2006 MERCEDES-BENZ SL600 page 1

373 Practical hints
What to do if …
Left display
Right display
Possible cause/consequence
Possible solution
F
Key
not detected
The SmartKey with KEYLESS-GO* is
not recognized while the engine is
running because:

The SmartKey with
KEYLESS-GO* is not in the vehi-
cle.


There is strong radio-frequency
interference.

Stop the vehicle as soon as it is safe to do so.

Search for the SmartKey with KEYLESS-GO*
or continue to operate the vehicle with the
SmartKey.
Otherwise the vehicle cannot be centrally
locked nor can the engine be started again af-
ter the engine is stopped.
Key
not detected
The SmartKey with KEYLESS-GO* is
not recognized when attempting to
start the engine with the
KEYLESS-GO start/stop button* on
the gear selector lever because:

The SmartKey with
KEYLESS-GO* is not in the vehi-
cle.


The battery in the SmartKey
with KEYLESS-GO* is not insert-
ed properly or completely dis-
charged.

Change the position of the SmartKey with
KEYLESS-GO* in the vehicle.

Make sure the battery in the SmartKey with
KEYLESS-GO* is properly inserted
(page 390) and is not discharged
(page 106).

Operate the vehicle with the SmartKey if
necessary.

376 Practical hintsWhat to do if …Left display
Right display
Possible cause/consequence
Possible solution
.
License plate
lamp, L
The left license plate lamp is mal-
functioning.

Replace the bulb as soon as possible.
License plate
lamp, R
The right license plate lamp is mal-
functioning.

Replace the bulb as soon as possible.
Light sensor
Drive to
workshop!
The light sensor is malfunctioning.
The headlamps switch on automati-
cally.

In the control system, set lamp operation to
manual (
page 152).

Switch on headlamps using the exterior lamp
switch.

Visit an authorized Mercedes-Benz Center as
soon as possible.
Low beam
Left
The left low beam lamp is malfunc-
tioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:

Visit an authorized Mercedes-Benz Center as
soon as possible.
Low beam
Right
The right low beam lamp is malfunc-
tioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:

Visit an authorized Mercedes-Benz Center as
soon as possible.

379 Practical hints
What to do if …
Left display
Right display
Possible cause/consequence
Possible solution
.
Turn signal
Rear right
Substitute
bulb on
The right rear turn signal lamp is
malfunctioning. A substitute bulb
has been brought into use.

Replace the bulb as soon as possible.
Visit workshop!
The display for the lights is malfunc-
tioning.

Visit an authorized Mercedes-Benz Center as
soon as possible.
C
Raise
roll-over bar
The roll bar is malfunctioning.

Raise the roll bar using the roll bar button
(page 75).

Have the roll bar checked by an authorized
Mercedes-Benz Center.
<
Seat belt system
Drive to
workshop
The seat belt system is malfunction-
ing.

Visit an authorized Mercedes-Benz Center as
soon as possible.
L
TeleAid
Drive to
workshop
One or more main functions of the
Tele Aid system are malfunctioning.

Have the Tele Aid system checked by an au-
thorized Mercedes-Benz Center.
t
Function
unavailable
This display appears if button t
or s on the multifunction steer-
ing wheel is pressed and the vehicle
is not equipped with a telephone.

380 Practical hintsWhat to do if …Left display
Right display
Possible cause/consequence
Possible solution
H
Please rectify
tire pressure
The tire inflation pressure is too
low in one or more tires.

Check and correct tire inflation pressure as required
(page 293).
Tire pressure
Caution
Tire defect
One or more tires is deflating.

Carefully bring the vehicle to a halt, avoiding abrupt
steering and braking maneuvers. Observe the traffic
situation around you.

If necessary, change the wheel (
page 399).

Vehicles with TIREFIT: Temporarily repair tire using
TIREFIT (
page 399) or contact Roadside Assistance.
If tire cannot be temporarily repaired using TIREFIT,
contact Roadside Assistance.

Have the damaged wheel repaired or replaced at an au-
thorized Mercedes-Benz Center.
Warning!
G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle. You
may lose control of the vehicle. Continued
driving with a flat tire will cause excessive
heat build-up and possibly a fire.

382 Practical hintsWhat to do if …Left display
Right display
Possible cause/consequence
Possible solution
Ê
Close
trunk lid
This message will appear whenever
the trunk lid is open.

Close the trunk lid.
M
Close
trunk partition
You are trying to open or close the
retractable hardtop even though
the luggage cover in the trunk is not
pulled out.

Pull out the luggage cover and secure it
(page 196).
W
Washer fluid
Check level
The fluid level has dropped to about 1/3 of total reservoir capacity.

Add washer fluid (
page 280).
Warning!
G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may ignite when if it comes into contact with
hot engine parts. You could be seriously
burned.

385 Practical hints
Locking/unlocking in an emergency
Locking/unlocking in an emergency
Unlocking the vehicle
If you cannot unlock the driver’s door using
the SmartKey, open the door using the me-
chanical key.
1Mechanical key locking tab
2Mechanical key

Move locking tab 1 direction of arrow
and slide the mechanical key 2 out of
the housing.Unlocking the driver’s door
1Unlocking

Unlock the door with the mechanical
key. To do so, push the mechanical key
in the lock until it stops and turn it
counterclockwise.
iUnlocking your vehicle with the me-
chanical key will trigger the anti-theft
alarm system. To cancel the alarm, do
one of the following:

Press button Œ or ‹on the
SmartKey.


Insert the SmartKey in the starter
switch.


Press the KEYLESS-GO* start/stop
button (
page 37).


Grasp the outside door handle (ve-
hicles with KEYLESS-GO* only).

386 Practical hintsLocking/unlocking in an emergencyUnlocking the trunk
A minimum height clearance of
6.2 ft (1.89 m) is required to open the
trunk lid.
If you are unable to unlock the trunk with
the SmartKey, open the trunk with the me-
chanical key.
The handle is located above the rear li-
cense plate recess.Trunk lid lock1Unlocking
2Handle

Insert the mechanical key into the
trunk lid lock.

Turn the mechanical key counterclock-
wise to position 1 and hold it in this
position.

Pull the trunk lid handle 2 and lift lid.Unlocking the glove box
Lockable storage areas in the passenger
compartment include:


the glove box


the storage compartment under the
armrest


the rear storage compartments
If these cannot be unlocked by means of
the SmartKey or the SmartKey with
KEYLESS-GO*, use the mechanical key to
unlock the glove box.
iUnlocking your vehicle with the me-
chanical key will trigger the anti-theft
alarm system. To cancel the alarm, do
one of the following:

Press button Œ or ‹ on the
SmartKey.


Insert the SmartKey in the starter
switch.


Press the KEYLESS-GO* start/stop
button (
page 37).


Grasp the outside door handle (ve-
hicles with KEYLESS-GO* only).
iTo unlock the remaining storage com-
partments, the cause for the malfunc-
tion of the SmartKey or the SmartKey
with KEYLESS-GO* must be deter-
mined and corrected, see (
page 99)
and (
page 104).

387 Practical hints
Locking/unlocking in an emergency
1Separately unlocking the glove box
Slide mechanical key out of SmartKey
housing (
page 385).

Insert the mechanical key into the
glove box lock and turn it to
position1.
Locking the vehicle
If you cannot lock the vehicle with the
SmartKey, lock it with the mechanical key
as follows:
Close the passenger door and the
trunk.

Press the central locking switch in the
center console (
page 113).

Check whether the locking knob on the
passenger door has moved down.

If necessary push it down manually.

Remove the mechanical key from of
the SmartKey (
page 385).

Check whether the trunk is locked.

If necessary, lock the trunk with the
mechanical key (
page 110).
Except for the driver’s door, the vehicle
should now be locked.
iUnlocking the glove box with the me-
chanical key will trigger the anti-theft
alarm system. To cancel the alarm, do
one of the following:

Press button Œ or ‹ on the
SmartKey.


Insert the SmartKey in the starter
switch.


Press the KEYLESS-GO* start/stop
button (
page 37).


Grasp the outside door handle (ve-
hicles with KEYLESS-GO* only).