2007 VOLVO C70 CONVERTIBLE Owner´s Manual

2007 Volvo C70
The upper right-hand corner of the rearview mirror has an integrated dis\
play that shows the compass direction toward
which the car is pointing. Eight different directions can be displayed: \
N, NE, E, SE, S, SW, W and NW. The display
shows your car's orientation with respect to true north.
Calibrating the compass
The compass may need to be calibrated in certain cases. If calibration i\
s required, the character C appears in the
mirror's display.
The earth is divided into 15 magnetic zones. The compass is initially se\
t for the zone to which the car was delivered,
and should always be adjusted if the car is driven to a new magnetic zon\
e. A "C" will be displayed if calibration
becomes necessary.
70 02 Instruments and controls
Mirrors
To calibrate the compass:
1. Stop the car in a large, open area, away from traffic.
file:///K|/delme/2007_C70/07c70_02.htm (33 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
2. Using a pen or similar object, hold the button (1) depressed for at\
least 6 seconds. "C" will be displayed.
3. Press button (1) for at least 3 seconds to display the number of th\
e current magnetic zone.
4. Press button (1) repeatedly until the number for the required geogr\
aphical area (1-15) is displayed. "C" will be
displayed again.
5. Drive slowly in a circle at a maximum speed of 6 m.p.h. (10 km/h) u\
ntil a compass direction is displayed.
Calibration is complete.
Magnetic zones
71 02 Instruments and controls
Mirrors
Power door mirrors
file:///K|/delme/2007_C70/07c70_02.htm (34 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
The mirror control switches are located on the driver's door armrest.
To adjust the mirrors:
Driver's door mirror:
Press the L button (a light in the switch will go on) to activate the \
adjustment control. Use this control to adjust the
driver's door mirror.
Passenger's door mirror:
Press the R switch (a light in the switch will go on) to activate the \
adjustment control.
Use this control to adjust the passenger's door mirror.
After you have adjusted the mirror(s), press the L or R switch again (\
the LED will go out) to deactivate the
adjustment control.
WARNING
l The mirrors should always be adjusted prior to driving.
l Objects seen in the passenger's side wide-angle door mirror are closer t\
han they appear to
be.
Storing the mirrors' position
The position of the power door mirrors is stored when the car is locked \
with the remote control. When the car is
unlocked with the same remote control, the mirrors will move to the stor\
ed position.
72 02 Instruments and controls
Personal settings
file:///K|/delme/2007_C70/07c70_02.htm (35 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
Control panel
A. Display
B. Menu button
C. Exit button
D. Enter button
E. Menu navigation controls
Personal settings can be made for some of the car's functions, such as t\
he central locking system, climate control, and
the audio system. Please refer to
page 219 for more information on the audio functions that can be adjusted. The
settings are presented in the display (A).
To access the menu and adjust settings:
1. Press MENU (B).
2. Scroll to "Car Settings" using the menu navigation control (E).
3. Press ENTER (D).
4. Select an alternative using the menu navigation control (E).
file:///K|/delme/2007_C70/07c70_02.htm (36 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
5. Confirm your selection by pressing ENTER.
To exit the menu:
l Press EXIT (C).
Available settings
Lock confirmation light
When the car is locked/unlocked with the remote control, the direction i\
ndicators can be selected to flash to confirm
the action. The alternatives On/Off are available for both locking and u\
nlocking.
Autolock
When the car starts to move, the doors and trunk can be locked automatic\
ally. The alternatives On/Off are available.
NOTE
Pulling the handle twice on a door unlocks and opens that
door.
Unlock
There are two alternatives for unlocking:
l Global (All doors)
Unlocks all doors and the trunk with one press on the remote control.
l Two Step (Two-stage unlocking)
This alternative unlocks the driver's door with one press on the remote \
control. A second press unlocks the passenger's
door and the trunk.
73 02 Instruments and controls
Personal settings
Approach lighting
This alternative determines the length of time for which the car's light\
s will remain on when the Approach light button
on the central locking system's remote control is pressed. Intervals of \
30/60/90 seconds may be selected. See
page 109
for more information.
Home safe lighting
This alternative determines the length of time for which the car's light\
s will remain on when the high beam lever on
the steering column is pulled toward the wheel with the ignition switche\
d off. Intervals of 30/60/90 seconds may be
selected. See
page 57 for information on using this function.
Information
file:///K|/delme/2007_C70/07c70_02.htm (37 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
l VIN number:
The VIN (Vehicle Identification Number) is the car's unique identity n\
umber.
l Number of Keys:
The number of keys registered for the car is displayed here.
Climate functions
l Blower speed in AUTO mode:
The blower speed can be set to AUTO mode in models equipped with ECC. Ch\
oose between "Low", "Normal" and
"High".
l Timer for recirculation:
When the timer is active, the air recirculates in the car for 3-12 minut\
es depending on the ambient temperature. Select
On/Off depending on whether the recirculation timer is to be active or n\
ot.
Reset to factory settings
Use this alternative to return to the default climate system settings.
74 02 Instruments and controls
HomeLink® Universal Transceiver (option)
02 Introduction
HomeLink1 is a system that can be programmed to learn the codes of three differen\
t remote controlled-devices (for
example, a garage door opener, remote lighting, entry gate). HomeLink's\
sun visor-mounted transceiver, powered by
your car's electrical system, may then be used in place of your handheld\
remote controls. The HomeLink transceiver
consists of three programmable buttons and an indicator light.
1 HomeLink is a registered trademark of Johnson Controls, Intl.
© JCI, All rights reserved
file:///K|/delme/2007_C70/07c70_02.htm (38 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
NOTE
l For your security, the HomeLink Universal Transceiver is designed to not\
function if you lock your car from the
outside.
l Retain the original transmitter(s) for future programming procedures (\
for example, if you purchase a new
vehicle).
l For your own security, erase all programmed buttons on the HomeLink Univ\
ersal Transceiver when you sell your
vehicle.
l Metallic sun protection films should not be used on any windows in a veh\
icle equipped with HomeLink Universal
Transceiver. This could interfere with the transceivers function.
Operating the HomeLink Universal Transceiver
Once programmed, the HomeLink Universal Transceiver can be used in place\
of your handheld transmitters.
NOTE
The HomeLink universal transceiver will function for 30 minutes after th\
e driver's door has been opened without
switching on the vehicle's ignition.
Press the programmed HomeLink button to activate the garage door, drivew\
ay gate, security lightning, home security
system etc.
Your original hand-held transmitters may, of course, be used at any time\
.
WARNING
l If you use HomeLink to open a garage door or gate, be sure no one is nea\
r the gate or door while it is in motion.
l Do not use the HomeLink Universal Transceiver with any garage door opene\
r that lacks safety "stop" and
"reverse" features as required by federal safety standards. (This inclu\
des any garage door opener model
manufactured before April 1, 1982). A garage door opener that cannot "d\
etect" an object, signalling the door to
"stop" and "reverse" does not meet current federal safety standards. Usi\
ng a garage door opener without these
features increases the risk of serious injury or death. For more informa\
tion on this matter, call toll-free 1-800-355-
3515. (Internet:
www.HomeLink.com).
Programming the transceiver for the first time (U.S. residents)
1. For first time training, press and hold the two outer HomeLink button\
s, releasing only when the HomeLink
indicator light begins to flash after 20 seconds. (Do not perform this \
step when training the additional HomeLink
buttons.)
2. Position the hand-held transmitter 1-3 inches away from the HomeLink \
surface
75 02 Instruments and controls
HomeLink® Universal Transceiver (option)
file:///K|/delme/2007_C70/07c70_02.htm (39 of 43)12/22/2006 9:15:42 PM\

2007 Volvo C70
(located on your sun visor), keeping the HomeLink indicator light in v\
iew.
3. Using both hands, simultaneously press and hold both the desired Home\
Link button and hand held transmitter
button. DO NOT release until the HomeLink indicator light flashes slowly\
and then rapidly. When the indicator light
flashes rapidly, both buttons may be released. (The rapid flashing indi\
cates successful training.)
NOTE
Some garage door openers may require you to replace step 3 with the "cyc\
ling" procedure noted in the
"Programming the transceiver for the first time (Canadian residents)" \
section.
4. Press and hold the trained HomeLink button and observe the indicator \
light.
l If the indicator light is solid/continuous, training is complete and you\
r device should activate when the HomeLink
button is pressed and released.
l If the indicator light blinks rapidly for 2 seconds and then turns a sol\
id/continuous light, proceed with the following
training instructions for a rolling code device. A second person may mak\
e the following steps quicker and easier.
Please use a ladder or other device. Do not stand on your vehicle to per\
form the next steps.
5. At the garage door opener receiver (motorhead unit) in the garage, \
locate the "learn" or "smart" button (usually near
where the hanging antenna wire is attached to the unit). If there is di\
fficulty locating the training button, reference the
garage door opener's manual or contact us toll-free 1-800-355-3515 (Int\
ernet:
www.HomeLink.com).
6. Press and release the "learn" or "smart" button (the name and color \
of the button may vary by manufacturer).
NOTE
Once the button is pressed, there are 30 seconds in which to initiate th\
e next
step.
7. Return to the vehicle and firmly press and hold the trained HomeLink \
button for two seconds and release. Repeat
the "press/hold/release" sequence up to 3 times to complete the training\
process.
To train additional HomeLink buttons, begin with step two.
Programming the transceiver for the first time (Canadian residents)
1. For first time training, press and hold the two outer HomeLink button\
s releasing only when the HomeLink indicator
light begins to flash after 20 seconds. (Do not perform this step when \
training the additional HomeLink buttons.)
2. Position the hand-held transmitter 1-3 inches (2.5-7.5 cm) away fro\
m the HomeLink surface (located on your)
keeping the HomeLink indicator light in view.
3. Using both hands, simultaneously press and hold both the desired Home\
Link button and hand held transmitter
button. During programming, your handheld transmitter may automatically \
stop transmitting. Continue to press and
hold the desired HomeLink button while you press and re-press ("cycle")\
your handheld transmitter every two
file:///K|/delme/2007_C70/07c70_02.htm (40 of 43)12/22/2006 9:15:42 PM\