
ignition switch to the “OFF” position or move the lever to the “OFF” position
to deactivate the rain
sensor.• When cleaning the outs
ide surface of the wind-
screen, if you touch the rain sensor. • When cleaning the outs
ide surface of the wind-
screen, if you wipe with a cloth the rain sensor.• When using an automatic car wash. • A physical shock is applied to the windscreen. • A physical shock is applied to the rain sensor.
BK-BK2008E1ENUK.en-uk-Section6.fm Page
71 Wednesday, January 9, 2008 4:32 PM

3-72 Instruments and controls
3
NOTE●
To protect the rubber parts of
the wipers, this operation of
the wipers does not take place
when the vehicle is station-
ary and the ambient temperature is about 0 °C or lower.
●
Do not cover the sensor by affixing a sticker or label to the windscreen. Also, do not put any water-repellent coating on the windscreen. The rain
sensor would not be able to
detect the extent of rain, and the wipers might stop work-ing normally.
●
In the following cases, the rain sensor may be malfunc- tioning.Have the vehicle inspected by a MITSUBISHI MOTORS Authorized Service Point. • When the wipers operate at
a constant interval despite
changes in the extent of rain. • When the wipers do not operate even though it is rain- ing.
●
The wipers may automatically
operate when things such
as rain, dust, mud, insects, tr
ee sap, oil or salt are affixed
to the windscreen on top of the rain sensor or when thewindscreen is frozen. (Wrong operation may also occur due to strong electromagnetic
waves, etc.) Objects affixed
to the windscreen wi
ll stop the wipers when the wipers
cannot remove them. To make the wipers operate
again, place the lever in the
“LO” or “HI” position.
●
Contact a MITSUBISHI MOTORS Authorized Service Point when replacing the winds
creen or reinforcing the
glass around the sensor.
To adjust the sensitivity of the rain sensor
E00517100038
With the lever in the “AUTO” (rain sensor) position, it is possi- ble to adjust the sensitivity of the rain sensor by turning knob (A).NOTE●
It is possible to activate the following functions. For fur- ther information, we reco
mmend you to consult a MIT-
SUBISHI MOTORS Authorized Service Point. • Automatic operation (rain droplet sensitive) can be changed to intermittent ope
ration (vehicle-speed sensi-
tive). • Automatic operation (rain droplet sensitive) can be changed to intermittent oper
ation (except vehicle-speed
sensitive).
“+”- Higher sensitivity to rain “-”- Lower sensitivity to rain
BK-BK2008E1ENUK.en-uk-Section6.fm Page
72 Wednesday, January 9, 2008 4:32 PM