Page 189 of 458
Starting and driving
4-17
4 Steering wheel lock
E00601500083
To l o c kRemove the key at the “LOCK” position.
Turn the steering wheel until it is locked.To u n l o c kTurn the key to the “ACC” position while moving the steering
wheel slightly.
NOTE●If the front wheels are turned, the anti-theft lock may
sometimes make it difficult to turn the key from “LOCK”
to “ACC”. Firmly turn the steering wheel to the left or to
the right as you turn the key.
CAUTION
!●Remove the key when leaving the vehicle.
BK-XP08E1ENUK.en-uk.book Page 17 Monday, August 13, 2007 2:20 PM
Page 208 of 458

4-36 Starting and driving
4
When driving downhillIt is important to take advantage of the engine braking by shift-
ing to a lower shift position while driving on steep downhill
roads in order to prevent the brakes from overheating.Brake pads●With new brake pads, avoid where possible sudden full
application of the brakes for the first 200 km (124 miles)
of driving.
●The disc brakes are provided with a warning device which
emits a shrieking metallic sound while braking if the
brake pads have reached their limit.
If you hear this sound, have the brake pads replaced.
Anti-lock brake system (ABS)
E00607100560
Environmental conditions can have an effect on braking. Dur-
ing sudden braking when there is snow, ice, oil, water etc. on
the road surface, a skid may occur. In this situation, steering
control and braking effectiveness is reduced and the stopping
distance is increased. The vehicle may also go into an uncon-
trolled spin.
The ABS helps prevent the wheels from locking during brak-
ing, thus maintaining directional stability, ensuring controlla-
bility and providing optimum braking force.Driving hints●With ABS fitted, steering during sudden braking (when
the ABS functions) differs slightly from when the brakes
are not being applied.
Steer the vehicle carefully in these conditions.
●Always maintain the same distance from the vehicle in
front of you as you would for a vehicle not equipped with
ABS.
Compared with vehicles not fitted with ABS, your vehicle
may require a longer stopping distance in the following
cases:
• Driving on gravel or snow-covered roads.
• Driving with tyre chains installed.
• Driving on roads where the road surface is pitted or has
other differences in surface height.
• Driving on bumpy roads or other poor driving surfaces.
WARNING
!●Do not leave any objects near the brake pedal or let
a floor mat slide under it; doing so could prevent the
full pedal stroke that would be necessary in an emer-
gency. Make sure that the pedal can be operated
freely at all times. Make sure the floor mat is
securely held in place.
WARNING
!●Driving with worn brake pads will make it harder to
stop, and can cause an accident.
BK-XP08E1ENUK.en-uk.book Page 36 Monday, August 13, 2007 2:20 PM
Page 212 of 458
4-40 Starting and driving
4
●The ABS becomes operative after the vehicle has acceler-
ated to a speed in excess of approximately 10 km/h
(6 mph). It stops operating when the vehicle decelerates to
a speed below approximately 5 km/h (3 mph).
Power steering system
E00607400127
When the engine is stopped, the power steering system will not
function and it will require greater manual effort to operate the
steering wheel. Keep this in mind in particular when towing the
vehicle. Never turn off the engine while driving.
Periodically check the power steering fluid level.
CAUTION
!●Do not hold the steering wheel in the fully turned
position (either left or right), for longer than 10 sec-
onds.
This can cause damage to the power steering system.
BK-XP08E1ENUK.en-uk.book Page 40 Monday, August 13, 2007 2:20 PM
Page 214 of 458

4-42 Starting and driving
4
Traction control function
E00611800050
On slippery surfaces, the traction control function prevents the
drive wheels from excessive spinning, thus helping the vehicle
to start moving from a stop. It also provides sufficient driving
force and steering performance as the vehicle turns at acceler-
ated speeds.NOTE●When moving out of mud, sand or fresh snow, pressing
the accelerator pedal may not allow the engine speed to
increase.
If this happens and the vehicle remains stuck as a result,
turn the TCL switch OFF. The vehicle will then be easier
to extricate.
●When climbing or beginning to climb a steep slope, turn
the TCL switch OFF if the traction control function
reduces the engine speed excessively.
TCL switch
E00611900048
The traction control function automatically goes on, when the
ignition switch is turned to the “ON” position. To deactivate
the traction control function, press the TCL switch. To reacti-
vate the traction control function, press the TCL switch again.
MITSUBISHI MOTORS recommends to normally keep the
traction control function on.
CAUTION
!●When driving a vehicle on a snowy or icy road, be
sure to install snow tyres and drive the vehicle at
moderate speeds.●When a tyre such as a compact spare tyre, which is
different in size from the standard tyre, has been
installed, make sure that the traction control func-
tion is turned off.
BK-XP08E1ENUK.en-uk.book Page 42 Monday, August 13, 2007 2:20 PM
Page 229 of 458
Starting and driving
4-57
4
SONAR OFF indication lamp
E00615900033
In case there is a malfunction in the corner sensor system, the
SONAR OFF indication lamp will flash and the warning
buzzer will sound for approximately 5 seconds. Even after the
buzzer has stopped sounding, the indication lamp will continue
flashing until the system reverts to the normal state. We recom-
mend you to have your vehicle inspected.
Cargo loads
E00609900634
Cargo loads precautions
CAUTION
!●Do not load cargo or luggage higher than the top of
the seatback. Be sure that your cargo or luggage
cannot move once your vehicle is moving.
Having either the rear view blocked, or your cargo
being thrown inside the cabin if you suddenly have
to brake can cause a serious accident or injury.●Load heavy cargo or luggage in the front of the vehi-
cle. If the load in the back of the vehicle is too heavy,
steering may become unstable.
BK-XP08E1ENUK.en-uk.book Page 57 Monday, August 13, 2007 2:20 PM
Page 314 of 458

6-2 For emergencies
6If the vehicle breaks down
E00800100606
If the vehicle breaks down on the road, move it to the shoulder
and use the hazard warning flashers.
Refer to “Hazard warning flasher switch” on page 3-38.If the engine stops/failsVehicle operation and control are affected if the engine stops.
Before moving the vehicle to a safe area be aware of the fol-
lowing:
●The brake booster becomes inoperative and the pedal
effort will increase. Press down the brake pedal harder
than usual.
●Since the power steering pump is no longer operative, the
steering wheel feels heavy when turning it. Turn the wheel
with more effort than usual.
Emergency starting
E00800501216
If the engine cannot be started because the battery is weak or
dead, the battery from another vehicle can be used with jumper
cables to start the engine.
1. Get the vehicles close enough so the jumper cables can
reach, but be sure the vehicles aren’t touching each other.
If they are, it could cause a ground connection you don’t
want. The vehicle will not start, and the bad grounding
could damage the electrical systems.
WARNING
!●To start the engine by use of jumper cables from
another vehicle, perform the correct procedures
according to the instruction manual. Incorrect pro-
cedures could result in a fire or explosion or damage
to the vehicles.
CAUTION
!●Check the other vehicle. It must have a 12-volt bat-
tery.
If the other system isn’t 12-volt, shorting can dam-
age both vehicles.
BK-XP08E1ENUK.en-uk.book Page 2 Monday, August 13, 2007 2:20 PM
Page 328 of 458

6-16 For emergencies
6Spare wheel
E00801101176
Check the air pressure of the spare tyre frequently and make
sure it is ready for emergency use at any time.
Maintaining the spare wheel at the highest specified air pres-
sure will ensure that it can always be used under any conditions
(city/high-speed driving, varying load weight, etc.).
The spare wheel is stored under the rear of the body.Compact spare wheelThe compact spare tyre is designed to save space in the lug-
gage compartment and its lighter weight makes it easier to use
if a flat tyre occurs.
CAUTION
!●The pressure should be periodically checked and
maintained at the specified pressure while the tyre is
stowed.
Driving with an insufficient tyre pressure can lead to
an accident. If you have no choice but to drive with
an insufficient tyre pressure, keep your speed down
and inflate the tyre to the correct pressure as soon as
possible. (Refer to “Tyre inflation pressures” on
page 8-21.)●The compact spare wheel is for temporary use only
and should be removed as soon as the original wheel
can be repaired or replaced.●The vehicle must not be driven at speeds in excess of
80 km/h (50 mph) while using the compact spare
wheel.
●The compact spare tyre is not as good as a standard
tyre in controllability and stability. When the com-
pact spare tyre is used, avoid quick starts, sudden
braking and sharp steering.●Avoid driving through automatic vehicle washers
and over obstacles that could possibly damage the
vehicle’s undercarriage. Because the compact spare
wheel is smaller than the original wheel, the ground
clearance is slightly reduced.●The compact spare wheel is specifically designed for
your vehicle and it should not be used on any other
vehicle.
CAUTION
!
BK-XP08E1ENUK.en-uk.book Page 16 Monday, August 13, 2007 2:20 PM
Page 338 of 458

6-26 For emergencies
6
15. Check your tyre inflation pressure. The correct pressures
are shown on the door label. See the illustration.
Wheel covers*
E00801300041
To remove1. Wrap the tip of the bar with a cloth, insert it deeply into
the notch provided in the wheel cover, and use it to lever
up the cover a little.
CAUTION
!●The tyre pressure should be periodically checked
and maintained at the specified pressure while the
tyre is stowed.●The compact spare tyre is to be used only temporar-
ily when the standard tyre is damaged. Repair the
damaged tyre as soon as possible and use it to
replace the compact spare tyre.●After changing the tyre and driving the vehicle
about 1,000 km (620 miles), retighten the wheel nuts
to make sure that they have not come loose.●If the steering wheel vibrates when driving after
changing the tyre, we recommend you to have the
tyres checked for balance.
●Do not mix one type of tyre with another or use a
different size from the one listed. This would cause
early wear and poor handling.
CAUTION
!
BK-XP08E1ENUK.en-uk.book Page 26 Monday, August 13, 2007 2:20 PM