2008.5 Citroen C5 Owner's Manual

79
4
A C C E S S
PANORAMIC SUN ROOF (SALOON)
This sun roof provides optimum light
and visibility in the passenger com-
partment.
Sun roof closed
- Press B to fi rst notch: tilting.
- Press B to second notch: auto-
matic complete tilting.
- Press A to fi rst notch: sliding
towards rear.
- Press A to second notch: auto-
matic total sliding towards rear. Sun roof open
- Press
B to fi rst notch: closure.
- Press B to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time.
In the event of anything being
caught by the sun roof closing, you
must reverse the roof movement.
To do that, reverse the position of
the control concerned.
When the driver is operating the sun
roof, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sun roof control
correctly.
Pay special attention to where children
are when operating the sun roof.
The fi tting of a sun roof as an
accessory is prohibited.
Operation
Tilted sun roof
- Press
A to fi rst notch: closure.
- Press A to second notch: auto-
matic total closure.
Your sun roof is fi tted with a manually-
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens. Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.

 move control B until the roof is in
the complete tilting position,

 keep control B pressed down for
a minimum of 1 second.

During these operations, the anti-
pinch function does not operate.

80
4
A C C E S S
GLASS PANORAMIC ROOF (TOURER)
This device comprises a tinted glass
panoramic area 1 to improve bright-
ness and vision in the passenger
compartment.
It is fi tted with an electrical blind 2
to help maintain a comfortable tem-
perature and reduce noise. Opening

 Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing

 Press control B .
Press to the fi rst notch to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon
as you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:

 press control B to the 2nd notch
(fully closed),

 wait until the blind is fully
closed,

 press control B for at least 3 sec-
onds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:

 Press control B until the blind
closes fully.

During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that his
passengers are using the blind cor-
rectly.
Pay special attention to children
when operating the blind.
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:

 press control B until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRICAL BLIND

81
4
A C C E S S
FUEL TANK

Capacity of the tank: approxi-
mately 71 litres.
Low fuel level
When the minimum level
in the tank is reached,
this warning lamp comes
on in the instrument
panel, accompanied by an audible
warning and a message on the mul-
tifunction screen.

You have enough fuel left to drive
approximately 30 miles (approx.
50 km).
 Press at the top left corner, then
pull open from the left.
 turn the key a quarter turn to lock
and unlock the fi ller cap,

 when refuelling, place the cap on
hook A ,

 fi ll the tank, but do not persist
after the third cut-off ; this could
cause your vehicle to malfunc-
tion.

While you are refuelling, the en-
gine must be stopped and the ig-
nition switched off.

For a petrol engine with a cata-
lytic converter, unleaded fuel is
compulsory.
Opening the fuel flap
The fi ller neck is narrower to en-
sure that only unleaded petrol noz-
zles can be put in.
Refuelling

82
4
A C C E S S
Fuel quality
A label inside the fi ller fl ap tells you
which type of fuel to use.
The petrol engines are designed to
run on RON 95.
However, for better performance
(petrol engine), we recommend
RON 98.
In winter conditions, starting from
cold may sometimes seem diffi cult.
During periods of very cold weather
we recommend the use of 95 or 98
unleaded petrol in preference to
E85 so as to ensure optimum start-
ing performance.
BioFlex engine
A Biofl ex vehicle is one that has
been designed to operate equally
on unleaded petrol (95 or 98 RON)
or on bioethanol (in Europe this is a
mixture of 85 % ethanol and 15 %
unleaded petrol, known as E85).
As a result, no matter how much fuel
remains in the tank, and whatever
this fuel may be (unleaded petrol,
E85 or a mixture of the two) you can
refuel at any time with unleaded pe-
trol (95 or 98 RON) or with bioetha-
nol (E85).
There is no problem in running this
vehicle on only unleaded petrol.

If you should put in fuel that is
not suitable for your vehicle’s
engine type, it is imperative to
have the tank drained before
you start the engine again.

83
V I S I B I L I T Y
5
LIGHTING CONTROLS
System for selection and control of
the various front and rear lamps pro-
viding the vehicle’s lighting.
Main lighting
The various front and rear lamps of
the vehicle are designed to adapt
the driver’s visibility progressively in
relation to the climatic conditions:
- sidelamps, to be seen,
- dipped headlamps to see with-out dazzling other drivers,
- main beam headlamps to see clearly when the road is clear,
- directional headlamps for im- proved visibility when cornering.
Additional lighting
Other lamps are fi tted to fulfi l the re-
quirements of particular driving con-
ditions:
- a rear fog lamp to be seen from a distance,
- front fog lamps for even better forward vision,
- daytime running lights to be seen during the day. Programming
Various automatic lighting control
modes are also available depending
on options:
- guide-me-home lighting,
- automatic lighting,
- directional lighting.
Manual controls
lamps off,
automatic switching on of
the lamps,
sidelamps only,
dipped headlamps or
main beam headlamps.

B. stalk for switching headlamps by
pulling: dipped headlamps/main
beam headlamps.
In the lamps off and sidelamps
modes, the driver can switch on the
main beam headlamps temporarily
("headlamp fl ash") by maintaining a
pull on the stalk.
Displays
Lighting of the corresponding indi-
cator lamp on the instrument panel
confi rms the selective switching on
of the lighting selected.
The lighting commands are issued
directly by the driver by means of
the ring
A and the stalk B .
A. main lighting mode selection
ring, with:

84
V I S I B I L I T Y
5

C. fog lamps selection ring.
The fog lamps operate with the
sidelamps and the dipped and main
beam headlamps.
- 1 st turn forwards: rear foglamps on.
- 1 st turn rearwards: rear foglamps off.

- 1 st turn forwards: front foglamps on.
- 2 nd turn forwards: rear foglamps on.
- 1 st turn rearwards: rear foglamps off.
- 2 nd turn rearwards: front foglamps off.
Model with rear foglamps only
Model with front and rear
foglamps In good or rainy weather, both day
and night, the front foglamps and
the rear foglamps are prohibited. In
these situations, the power of their
beams may dazzle other drivers.
They should only be used in fog or
snow.
In these weather conditions, it is
your responsibility to switch on the
foglamps and dipped headlamps
manually as the brightness sensor
may detect suffi cient light.
Do not forget to switch off the front
foglamps and the rear foglamps
when they are no longer necessary.
Lamps on buzzer
The triggering of an audible signal
when a front door is opened warns
the driver that he has forgotten to
switch off his vehicle’s lamps, with
the ignition off and in manual lamps
mode.
In this case, switching off the lamps
stops the audible signal.
With the ignition off, if the dipped
headlamps remain on, they will
switch off automatically after thirty
minutes to prevent discharging of
the battery.

85
V I S I B I L I T Y
5
* According to country.
Daytime-running lamps
System which switches on special
lamps at the front, to make the vehi-
cle more visible by day.
They light up automatically and per-
manently, when the engine is running,
if:
- The function is activated * in the
"Main Menu" of the instrument
panel screen.
- The lighting control is at posi- tion 0 or AUTO .
- All the headlamps are off.
You can deactivate * this function
using the "Main Menu" of the instru-
ment panel screen. Manual guide-me-home
lighting
The temporary maintaining of the
dipped headlamps lighting after the
vehicle's ignition has been switched
off makes the driver's exit easier
when the light is poor.
Switching on

 With the ignition off, "fl ash" the
headlamps using the lever B .

 A second "headlamp fl ash"
switches the function off again.
Switching off
The manual guide-me-home lighting
switches off automatically after a set
time. Automatic lighting
The sidelamps and dipped head-
lamps are switched on automatically,
without any action on the part of the
driver, when a low level of external
light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns
to a suffi cient level or after the wind-
screen wipers are switched off, the
lights are switched off automatically.
Activation

 Turn ring A to the "AUTO" posi-
tion. The automatic lighting is ac-
companied by a message on the
multifunction screen.
Deactivation

 Turn ring A to a position other
than "AUTO" . Deactivation is
accompanied by a message on
the multifunction screen.

85
V I S I B I L I T Y
5
* According to country.
Daytime-running lamps
System which switches on special
lamps at the front, to make the vehi-
cle more visible by day.
They light up automatically and per-
manently, when the engine is running,
if:
- The function is activated * in the
"Main Menu" of the instrument
panel screen.
- The lighting control is at posi- tion 0 or AUTO .
- All the headlamps are off.
You can deactivate * this function
using the "Main Menu" of the instru-
ment panel screen. Manual guide-me-home
lighting
The temporary maintaining of the
dipped headlamps lighting after the
vehicle's ignition has been switched
off makes the driver's exit easier
when the light is poor.
Switching on

 With the ignition off, "fl ash" the
headlamps using the lever B .

 A second "headlamp fl ash"
switches the function off again.
Switching off
The manual guide-me-home lighting
switches off automatically after a set
time. Automatic lighting
The sidelamps and dipped head-
lamps are switched on automatically,
without any action on the part of the
driver, when a low level of external
light is detected or in certain cases of
activation of the windscreen wipers.
As soon as the brightness returns
to a suffi cient level or after the wind-
screen wipers are switched off, the
lights are switched off automatically.
Activation

 Turn ring A to the "AUTO" posi-
tion. The automatic lighting is ac-
companied by a message on the
multifunction screen.
Deactivation

 Turn ring A to a position other
than "AUTO" . Deactivation is
accompanied by a message on
the multifunction screen.