SUPPLEMENTAL RESTRAINT SYSTEM – AIRBAG SYSTEMRS–25
RS
SYSTEM DESCRIPTION
1. GENERAL
(a) In conjunction with an impact absorbing structure for
a frontal collision, the SRS (Supplemental Restraint
System) driver airbag, front passenger airbag and
driver side knee airbag were designed to
supplement seat belts in the event of a frontal
collision in order to help reduce shock to the head,
chest and knee of the driver and front passenger.
This system is a 3-sensor type airbag system to
detect the impact during a frontal collision using the
center airbag sensor and front airbag sensors. It
also operates the airbag system and seat belt
pretensioner.
(b) In order to detect the extent of the collision during
the initial stages of the collision in further detail, the
front airbag sensors have been changed from
mechanical type to electrical type deceleration
sensors. Accordingly, the deployment of the driver
airbag and front passenger airbag is controlled in
two stages according to the severity of the impact.
(c) In conjunction with an impact absorbing structure for
a side collision, the side airbag and curtain shield
airbag were designed to help reduce shock to the
driver and front passenger in the event of a side
collision.
(d) A curtain shield airbag that helps reduce shock to
the front and rear seat occupants with a single
curtain shield airbag has been adopted. In
conjunction with this system, the side airbag
sensors have been installed at the bottom of the
center pillars and rear airbag sensors have been
installed at the bottom of the rear pillars.
(e) In this system, a front side collision is detected by
the side airbag sensor in order to simultaneously
deploy the side airbag. A rear side collision is
detected by the rear airbag sensor and the center
airbag sensor in order to deploy the side airbag and
curtain shield airbag.
(f) The center airbag sensor sends the airbag
deployment signal to the ECM through the CAN
(Controller Area Network) to operate the fuel pump
control.
2. CONSTRUCTION AND OPERATION
(a) FRONT AIRBAG SENSOR
(1) The front airbag sensors are installed on the
right and left radiator supports.
(2) The front airbag sensor consists of the
deceleration sensor.
WW–34WIPER AND WASHER – WASHER MOTOR
WW
3. INSTALL WINDSHIELD WASHER JAR ASSEMBLY
(a) Install the windshield washer jar and pump with the
3 bolts.
(b) Connect the connectors.
4. FILL UP WASHER JAR AND PUMP ASSEMBLY WITH
WASHER FLUID
(a) Connect the washer hoses to the washer motor and
pump, and fill the washer jar with washer fluid.
5. INSTALL FRONT BUMPER COVER (See page ET-11)
6. INSTALL RADIATOR SUPPORT OPENING COVER
(See page ET-12)
7. INSTALL FRONT FENDER LINER LH (See page ET-
12)
8. INSTALL FRONT FENDER LINER RH (See page ET-
12)
9. INSTALL WASHER INLET SUB-ASSEMBLY
(a) Install the washer inlet of the washer jar and pump
to the windshield washer jar and pump.
(b) Install the washer inlet of the washer jar and pump
with the clip.
10. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
B133945
B133129
B133130
