2008 Lancia Musa engine

129
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
>
EBD FAILURE
(red)
(amber)
Simultaneous turning on of the warn-
ing lightsxand>the engine is
running indicates an EBD system fail-
ure or non-availability of the system.
Early locking of the rear wheels may
occur in the event of violent braking
causing the car to swerve. Drive very
carefully to a Lancia Dealership to
have the system inspected.
The display will show the dedicated
message.
x
INJECTION SYSTEM
FAILURE (Multijet
versions - amber)
EOBD ENGINE
CONTROL
SYSTEM FAILURE
(petrol versions - amber)
Injection system failure
When the ignition key is moved to
MAR, the warning light turns on and
should go out as soon as the engine is
started.If the warning light stays on or turns
on during car travel, it indicates that
the injection system is not operating
correctly, which could cause reduced
performance, poor drivability and
high consumption levels.
The display will show the dedicated
message.
In these conditions, the car can con-
tinue travelling at moderate speed
without demanding excessive effort
from the engine. In any case, go to a
Lancia Dealership as soon as possible.
EOBD engine control system
failure
Under normal conditions, when the
ignition key is moved to MAR, the
warning light turns on and should go
off after engine start-up. This indi-
cates that the warning light is work-
ing correctly. If the warning light ei-
ther stays on or comes on during car
travel:
❒steady light: indicates a fault in the
supply/ignition system which could
cause high emissions at the ex-
haust, possible reduced perfor-
mances, poor drivability and high
consumption levels. U
The display will show the dedicated
message.
In these conditions, the car can con-
tinue travelling at moderate speed
without demanding excessive effort
from the engine. Prolonged use of the
car with the warning light on may
cause damage. Go to a Lancia Deal-
ership as soon as possible. The warn-
ing light goes out after the fault is
cleared, and the indication is stored in
the system.
❒flashing light: indicates the possi-
bility of damage to the catalyser
(see “EOBD system” in section
“Dashboard and controls”).
If the warning light flashes, release the
accelerator pedal to lower the speed
of the engine until the warning light
stops flashing; continue the journey at
moderate speed, trying to avoid dri-
ving conditions that may cause fur-
ther flashing. Finally, contact Lancia
Dealership as soon as possible.
125-134 MUSA 3ed GB 12-11-2007 11:38 Pagina 129

131
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
GLOW PLUG HEATING
(Multijet versions -
amber)
GLOW PLUG HEATING
FAILURE
(Multijet versions - amber)
Glow plug heating
The warning light goes on when the
key is turned to MAR. It goes out as
soon as the glow plugs have reached
the preset temperature. Start the en-
gine as soon as the warning light goes
out.
IMPORTANT At high ambient tem-
peratures the warning light stays on
for an extremely short time.
Glow plug heating failure
The warning light flashes in the event
of a failure in the glow plug heating
system. Go to a Lancia Dealership as
soon as possible.
The display will show the dedicated
message.
m
WATER IN DIESEL
FUEL FILTER (Multijet
versions - amber)
When the ignition key is
moved to MAR, the warning light
turns on and should go off after a few
seconds.
The warning lightcturns on when
there is water in the diesel fuel filter.
The display will show the dedicated
message.
c
The presence of water in the
supply circuit may cause
severe damage to the injec-
tion system and irregular
engine operation. If the warning
lightcgoes on (with the message on
the display on some versions), go to
a Lancia Dealership as soon as pos-
sible to remove clogging from the
system. Whenever the warning light
comes on immediately after refu-
elling, water may have been intro-
duced in the tank. In this case, stop
the engine immediately and contact
a Lancia Dealership.
CAR PROTECTION
SYSTEM FAULT -
LANCIA CODE (amber)
Turning the key to MAR, the
warning light flashes once and then
goes off.
If the warning light stays on with the
ignition key positioned on MAR, a
failure may have occurred (see “Lan-
cia Code system” in section “Dash-
board and controls”).
IMPORTANT Simultaneous turning
on of the warning lights Uand
Yindicates a failure in the Lancia
CODE system.
If the warning light
Yflashes with
the engine running, the car is not pro-
tected by the engine inhibitor device
(see “Lancia Code system” in section
“Dashboard and controls”).
Contact Lancia Dealership to have all
the keys stored.
Y
REAR FOG LIGHTS
(amber)
The warning light comes on
when the fog lights are turned
on.
4
125-134 MUSA 3ed GB 12-11-2007 11:38 Pagina 131

132
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
GENERAL FAILURE
INDICATION
(amber)
The warning light turns on in
the following circumstances.
Externallight failure
The warning light comes on (on some
versions only) when a failure is de-
tected in one of the following lights:
– tail lights
– stop lights (excluding 3
rdstop)
– rear fog lights
– direction indicators
– plate lights.
The fault identified in the lights above
may be due to: one or more burnt
lamps, a blown protection fuse or in-
terruption of the electrical connection.
The display will show the dedicated
message.
è
Fresh air filter clogged
(where provided)
The warning light turns on when the
particulate filter is clogged and the
driving conditions do not enable au-
tomatic activation of the regeneration
procedure.
To allow the regeneration procedure,
keep the car running until the warn-
ing light turns off.
The display will show the dedicated
message.
Engine oil pressure sensor
failure
The warning light turns on when a
failure is detected in the engine oil
pressure sensor. Go to a Lancia Deal-
ership as soon as possible.Twilight/rain sensor failure
The warning light turns on when a
failure is detected in the twilight/rain
sensors. Go to a Lancia Dealership as
soon as possible.
The display will show the dedicated
message.
Fuel cut-off switch tripped
The warning light comes on when the
fuel cut-off switch trips.
The display will show the dedicated
message.
Speed limit exceeded
The display shows the dedicated mes-
sage when the car exceeds the set
speed limit (see “Multifunction Dis-
play” in section “Dashboard and con-
trols”).
125-134 MUSA 3ed GB 12-11-2007 11:38 Pagina 132

135
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
IN AN EMERGENCY
OPENING/CLOSING OF DOORS...................... 136
ENGINE STARTING .......................................... 136
QUICK TYRE REPAIR KIT
FIX & GO automatic......................................... 138
REPLACING A WHEEL.................................... 142
WHEN NEEDING TO CHANGE A BULB ......... 147
IF AN EXTERIOR LIGHT BURNS OUT ............ 150
IF AN INTERIOR LIGHT BURNS OUT............. 155
IF A FUSE BLOWS............................................ 156
IF THE BATTERY IS FLAT .............................. 162
LIFTING THE CAR........................................... 162
TOWING THE CAR........................................... 163
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 135

136
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
OPENING/
CLOSING OF
DOORS
Emergency device for locking
doors from the outside
The doors are fitted with an emer-
gency device so that they can be
closed using a lock in the event of a
current failure.
In this case, to close the doors of the
car, proceed as follows:
❒fit the ignition key into the revolv-
ing plug B-fig. 1.
❒turn it to 1and close the door.
fig. 1L0D0247m
STARTING
THE ENGINE
STARTING WITH AN
AUXILIARY BATTERY
If the battery is lat, the engine may be
started using an auxiliary battery with
the same capacity or a little higher
than the flat one.
Proceed as follows:
❒connect the positive terminals (+
sign near the terminal) of the two
batteries using an appropriate ca-
ble; To re-open the door, proceed as fol-
lows:
❒fit the ignition key in the revolving
plug of the lock on the driver’s side
and turn it anticlockwise
❒open the door on the driver side
❒from the inside of the car, open the
remaining doors by lifting the re-
spective levers on the door han-
dles.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 136

WARNING
137
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
❒using a second cable connect the
negative terminal (–) of the auxil-
iary battery to the ground E
on the
engine or on the gearbox of the car
to be started;
❒Start the engine;
❒when the engine has been started,
remove the leads reversing the or-
der above.
If after various attempts the engine
does not start, do not persist in vain.
Contact a Lancia Dealership.
IMPORTANT Do not connect the neg-
ative terminals of the two batteries di-
rectly: sparks could ignite explosive
gas released from the battery. If the
auxiliary battery is installed on an-
other car, prevent accidental contact
between metallic parts of the two cars.Never use a quick battery
charger for the emergency
start: this could damage the
electronic systems and the
engine fuel feed and ignition control
units.
This starting procedure
must be carried out by
expert personnel as incorrect ma-
noeuvres can cause electric dis-
charges of considerable intensity.
Furthermore, battery fluid is poi-
sonous and corrosive: avoid con-
tact with your skin and eyes. Keep
naked flames away from the bat-
tery. No smoking. Do not cause
sparks.
fig. 2L0D0396m
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 137

138
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
Indicate that the car is sta-
tionary according to the
laws in force: emergency lights, re-
fracting warning triangle, etc. Pas-
sengers should leave the car, partic-
ularly if it is very loaded and wait
for the wheel to be changed away
from on-coming traffic. In case of
steep slopes or rough slopes, place
wedges or other materials suitable
to stop the vehicle under the wheels.
WARNINGQUICK TYRE
REPAIR KIT FIX
& GO automatic
(if provided for)
The quick tyre repair kit Fix & Go
automaticfig. 3is placed in the boot.
The kit includes:
❒cylinderAcontaining sealing liq-
uid and fitted with:
– filling pipe B;
– adhesive label Cbearing the
words “max. 80 km/h”, to be at-
tached in a position easily visi-
ble to the driver (on the dash-
board) after tyre repair;
❒informative leaflet fig. 4, used to
ensure the correct use of the quick
tyre repair kit and then given to
the personnel who will handle the
treated tyre; BUMP STARTING
Never jump start the engine by push-
ing, towing or driving downhill. This
could cause a flow of fuel into the cat-
alytic converter and damage it beyond
repair.
IMPORTANT Remember that the
brake booster and the power steering
system are not operating until the en-
gine is started, a greater effort will
therefore be required to press the
brake pedal or turn the steering
wheel.
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 138

140
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
INFLATION PROCEDURE
❒Ensure that the handbrake is
up. Unscrew the pneumatic valve
cap, take out the flexible filling
pipeA-fig. 5and screw down the
ring nut Bon the tyre valve;
fig. 5L0D0484m
Wear the protective gloves
provided with the quick
tyre repair kit.
WARNING
The cylinder contains eth-
ylene glycol. Contains la-
tex: may cause an allergic reaction.
Harmful if swallowed. Irritant for
the eye. May cause sensitization by
inhalation or contact. Avoid con-
tact with your eyes, skin and
clothes. In the event of contact,
wash immediately with plenty of
water. Do not induce vomiting if
swallowed. Rinse your mouth and
drink plenty of water. Call a doc-
tor immediately. Keep away from
children. The product must not be
used by asthmatics. Do not breath
in the vapours during insertion and
suction. Call a doctor immediately
if allergic reactions are noted.
Store the cylinder in the specific
compartment, away from sources
of heat.
WARNING
❒ensure that the switch D-fig. 6of
the compressor is in the 0(off) po-
sition, start the engine, fit the plug
A-fig. 7in the cigar lighter (or
12V socket) and switch on the
compressor by turning the switch
Dto the I(on) position. Inflate the
tyre to the pressure specified in the
“Inflation pressure” paragraph,
“Technical Specifications” chap-
ter.
fig. 6L0D0364m
fig. 7L0D0177m
135-164 MUSA 3ed GB 12-11-2007 11:38 Pagina 140