2007 CADILLAC SRX Owners Manual

Page 209 of 522

CADILLAC SRX 2007 1.G Owners Manual This light should come on, as a check to show
you it is working, when the ignition is on and the
engine is not running. If the light does not
come on, have it repaired. This light will also
come on du

Page 210 of 522

CADILLAC SRX 2007 1.G Owners Manual Did you just drive through a deep puddle of water?
If so, your electrical system may be wet. The
condition will usually be corrected when the
electrical system dries out. A few driving trips
should tu

Page 211 of 522

CADILLAC SRX 2007 1.G Owners Manual Oil Pressure Light
{CAUTION:
Do not keep driving if the oil pressure is
low. If you do, your engine can become so
hot that it catches �re. You or others
could be burned. Check your oil as soon
as poss

Page 212 of 522

CADILLAC SRX 2007 1.G Owners Manual Security Light
For information
regarding this light, see
Theft-Deterrent
System on page 112.
Fog Lamp Light
The fog lamps light will
come on when the fog
lamps are in use.
The light will go out when t

Page 213 of 522

CADILLAC SRX 2007 1.G Owners Manual Highbeam On Light
This light comes on
whenever the
high-beam headlamps
are on.
SeeHeadlamp High/Low-Beam Changer on
page 169for more information.
Tow/Haul Mode Light
This light comes on
when the Tow/H

Page 214 of 522

CADILLAC SRX 2007 1.G Owners Manual All of the following situations are normal and do
not indicate that anything is wrong with the
fuel gage:
At the gas station the gas pump shuts off
before the gage reads full.
The gage may change wh

Page 215 of 522

CADILLAC SRX 2007 1.G Owners Manual When the sport mode is active, an S will appear
next to the shift position indicator on the center of
the DIC display. When the manual mode is
active, an M will appear on the DIC display. When
the nor

Page 216 of 522

CADILLAC SRX 2007 1.G Owners Manual UCustomization:Press this button to scroll
through each of the customization features. See
DIC Vehicle Customization on page 231for
more information on the customization features.
VSet/Reset:Press thi