Page 1257 of 5267
P0355-IGNITION COIL #5 PRIMARY CIRCUIT
For a complete wiring diagramRefer to Section 8W.
Page 1261 of 5267
P0420-1/1 CATALYTIC CONVERTER EFFICIENCY
For a complete wiring diagramRefer to Section 8W.
Page 1264 of 5267
P0432-2/1 CATALYTIC CONVERTER EFFICIENCY
For a complete wiring diagramRefer to Section 8W.
Page 1267 of 5267
P0441-EVAP PURGE FLOW MONITOR
For a complete wiring diagramRefer to Section 8W.
Page 1271 of 5267
P0442-EVAP LEAK MONITOR MEDIUM (0.040) LEAK DETECTED
For a complete wiring diagramRefer to Section 8W.
Page 1277 of 5267
P0443-EVAP PURGE SOLENOID CIRCUIT
For a complete wiring diagramRefer to Section 8W.
Page 1281 of 5267
P0455-EVAP LEAK MONITOR LARGE LEAK DETECTED
For a complete wiring diagramRefer to Section 8W.
Page 1287 of 5267
P0460-FUEL LEVEL SENDING UNIT NO CHANGE OVER MILES
For a complete wiring diagramRefer to Section 8W.
When Monitored:
Engine running and fuel level either below 15% or above 85% of capacity.
Set Condition:
The PCM sees low fuel, less than 15%, for more than 120 miles or fuel level does not change by at least 4%
for more than 250 miles.
Possible Causes
PHYSICALLY DAMAGED/DEFORMED/OBSTRUCTED FUEL TANK
FUEL LEVEL SENSOR
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE -
DIAGNOSIS AND TESTING)
1.CHECKING FOR A DAMAGED/DEFORMED/OBSTRUCTED FUEL TANK
Turn the ignition off.
WARNING: WARNING: The fuel system is under a constant pressure, even with the engine off. Before test-
ing or servicing any fuel system hose, fitting or line, the fuel system pressure must be released.
Inspect the outside of the fuel tank for defects.
Remove the fuel tank.
Remove the fuel pump module from the fuel tank.
Inspect the inside of the fuel tank for any obstructions or deformities.
Is the fuel tank free from defects?
Ye s>>
Go To 2
No>>
Repair or replace the fuel tank as necessary.
Perform POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
2.FUEL LEVEL SENSOR
If there are no possible causes remaining, view repair.
Repair
Replace the Fuel Level Sensor.
Perform POWERTRAIN VERIFICATION TEST. (Refer to 9 - ENGINE - STANDARD PROCEDURE)
