2008 MITSUBISHI GRANDIS jump start

4-28 Starting and driving
4
NOTE●To avoid erroneous operation, move the selector lever
firmly into each position and briefly hold it there. Always
check the position shown by the selector lever position
indicator lamp after moving the selector lever.
●If the brake pedal is not depressed and held, the shift-lock
device activates to prevent the selector lever from being
moved from the “P” (PARK) position.
●For a shift indicated by in the illustration, depress the
brake pedal before moving the selector lever. If you
attempt to move the selector lever before depressing the
brake pedal, the selector lever may become immovable.
Selector lever position indication lamps/“N” indi-
cation lamp
E00603500452
WARNING
!●Always depress the brake pedal when shifting the
selector lever into a gear from the “P” (PARK) or
“N” (NEUTRAL) position.
When beginning to drive, do not shift the selector
lever from the “P” (PARK) or “N” (NEUTRAL)
position while depressing the accelerator pedal,
doing so is dangerous because the vehicle will
“jump” forward or backward.
A- Selector lever position indication lamps
When the ignition switch is turned to the “ON” position, the
indication lamps in the instrument panel come on to show
the position of the selector lever (i.e. “PARK”, “DRIVE”,
“REVERSE”, etc.).
B- “N” indication lamp
When the “N” indication lamp blinks with the “D” (DRIVE)
position or “Sports mode” selected, the A/T may be mal-
functioning.
BK-XP08E1ENUK.en-uk.book Page 28 Monday, August 13, 2007 2:20 PM

6-2 For emergencies
6If the vehicle breaks down
E00800100606
If the vehicle breaks down on the road, move it to the shoulder
and use the hazard warning flashers.
Refer to “Hazard warning flasher switch” on page 3-38.If the engine stops/failsVehicle operation and control are affected if the engine stops.
Before moving the vehicle to a safe area be aware of the fol-
lowing:
●The brake booster becomes inoperative and the pedal
effort will increase. Press down the brake pedal harder
than usual.
●Since the power steering pump is no longer operative, the
steering wheel feels heavy when turning it. Turn the wheel
with more effort than usual.
Emergency starting
E00800501216
If the engine cannot be started because the battery is weak or
dead, the battery from another vehicle can be used with jumper
cables to start the engine.
1. Get the vehicles close enough so the jumper cables can
reach, but be sure the vehicles aren’t touching each other.
If they are, it could cause a ground connection you don’t
want. The vehicle will not start, and the bad grounding
could damage the electrical systems.
WARNING
!●To start the engine by use of jumper cables from
another vehicle, perform the correct procedures
according to the instruction manual. Incorrect pro-
cedures could result in a fire or explosion or damage
to the vehicles.
CAUTION
!●Check the other vehicle. It must have a 12-volt bat-
tery.
If the other system isn’t 12-volt, shorting can dam-
age both vehicles.
BK-XP08E1ENUK.en-uk.book Page 2 Monday, August 13, 2007 2:20 PM

For emergencies
6-3
6
2. You could be injured if the vehicles move. Set the parking
brake firmly on each vehicle. Put an automatic transmis-
sion in “P” (PARK) or a manual transmission in “N”
(Neutral). Turn off the ignition switch.NOTE●Turn off all lamps, heater and other electrical loads. This
will avoid sparks and help save both batteries.
3. Make sure battery electrolyte is at the proper level.
Refer to “Battery” on page 8-16.4. Connect the booster battery.
Petrol-powered vehicles
Connect one end of one jumper cable to the positive (+)
terminal of the discharged battery (A), and the other end
to the positive (+) terminal of the booster battery (B).
WARNING
!●Turn off the ignition on both vehicles beforehand.
Use care to make sure that the cables or your clothes
are never caught by the fan or drive belt. Personal
injury could result.
WARNING
!●If electrolyte fluid is not visible, or appears to be fro-
zen, Do Not Attempt Jump Starting!
A battery might rupture or explode if the tempera-
ture is below the freezing point or if it is not filled to
the proper level.
BK-XP08E1ENUK.en-uk.book Page 3 Monday, August 13, 2007 2:20 PM

Alphabetical index
4High-beam indication lamp 3-9
Hinges and latches lubrication 8-32
Horn switch 3-46
I
If the vehicle breaks down 6-2
Ignition switch 4-14
Indicator and warning lamps 3-8
Indicator lamps 3-9
Inside rear-view mirror 4-9
Inside tailgate release 1-15
Installation of accessories 5
Instrument panel upper box 5-65
Instruments 3-2
Interior lamp switch 5-59
Interior lamps 5-58
J
Jack 6-11
Storage 6-10
Jacking up the vehicle 6-13
Jump starting (Emergency starting) 6-2
K
Keyless entry system 1-5
Keys 1-2
L
Labeling 9-2Lamp monitor buzzer 3-33
Lamps (headlamps, fog lamp, etc.) auto-cutout function 3-33
Leakage (Fuel, engine coolant, oil and exhaust gas) 8-31
Licence plate lamps
Bulb capacity 8-44
Replacement 8-55
Low fuel warning lamp 3-6
Lubricants 9-16
Luggage compartment lamp 5-62
Bulb capacity 8-45
Replacement 8-59
Luggage floor box 5-67
Luggage hooks 5-77
LW/MW/FM electronic tuning radio with CD player 5-21
M
Making a flat seat 2-25
Manual transmission 4-23
Oil 9-16
Mirror
Inside rear-view mirror 4-9
Outside rear-view mirrors 4-10
MIVEC engine 4-20
Modification/alterations to the electrical or fuel systems 6
Multi centre display 3-15
N
Notes regarding diesel fuel 9-15
BK-XP08E1ENUK.en-uk.book Page 4 Monday, August 13, 2007 2:20 PM