2006 Acura RSX Owner's Manual

Vents, Heating, and A/C
88
TEMPERATURE CONTROL DIALMODE CONTROL DIAL
REAR WINDOW DEFOGGER BUTTON
RECIRCULATION BUTTON AIR CONDITIONING BUTTON FAN CONTROL DIAL

To use the heating and cooling
system in automatic mode, set the
system as f ollows.Set the f an control dial to AUTO.
Set the mode control dial to AUTO.
Turn the temperature control dial
to the desired temperature.
Select f resh air mode by pressing
the recirculation button. The
indicator in the switch should be
off.
Turn on the A/C by pressing the
button. Pressing the A/C button turns the
air conditioning ON and OFF. The
indicator in the button comes on
when the A/C is ON.
When you turn the A/C of f , the
system cannot regulate the inside
temperature if you set the dial below
the outside air temperature.
With A/C on, use the temperature
control dial to adjust the temperature
of the air f low to a comf ortable
setting.
Air conditioning also removes mois-
ture from the air as it operates. You
can use it to def og the windows
quickly in cool or damp weather.
Used in combination with the heater,
it also makes the interior warm and
dry.
To heat or cool the interior f aster,
select recirculation mode, and set
the temperature control dial to the
upper or lower limit. The system
runs on f ull cooling or heating only.
It does not regulate the interior temperature. When the temperature
is set between the lower and upper
limits, the system regulates the
interior temperature to the set value.
TurningthefancontroldialtoOFF
shuts the heating and cooling system
completely off. Keep the system
completely of f only f or short periods.
To keep stale air and mustiness from
collecting, you should have the f an
running at all times.
You can manually set the system
controls f or ventilation, air
conditioning, heating, airf low
direction, and fan speed in various
combinations.
1.
2.
3.
4.
5.
CONT INUED
Vents, Heating, and A/C
Automatic Operation
Manual OperationA ir Condit ioning But t on
Features
89

Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge (see page) when using the A/C in heavy
traf f ic or driving up long hills. If it
moves near the red zone, turn of f the
air conditioning until the gauge
reads normally. The main air flow comes out
of the dashboard vents.
Airf low is divided between
the vents in the dashboard and the
f loor vents.
The main air f low is directed
to the floor vents.
The main air f low is divided
between the f loor vents and
defroster vents at the base of the
windshield.
The main air f low is directed
to the windshield for faster
def rosting or def ogging. To def rost
or defog, turn the temperature
control dial to maximum. Select , and set the f an speed to
high.
This button controls the source of air
going into the system. When the
indicator in this button is on, the
system is recirculating the interior
air (recirculation mode). When the
indicator is of f , f resh air is brought
in f rom outside the vehicle (f resh air
mode). Push the button to change
between recirculated and f resh air.
Use recirculation mode to heat or
cool the interior more quickly or to
keep out smoke and dust. Leaving
the system in the recirculation mode
with the A/C off can cause the
windows to f og up. Switch to f resh air mode as soon as the interior
reaches a comf ortable temperature
or the outside smoky, dusty
condition clears.
When the dial is set to AUTO, the
system controls the f an speed
automatically. You can manually select the f an
speed by turning the f an speed
control dial. Turning this dial
clockwise increases the f an speed,
which increases air flow.
In AUTO mode, the system controls
the airf low direction automatically
between the dashboard vents and
the f loor vents. Some air will come out of the side
vents in all modes. Use this dial to select the direction of
airf low coming out of the system.
58
Vents, Heating, and A/C
Recirculat ion But t on
Fan Speed
Mode Cont rol Dial
90

Theclimatecontrolsystemhastwo
sensors. A sunlight sensor is in the
top of the dashboard, and a
temperature sensor is under the
steering column. Do not cover the
sensors or spill any liquid on them.
When you select or ,
the system automatically switches to
f resh air mode and turns on the A/C.
This helps to dehumidif y the air and
def og the windshield. In either mode,
you cannot turn the A/C of f . When
you switch to another mode, the A/C
returns to its original setting, either
on or of f , as displayed by the A/C
indicator light.
To def rost the windows quickly,
select and , and turn
the f an and temperature controls to
the maximum level.
Continuous use of the recirculation
mode can cause humidity to build up
inside the vehicle.
Once the windshield is clear, select
f resh air mode to avoid f ogging the
windows. Sunlight and T emperature
Sensors
Climat e Cont rol Sensors
Features
91
SUNLIGHT SENSOR
TEMPERTURE SENSOR

Some models may have one of the
audio systems described in this
section. Read the appropriate pages
in this section f or operation of the
audio systems installed in your
vehicle.
If your vehicle has a dif f erent audio
system f rom these two types, read
the radio manuf acturer’s manual that
came with your vehicle f or its
operation.page to f or all models
except Type-S
page to f or Type-S
93
120
105
106
Audio System
92
All models except Type-S
Type-S model

Playing the Radio
Features
93
AM/FM BUTTONPRESET BUTTONS
STEREO INDICATOR
SCAN INDICATOR
SCAN BUTTON
SEEK/SKIP BAR
POWER/VOLUME KNOB TUNE/MODE KNOBAUTO SELECT
BUTTON
All models except Type-S

µµ
µ
You can use these five methods to
f ind radio stations on a selected
band: the
preset buttons, and .Use the TUNE knob to
tune the radio to a desired f requency.
Turn the knob right to tune to a
higher f requency, or lef t to tune to a
lower f requency. The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see SCAN in
the display. The system will scan f or
a station with a strong signal. When
it f inds one, it will stop and play that
station f or about 5 seconds. If you do
nothing, the system will then scan
f or the next strong station and play it
for 5 seconds. When it plays a station
that you want to listen to, press the
SCAN button again.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction on
AM is not available. The SEEK f unction
searches up and down from the
current f requency to f ind a station
with a strong signal. To activate it,
press either ( or ), then
release it.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pressing the
PWR/VOL knob, or the AM/FM
button. Adjust the volume by turning
the knob. To Play the Radio
To Select a Station
TUNE,SEEK,SCAN, AUTO SELECT TUNE
SCAN
SEEK
Playing the Radio
94

µµEach preset button can
store one f requency on AM and two
f requencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two f requencies with each preset
button.
UsetheTUNE,SEEK,orSCAN
function to tune the radio to a
desired station.
Pick a preset button, and hold it
until you hear a beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
The preset f requencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio f use is
removed. If you are
traveling far from home and can no
longer receive the stations you
preset, you can use the auto select
feature to find stations in the local
area.
Press the A. SEL button. ‘‘A.SEL’’
will f lash in the display, and the
system will go into scan mode f or
several seconds. It stores the
f requencies of six AM stations and
twelve FM stations in the preset
buttons. If you do not like the stations auto
select has stored, you can store
other f requencies on the preset
buttons. Use the TUNE, SEEK, or
SCAN f unction to f ind stations, then
store them in the preset buttons as
described previously.
press the
A. SEL button. This restores the
presets you originally set.
You will see a ‘‘0’’ displayed af ter
pressing a preset button if auto
select cannot f ind a strong station f or
every preset button.
1.
2.
3.
4.
To turn of f auto select,
CONT INUED
Preset
A UT O SEL ECT
Playing the Radio
Features
95