2008 MITSUBISHI GRANDIS instrument cluster

3-26 Instruments and controls
3
NOTE●If the driving range drops below 50 km (30 miles) while
the driving range is displayed, the display shows “---”.
When this occurs, top up the fuel tank as soon as possible.
●The driving range varies depending on road conditions,
the manner of driving and other related factors. Conse-
quently, the display should be used only as a guide. It is
recommended to add fuel as soon as the low fuel warning
lamp in the instrument cluster illuminates.
(Refer to “Low fuel warning lamp” on page 3-6.)
●Refueling will update the driving range indication.
●The driving range displayed is based on previous fuel con-
sumption data. Disconnecting the battery cable will result
in the deletion of existing fuel consumption data, which
will affect the unit’s calculations.
●The driving range figure can occasionally increase if the
vehicle is stopped on an incline. This is because the fuel
has moved in the tank because of the incline and is not
considered as a fault.
Average speed
E00509500062
This value shows the average speed (in km/h or mph) since the
display was reset. Refer to “To reset the display” on page 3-23.
BK-XP08E1ENUK.en-uk.book Page 26 Monday, August 13, 2007 2:20 PM

3-34 Instruments and controls
3
Dipper (High/Low beam change)
E00506200114
When the lamp switch is in the “ ” position, the beam
changes from high to low (or low to high) each time the lever is
pulled to (1). While the high beam is on, the high beam indica-
tor lamp in the instrument cluster will also illuminate.
Headlamp flasher
E00506300027
The high beams flash when the lever is pulled slightly to (2),
and will go off when it is released.
When the high beam is on, the high beam indicator lamp in the
instrument cluster will also illuminate.NOTE●The high beams can also flash when the lamp switch is
OFF.
●If you turn the lamps off with the headlamps set to high-
beam illumination, the headlamps are automatically
returned to their low-beam setting when the lamp switch
is next turned to the “ ” position.
BK-XP08E1ENUK.en-uk.book Page 34 Monday, August 13, 2007 2:20 PM

3-38 Instruments and controls
3
NOTE●If the lamp flashes unusually quickly, the bulb in a turn-
signal lamp may have burned out. We recommend you to
have the vehicle inspected.
●It is possible to activate the following functions. For fur-
ther information, we recommend you to consult a MIT-
SUBISHI MOTORS Authorized Service Point.
On a vehicle equipped with a Multi Display Station
(MDS), the functions can be adjusted on the screen. For
details, refer to a separate operation manual.
• Sounding of a buzzer as the turn-signal lamps flash
• Flashing of the turn-signal lamps and the indication
lamp in the meter when the lever is operated with the
ignition switch in the “ACC” position
Hazard warning flasher switch
E00506600567
Use the hazard warning flasher switch when the vehicle has to
be parked on the road for any emergency.
The hazard warning flashers can always be operated, regard-
less of the position of the ignition key.
Push the switch to turn on the hazard warning flashers; push
the switch again to turn them off.
When this switch is operated, all turn-signal lamps flash con-
tinuously, as do the turn-signal indication lamps in the instru-
ment cluster.
BK-XP08E1ENUK.en-uk.book Page 38 Monday, August 13, 2007 2:20 PM

Instruments and controls
3-39
3
NOTE●If the lamps are kept flashing for a long time, the battery
will be discharged, resulting in hard engine starting or no
start condition.
●It is possible to cause a buzzer to sound in time with flash-
ing of the turn-signal lamps. For further information, we
recommend you to consult a MITSUBISHI MOTORS
Authorized Service Point.
On a vehicle equipped with a Multi Display Station
(MDS), the functions can be adjusted on the screen. For
details, refer to a separate operation manual.
Fog lamp switch
E00506700018
Front fog lamp switch
E00508300050
The front fog lamps can be operated when the headlamps or
tail lamps are turned on. Push the switch to turn on the front
fog lamps, push the switch again to turn them off.
The indicator lamp in the instrument cluster will illuminate
while the front fog lamps are on.NOTE●The front fog lamps are automatically turned off when the
headlamps and tail lamps turn off. To turn on the front fog
lamps again, push the switch again when the headlamps or
tail lamps are turned on.
BK-XP08E1ENUK.en-uk.book Page 39 Monday, August 13, 2007 2:20 PM

3-40 Instruments and controls
3
●In case of vehicles with Daytime Running Lamp, the front
fog lamps can be operated even if the lamp switch is set to
the “OFF” position, because the low beam of the head-
lamps, tail lamps, etc. illuminate when the ignition key is
at the “ON” position.Rear fog lamp switch
E00508400237
The rear fog lamp can be operated when the headlamps or front
fog lamps are on. Push the switch to turn on the rear fog lamp,
and push the switch again to turn it off.
The indication lamp in the instrument cluster will illuminate
while the rear fog lamp is on.
NOTE●The rear fog lamp is automatically turned off when the
headlamps and front fog lamps are turned off. To turn on
the rear fog lamp again, push the switch again when the
headlamps or front fog lamps are on.
●In case of vehicles with Daytime Running Lamp, the rear
fog lamp can be operated even if the lamp switch is set to
the “OFF” position, because the low beam of the head-
lamps, tail lamps, etc. illuminate when the ignition key is
at the “ON” position.
BK-XP08E1ENUK.en-uk.book Page 40 Monday, August 13, 2007 2:20 PM