2008.5 Citroen C5 Owner's Manual

145
9
D R I V I N G The parking assistance system
cannot, in any circumstances, re-
place the need for vigilance and
responsibility on the part of the
driver.
VISUAL AND AUDIBLE FRONT AND/OR REAR PARKING ASSISTANCE
System consisting of proximity sen-
sors, installed in the front and/or rear
bumper.
It detects any obstacle (person, ve-
hicle, tree, barrier...) located in front
of or behind the vehicle, however,
it will not be able to detect obsta-
cles located immediately below the
bumper.
An object, such as a stake, a road-
works cone or any other similar ob-
ject may be detected at the start of
the manoeuvre but may no longer
be detected when the vehicle moves
nearer to it. The parking assistance is
switched
on :
- by engaging reverse gear,
- at a speed below 6 mph (10 km/h) in forward gear.
This is accompanied by an audible
signal and/or displaying of the vehicle
on the multifunction screen.
The proximity information is indicated
by:
- an audible signal which becomes more rapid as the vehicle appro-
aches the obstacle,
- a diagram on the multifunction display, with blocks which move
closer to the vehicle.
The obstacle is located in relation to
the emission of the audible signal by
the speakers; front or rear and right
or left.
When the distance between the ve-
hicle and the obstacle is less than
approximately twenty-fi ve centime-
tres, the audible signal becomes
continuous and/or the "Danger"
symbol appears, depending on the
multifunction screen version.
The parking assistance is switched
off :
- when you exit reverse gear,
- when the speed is higher than 6 mph (10 km/h) in forward gear,
- when the vehicle has been station- ary for more than three seconds in
forward gear. Deactivation

 Press button A , the warning lamp
comes on, the system is fully de-
activated.
The system will be deactivated auto-
matically when a trailer is being
towed or when a bicycle carrier is
fi tted (vehicle fi tted with a towbar
or bicycle carrier recommended by
CITROËN).

146
9
D R I V I N G
Reactivation
In bad weather or in winter, ensure
that the sensors are not covered with
mud, ice or snow. When reverse gear
is engaged, an audible signal (long
beep) indicates that the sensors may
be dirty.

 Press button A again, the warn-
ing lamp switches off, the system
is reactivated.
"HYDRACTIVE III+" ELECTRONIC SUSPENSION
The suspension automatically and
instantly adjusts to different driving
styles and to the profi le of the road,
providing the best compromise be-
tween occupant comfort and vehicle
road holding.
It allows you to alternate between
soft and fi rm suspension settings,
maximising comfort at the same
time as permanently guaranteeing
the highest level of safety. It also
automatically corrects road holding,
according to the vehicle load and
driving conditions.
Also, the "Hydractive III+" suspen-
sion gives you the possibility of
choosing between two modes of
suspension.
A change of suspension mode can
be made either when the vehicle is
moving or when stationary, by press-
ing on button A . Display on the instrument
panel
The suspension mode selected is
displayed on the instrument panel
screen.
Normal mode
This mode favours soft
damping for maximum com-
fort.
If the speed authorised for a
particular position is exceed-
ed, the vehicle reverts automatically
to the normal road position.
SPORT mode
This mode favours dynamic
driving.
The warning lamp on button A
comes on in addition to the
message on the instrument
panel screen.

SPORT mode is retained when you
switch off the engine.

146
9
D R I V I N G
Reactivation
In bad weather or in winter, ensure
that the sensors are not covered with
mud, ice or snow. When reverse gear
is engaged, an audible signal (long
beep) indicates that the sensors may
be dirty.

 Press button A again, the warn-
ing lamp switches off, the system
is reactivated.
"HYDRACTIVE III+" ELECTRONIC SUSPENSION
The suspension automatically and
instantly adjusts to different driving
styles and to the profi le of the road,
providing the best compromise be-
tween occupant comfort and vehicle
road holding.
It allows you to alternate between
soft and fi rm suspension settings,
maximising comfort at the same
time as permanently guaranteeing
the highest level of safety. It also
automatically corrects road holding,
according to the vehicle load and
driving conditions.
Also, the "Hydractive III+" suspen-
sion gives you the possibility of
choosing between two modes of
suspension.
A change of suspension mode can
be made either when the vehicle is
moving or when stationary, by press-
ing on button A . Display on the instrument
panel
The suspension mode selected is
displayed on the instrument panel
screen.
Normal mode
This mode favours soft
damping for maximum com-
fort.
If the speed authorised for a
particular position is exceed-
ed, the vehicle reverts automatically
to the normal road position.
SPORT mode
This mode favours dynamic
driving.
The warning lamp on button A
comes on in addition to the
message on the instrument
panel screen.

SPORT mode is retained when you
switch off the engine.

147
9
D R I V I N G
Vehicle positions
Maximum height
Changing a wheel (Not possible if
speed > 6 mph (10 km/h)).
Intermediate position
For an increased ground clearance
(Not possible if speed > 25 mph
(40 km/h)).
For use on diffi cult roads when trav-
elling at reduced speed, as well as
on car park ramps.

Position changes may only be
made when the engine is running.
Adjustable ground clearance re-
sponds to all types of situation.
Apart from a few specifi c situations,
driving in the normal road position is
imperative.

 Press once on one of the adjust-
ment controls.
The change in position is indicated
by a message on the instrument
panel screen.
Normal position
If the speed authorised for a particu-
lar position is exceeded, the vehicle
reverts automatically to the normal
position.
Minimum height
To facilitate loading or unloading the
vehicle.
For workshop inspections.
Not to be used in normal driving (Not
possible if speed > 6 mph (10 km/h)).

148
9
D R I V I N G
Position not authorised
The instrument panel screen tempo-
rarily displays a message indicating
that this position is not authorised.
The vehicle remains in the author-
ised position and the instrument
panel screen indicates this position
to you.
Automatic variation of ground clear-
ance
- If your speed exceeds 70 mph (approx. 110 km/h), on a good
road surface, ground clearance
is lowered. The vehicle returns
to its normal position if the road
surface deteriorates or if your
speed is lower than 55 mph (ap-
prox. 90 km/h).
- At low or medium speed, if the road surface is poor, ground
clearance is increased. The ve-
hicle returns to its normal posi-
tion as soon as conditions allow.
- On switching off the ignition, the ground clearance is reduced to
the parking position

For your safety if you are operating
underneath the vehicle,
you must

support the vehicle with axle stands.

150
10
C H E C K S
BONNET
Protects the components of the
engine and provides access for
checking levels.
Opening

Lift the lever B and raise the bonnet.

 Unclip the strut C from its housing
and pivot it to insert it in the notch

D indicated by a yellow arrow.

 Fix the strut in the notch to hold
the bonnet open. Closing

 Take the strut out of the support
notch.

 Clip the strut in its housing.

 Lower the bonnet then slam it
fi rmly at the end of its travel.

 Pull on the bonnet to check that
it is secured correctly.
To avoid any risk of burns, only han-
dle the bonnet strut by its yellow
end.
The location of the interior control
prevents opening of the bonnet
while the front passenger’s door is
closed.
This operation must only be carried
out when the vehicle is stationary.
Avoid opening the bonnet in strong
winds.

 Open the front passenger door.

 Pull the interior control A , located
at the bottom of the door frame.

151
10
C H E C K S
DRAINING THE DIESEL FUEL FILTER
Protective cover
Removal of the cover Draining water from the fuel
filter
Drain regularly (at each oil change).
To drain the water, slacken the bleed
screw or the water in diesel fuel sen-
sor, located at the base of the fi lter.
Continue until all the water has
fl owed out.
Then retighten the bleed screw or
the water detection sensor.

HDi 110, HDi 173 and V6 HDi 208
engines

 Pull the protective cover upwards
to remove it.

HDi 138 engine

 Remove the protective cover
by fi rst unclipping at 3 , then 1
and 4.

 Unclip at 2 by pulling towards
you, then lift up. Refi tting

 Firstly clip in at 2 .

 Lower and centre the cover.

 Clip in at 3 and 4 , pushing verti-
cally and gently from the rear.

 Clip in at 1 pushing vertically.

152
10
C H E C K S
RUNNING OUT OF FUEL (DIESEL)
HDi 110 engine

 Unclip the protective cover
to gain access to the priming
pump. HDi 138 and HDi 173 engines

 Unclip the protective cover
to gain access to the priming
pump.
Priming the fuel circuit
In the event of running out of fuel:

 after fi lling (minimum 5 litres)
and removing the protective
cover, operate the manual prim-
ing pump, until some resistance
is felt,

 operate the starter motor while
depressing the accelerator pedal
slightly until the engine starts. HDi engines are the result
of advanced technology.
All maintenance and repairs require
special qualifi cations which only a
CITROËN dealer can guarantee.
V6 HDi 208 engine with electric
pump
In the event of running out of fuel:

 after adding fuel, turn the ignition
key to position M , wait for a few
seconds,

 operate the starter motor until
the engine starts.
If the engine fails to start after sev-
eral attempts, contact a CITROËN
dealer.
If the engine fails to start at the fi rst
attempt, wait fi fteen seconds before
trying again.
If the engine fails to start after a
few attempts, operate the priming
pump again and then try to start the
engine.
When the engine is idling, acceler-
ate slightly to complete the bleeding
of the circuit.