Page 105 of 522
Notice:If you open the liftgate without
checking for overhead obstructions such as a
garage door, you could break the liftgate or
the liftgate glass. Always check to make sure
the area above the liftgate is clear before
opening it.
To open and close the liftgate, press and hold
the power liftgate button on the remote keyless
entry transmitter (RKE) until the liftgate starts
moving. Press the RKE button a second
time during liftgate operations to reverse that
operation. SeeRemote Keyless Entry (RKE)
System Operation on page 96for more
information.
The liftgate can also be power closed by pressing
the power liftgate button next to the liftgate
latch. Press the button a second time during
liftgate operation to reverse that operation. The
power liftgate may be temporarily disabled
under extreme temperatures or low battery
condition. If this occurs, the liftgate can still be
operated manually.
105
Page 106 of 522

If you shift the transmission out of PARK (P) while
the power function is in progress, the liftgate
power function will continue to completion. If you
shift the transmission out of PARK (P) and
accelerate before the power liftgate latches closed,
the liftgate may reverse to the open position.
Cargo could fall out of the vehicle. Always make
sure the power liftgate is closed and latched before
you drive away.
If you power open the liftgate and the liftgate
support struts have lost pressure, the lights will
ash and a chime will sound. The liftgate will hold
open temporarily, then slowly close. See your
dealer for service before using the liftgate.
Obstacle Detection Features
If the liftgate encounters an obstacle during a
power open or close cycle, a warning chime will
sound and the liftgate will automatically reverse
direction to the fully closed or open position. After
removing the obstruction, the liftgate may be
power opened or closed normally.If the liftgate encounters multiple obstacles on the
same power cycle, the power function will
deactivate, and the liftgate will switch to manual
operation. The REAR ACCESS OPEN warning
message in the Driver Information Center (DIC) will
indicate that the liftgate is open. After removing
the obstructions, manually open the liftgate to the
fully open position or close the liftgate to the
fully closed and latched position. The liftgate will
now resume normal power operation.
Your vehicle has an obstacle detection sensor
located on the rear edge of the rear quarter panel
windows. If an object is caught between the
liftgate and the window and presses against this
sensor, the liftgate will reverse direction and
open fully. The liftgate will remain open until it is
activated again or closed manually.
106
Page 107 of 522

Manual Liftgate Operation
With the doors unlocked, the power liftgate can
always be manually opened and closed.
To open the liftgate, pull up on the handle on the
outside of the liftgate. To close the liftgate,
use the pull cup to lower the liftgate and close.
The liftgate latch will power cinch to closed
position. Do not force the liftgate during a
power cycle.
Always close the liftgate before driving.{CAUTION:
It can be dangerous to drive with the
liftgate open because carbon monoxide
(CO) gas can come into your vehicle. You
can not see or smell CO. It can cause
unconsciousness and even death. If you
must drive with the liftgate open or if
electrical wiring or other cable
connections must pass through the seal
between the body and the liftgate:
Make sure all other windows are shut.
Turn the fan on your heating or
cooling system to its highest speed
and select the control setting that will
force outside air into your vehicle. See
Dual Climate Control System on
page 189.
If you have air outlets on or under the
instrument panel, open them all the
way. SeeEngine Exhaust on page 132.
107
Page 108 of 522
Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome by the
extreme heat and suffer permanent
injuries or even death from heat stroke.
Never leave a child, a helpless adult, or a
pet alone in a vehicle, especially with the
windows closed in warm or hot weather.
108
Page 109 of 522

Power Windows
{CAUTION:
Leaving children, helpless adults, or pets
in a vehicle with the windows closed is
dangerous. They can be overcome from
extreme heat in warm or hot weather and
suffer permanent injuries or even death
from heat stroke.
Leaving children in a vehicle with the
ignition key is dangerous for many
reasons, children or others could be badly
injured or even killed. They could operate
the power windows or other controls or
even make the vehicle move. The
windows will function with the keys in the
ignition and they could be seriously
injured or killed if caught in the path of a
closing window. Do not leave keys in a
vehicle with children.
When there are children in the rear seat
use the window lockout button to prevent
unintentional operation of the windows.The power window
switches are located on
the armrest near
each window.
Press the switch to the rst position to lower the
window to the desired level. Pull the switch
up to raise the window.
Your vehicle has Retained Accessory Power (RAP)
that allows you to use the power windows once the
ignition has been turned off. For more information,
seeRetained Accessory Power (RAP) on
page 118.
109
Page 110 of 522

Express-Down Window
This feature is on all windows. Press the switch
to the second position and release the switch
to activate the express-down feature. To stop the
window as it is lowering, press down or pull up
brie y on the switch again.
Express-Up Window
This feature is on all windows. Pull the switch up
to the second position and release the switch
to activate the express-up feature. To stop the
window as it is raising, pull up or press down
brie y on the switch again.
Programming the Power Windows
If the battery on your vehicle has been recharged,
disconnected, or is not working, you will need
to reprogram each power window for the
express-up feature to work. Before reprogramming,
you will need to replace or recharge your
vehicle’s battery.To program each window, follow these steps:
1. With the ignition in ACCESSORY, ON,
or when Retained Accessory Power (RAP)
is active, close all doors.
2. Press and hold the power window switch until
the window is fully open.
3. Pull the power window switch up until the
window is fully closed.
4. Continue pulling the switch up for
approximately two seconds after the window
is completely closed.
The window is now reprogrammed. Repeat the
process for the other windows.Express Window Anti-Pinch Feature
If any object is in the path of the window when the
express-up is active, the window will stop at the
obstruction and auto-reverse to a preset
factory position. Weather conditions such as
severe icing may also cause the window to
auto-reverse. The window will return to normal
operation once the obstruction or condition
is removed.
110
Page 111 of 522

Express Window Anti-Pinch Override
{CAUTION:
If express override is activated, the
window will not reverse automatically.
You or others could be injured and the
window could be damaged. Before you
use express override, make sure that all
people and obstructions are clear of the
window path.
In an emergency, the anti-pinch feature can be
overridden in a supervised mode. Pull the window
switch all the way up to the second position.
The window will rise for as long as the switch is
held. Once the switch is released, the express
mode is re-activated.
In this mode, the window can still close on an
object in its path. Use care when using the
override mode.
Window Lockout
o
(Window Lockout):The rear window lockout
button is located on the driver’s door armrest
near the window switches.
Press the right side of the button to disable the
rear window controls. The light on the button
will illuminate, indicating the feature is in use.
The rear windows still can be raised or lowered
using the driver’s window switches when the
lockout feature is active.
To restore power to the rear windows, press the
button again. The light on the button will go out.
111
Page 112 of 522

Sun Visors
Swing down the primary visor to block out glare.
It can also be detached from the center mount and
moved to the side to block glare from that
direction.
The driver’s sunshade may also have buttons for
a built-in garage door opener. SeeUniversal
Home Remote System (With Three Round LED)
on page 143orUniversal Home Remote
System (With One Triangular LED) on page 143
for more information.
Lighted Visor Vanity Mirror
Pull the visor down and lift the cover. The light will
automatically come on. The light will go out when
you close the cover.
Theft-Deterrent Systems
Vehicle theft is big business, especially in some
cities. Although your vehicle has a number of
theft-deterrent features, we know that nothing we
put on it can make it impossible to steal.
Theft-Deterrent System
The security light is
located on the
instrument panel cluster.
If the ignition is off and a door is open, the
security light will ash, reminding you to arm the
theft-deterrent system.
To arm the system, do the following:
1. Lock the door using the Remote Keyless
Entry (RKE) transmitter or the power door
lock switch.
2. Close all the doors. The security light will
illuminate. It should go off within approximately
30 seconds.
If a door or a liftgate is opened without a key or a
RKE transmitter, the horn will sound and the
lamps will ash for up to 30 seconds.
112