2007 DODGE SPRINTER ignition

13 At a glance
Cockpit
1
Function
Page
1
Door control panel
22
2
Light switch
77
3
Combination switch\4Turn signals
\4High-beam headlamps
\4Windshield wipers
\4Rear window wiper*
79
77
126
127
4
Cruise control lever*
147
5
Horn
6
Steering wheel without/
with* buttons
17
Function
Page
7
Instrument cluster
14, 84
8
Storage compartment
9
Storage compartment with
interior lamp
80
Overhead control panel*
19
a
Rear-view mirror*
125
b
Warning display for Park-
tronic system*
150
c
Opens / closes the right-
hand side window
144
d
Jack and vehicle tool kit
300
e
Glove box
165
Function
Page
f
Center console
18
g
Selector lever (automatic
transmission)
111
h
Ignition lock
67
j
Additional switch unit
20
k
Handbrake
115
l
Steering wheel adjustment
76
m
Hood lock release
185
n
Additional switch unit
20

21 At a glance
Switch units
1
Switch unit between the steering wheel and
the ignition lock
Function
Page
³
Switches the heater
booster function*
on/off
137
ö
³
Switches auxiliary heat-
ing*
on/off
140
Switches the heater
booster function*
on/off
137
Adjusts the working en-
gine speed*
155
Switches the operating
speed governor*
on/off
154
Ventilates the load
compartment,
air in/air out*
146
iThe layout of the switches may vary,
depending on the vehicle’s equipment.
N54.25-2912-31
Function
Page
Switches the rear-com-
partment convenience
interior lighting*
on/off
82
iThe layout of the switches may vary,
depending on the vehicle’s equipment.

28 SafetyOccupant safety
2
Adjust the belt height in such a way that
the shoulder belt is routed over the middle
of the shoulder.Belt sash guide with height adjustment5Release button
\1To raise the belt height: slide belt
sash guide1 upward.
Belt sash guide1 engages in various
positions.
\1To lower the belt height: press and
hold release button 5.\1Slide belt sash guide1 to the desired
height.
\1Let go of release button5 and make
sure that belt sash guide1 engages.
The SRS (S
upplemental R
estraint S
ystem)
may consist of the following components,
depending on the equipment level:
\41 warning lamp
\4Emergency tensioning retractors
\4Belt force limiters
\4Airbag system with:
\4Airbag control unit
\4Airbags1 warning lamp
The SRS performs a self-test at regular in-
tervals when the ignition is switched on
and while the engine is running. Malfunc-
tions can therefore be detected in good
time.
The 1 warning lamp in the instrument
cluster (\2page 14) comes on for approxi-
mately 4 seconds when you switch on the
ignition.
SRS (Supplemental Restraint
System)
Warning
G
A malfunction has occurred if the 1
warning lamp:
\4does not come on when you switch on
the ignition
\4does not go out after approximately 4
seconds
\4lights up again
Individual systems may be activated unin-
tentionally or may not be triggered in the
event of an accident with a high rate of vehi-
cle deceleration.

30 SafetyOccupant safety
2
Vehicle deceleration or acceleration and
the direction of the force are essentially
determined by:
\4the distribution of the force during the
impact
\4the collision angle
\4the deformation characteristics of the
vehicle
\4the composition of the object involved
in the collision, for example the other
vehicle
Factors that cannot be seen or measured
until after the collision are not used to de-
termine whether the airbag should be trig-
gered and are not decisive for this.
The vehicle may be substantially deformed
without an airbag being triggered, for exam-
ple if only relatively easily-deformable vehicle
parts such as the hood or fenders are affect-
ed by the collision and the required deceler-
ation threshold is not reached. On the other
hand, airbags may be triggered even though
the vehicle only displays minor deformation,
if, for example, rigid vehicle parts such as a
longitudinal member are affected by the im-
pact, thus causing vehicle deceleration to ex-
ceed the pre-determined threshold. Emergency tensioning retractors, belt
force limiters
If the vehicle is equipped with a driver’s air-
bag, the driver’s and the co-driver’s seat
belts are equipped with emergency ten-
sioning retractors.
A belt force limiter additionally installed in
the seat belt reduces the load exerted by
the seat belt on the occupant when it is
triggered.
Emergency tensioning retractors tension
the seat belts in an accident, pulling them
close against the body. When the ignition is on, the emergency
tensioning retractor is activated:
\4only if the restraint systems are opera-
tional (the 1-warning lamp comes
on for approximately 4 seconds after
the ignition is switched on.)
(\2page 28).
\4in the event of a head-on or rear-end
collision, if there is a high rate of vehi-
cle acceleration or deceleration in the
initial stages of a collision
\4in the event of a side impact, if the ve-
hicle suddenly decelerates or acceler-
ates in a lateral direction at the initial
stage of the impact and the vehicle is
equipped with thorax / sidebags and /
or windowbags.
If the emergency tensioning retractors are
triggered, you will hear a bang that is gen-
erally harmless to your hearing. A small
amount of powder may also be released.
The 1 warning lamp lights up.
iEmergency tensioning retractors do
not correct:
\4incorrect sitting positions
\4incorrectly worn seat belts
Emergency tensioning retractors do
not pull occupants back towards the
backrest.

44 SafetyDriving safety systems
2
There is a malfunction if the # indicator
lamp is permanently lit while the engine is
running (\2page 272).
If ESP
® malfunctions, engine power output
may be reduced.ASR improves traction for a sustained peri-
od, i.e. the transfer of power from the tires
to the road surface, and thus also improves
the driving stability of the vehicle. ASR as-
sists you when pulling away and accelerat-
ing, especially on smooth and slippery
surfaces.
ASR brakes individual drive wheels and
limits the engine torque to prevent the
drive wheels from spinning. When ASR in-
tervenes, thev indicator lamp in the
speedometer flashes.
If the road surface is not capable of provid-
ing sufficient traction, bearing in mind the
tires, load and gradient, it is not be possi-
ble to pull away smoothly even with ASR.
Vehicles without steering wheel buttons:
There is a malfunction if thek indicator
lamp is permanently lit while the engine is
running (\2page 270).
If ASR malfunctions, engine power output
may be reduced.
Warning
G
Proceed as follows if the v warning lamp
in the speedometer flashes:
\4Do not deactivate ASR under any cir-
cumstances.
\4Only depress the accelerator pedal as
far as necessary when pulling away.
\4Adapt your driving style to suit the pre-
vailing road and weather conditions.
Otherwise, the vehicle could begin to skid.
ESP
® cannot reduce the risk of an accident
if you drive too fast. ESP
® is unable to over-
ride the laws of physics.
!
CAUTION
Only operate the vehicle briefly (maxi-
mum of 10 seconds) on a brake dyna-
mometer. The key must be turned to
position1 in the ignition lock during
this time. You could damage the drive
train or the brake system.
!
CAUTION
Do not operate the vehicle on a roller
dynamometer (for example for perfor-
mance testing). If you wish to operate
the vehicle on a roller dynamometer,
please consult an authorized Sprinter
Dealer beforehand. You could other-
wise damage the drive train or the
brake system.
Acceleration skid control (ASR)

47 Safety
Anti-theft systems
2
\3 Anti-theft systemsThe immobilizer prevents the vehicle from
being started without the correct key.
When leaving the vehicle, always take the
key or remote keyless entry transmitter
with you and lock the vehicle. The engine
could be started by anyone with a valid key
or remote keyless entry transmitter that is
left inside the vehicle
\1To switch on: remove the key from the
ignition lock (\2page 67).
\1To switch off: switch on the ignition
(\2page 67).A visual and audible alarm is triggered if
the alarm system is enabled and:
\4a door is opened
\4the hood is opened
Enabling the alarm system
\1Close all the doors.
\1Lock the vehicle using the‹ button
on the key (\2page 52).
The indicator lamp in the central lock-
ing switch (\2page 63) flashes.
Deactivating the anti-theft alarm sys-
tem
\1Unlock the vehicle using theΠbut-
ton on the key (\2page 52).
The indicator lamp in the central lock-
ing switch (\2page 63) goes out.Switching off the alarm
\1Insert the key into the ignition lock.
or
\1Press theΠbutton (\2page 52).
The alarm is switched off.Immobilizer
Anti-theft alarm system (ATA)*
iThe vehicle locks again automatically if
you do not open a door within 40 sec-
onds after unlocking the vehicle.iThe alarm system will be triggered if
the vehicle has been locked with the
key and is then unlocked from the in-
side.

48 SafetyAnti-theft systems
2
A visual and audible alarm is triggered if
the inclination of the vehicle changes while
tow-away protection is enabled.
Enabling tow-away protection
Tow-away protection is automatically en-
abled approximately 20 seconds after you
lock the vehicle.
Tow-away protection is automatically de-
activated when you unlock the vehicle.Deactivating the tow-away protection
for transportation
Deactivate tow-away protection if the vehi-
cle is transported or loaded onto another
vehicle. This will prevent false alarms.
The button is located in the overhead con-
trol panel.
1To deactivate tow-away protection
2Indicator lamp\1Turn the key to position0 or1
(\2page 67) in the ignition lock or re-
move the key.
\1Press button1.
Indicator lamp2 lights up for approxi-
mately 5 seconds after the button is re-
leased.
\1Lock the vehicle using the key.
Tow-away protection remains deactivated
until you lock the vehicle again.Tow-away protection*iThe tow-away protection alarm is trig-
gered shortly before the wheel leaves
the ground if the vehicle is being jacked
up on one side, for example.
iWhen the ignition is switched off
(\2page 67), you cannot deactivate
tow-away protection.

49 Safety
Anti-theft systems
2
If the anti-theft alarm system is enabled
and the vehicle is locked, a visual and au-
dible alarm is triggered if one of the side
windows or the rear window on your vehi-
cle is smashed and someone reaches into
the interior, for example.
Enabling the interior motion sensor
\1Close:
\4the side windows
\4the sliding sunroof
This will prevent false alarms.
\1Lock your vehicle.
The interior motion sensor is enabled
after approximately 40 seconds.Deactivating the interior motion sensor
Deactivate the interior motion sensor if
people or animals remain in the locked ve-
hicle. This will prevent false alarms.
The button is located in the overhead con-
trol panel.
1To deactivate the interior motion sen-
sor
2Indicator lamp
\1Turn the key to position0 or1
(\2page 67) in the ignition lock or re-
move the key.\1Press button1.
Indicator lamp2 lights up for approxi-
mately 5 seconds after the button is re-
leased.Interior motion sensor*iDo not leave anything (for example
mascots or coat hangers) hanging on
the rear-view mirror or on the grab han-
dles on the roof trim. This will prevent
false alarms.
iThe interior motion sensor remains
deactivated until you lock the vehicle
again.