2005 NISSAN X-TRAIL key

DI-2 Wiring Diagram — AT/IND —/LHD Models ............ 53
Wiring Diagram — AT/IND —/RHD Models ............ 54
A/T Indicator Does Not Illuminate ........................... 55
WARNING CHIME ..................................................... 56
System Description ................................................. 56
POWER SUPPLY AND GROUND CIRCUIT ....... 56
LIGHT WARNING CHIME ................................... 56
SEAT BELT WARNING CHIME ........................... 56
KEY REMINDER WARNING CHIME [FOR RHD MODELS] ............................................................. 56
Wiring Diagram — CHIME —/LHD Models ............. 57
Wiring Diagram — CHIME —/RHD Models ............ 58
Symptom Chart ....................................................... 60
Power Supply and Ground Circuit Inspection ......... 60
Front Door Switch (Driver Side) Inspection ............. 61
Lighting Switch Input Signal Inspection .................. 62
CLOCK ...................................................................... 63
Wiring Diagram — CLOCK — ................................. 63

DI-56
WARNING CHIME

WARNING CHIMEPFP:24814
System DescriptionEKS002XF
POWER SUPPLY AND GROUND CIRCUIT
Power is supplied at all times

to combination switch terminal 11 and

to daytime light control unit terminal 1 (with daytime light system)

through 10A fuse (No. 31, located in fuse and fusible link box), and

to key switch terminal 1 (RHD models) and

to time control unit terminal 1

through 10A fuse [No. 28, located in the fuse block (J/B)].
With ignition switch in ON or START position, power is supplied

to time control unit terminal 17

through 10A fuse [No. 5, located in the fuse block (J/B)].
Ground is supplied

to time control unit terminal 16

through grounds M27 and M70.
LIGHT WARNING CHIME
With ignition switch OFF position, driver's door open, and lighting switch in 1ST or 2ND position, warning
chime will sound.
Power is supplied

from the lighting switch terminal 12 or daytime light control unit terminal 11 (with daytime light system)

to time control unit terminal 19.
Ground is supplied

to time control unit terminal 30

through front door switch (driver side) terminal 2.
Front door switch (driver side) terminal 3 is grounded through grounds B8 and B18.
SEAT BELT WARNING CHIME
When the vehicle speed exceeds 25 km/h (16 MPH) with driver or passenger seat belt unfastened (seat belt
switch ON), warning chime will sound. Refer to SB-6, "
SEAT BELT WARNING SYSTEM" .
KEY REMINDER WARNING CHIME [FOR RHD MODELS]
Key reminder chime will sound, at the same time, key reminder system will start operating.
When the following three conditions are simultaneously met.

Key is inserted in the ignition key cylinder.

Driver's door is opened.

The setting of driver's door lock knob is “LOCK”.
For information regarding key reminder system, refer to BL-43, "
Key reminder system" in BL section.

DI-60
WARNING CHIME

Symptom ChartEKS002XQ
Power Supply and Ground Circuit InspectionEKS002YF
1. CHECK FUSES
Check for blown time control unit fuses.
OK or NG
OK >> GO TO 2.
NG >> Be sure to eliminate cause of malfunction before installing new fuse. Refer to PG-79, "
FUSE
BLOCK - JUNCTION BOX (J/B)" .
2. CHECK POWER SUPPLY CIRCUIT
Check voltage between time control unit connector and ground.
OK or NG
OK >> GO TO 3.
NG >> Repair harness or connector.
3. CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect time control unit connection.
3. Check continuity between time control unit harness connector
M30 terminal 16 (B/R) and ground.
OK or NG
OK >> INSPECTION END
NG >> Repair harness or connector.
Symptom Diagnosis/Service procedure
Light warning chime does not activate.Perform the following inspections.
1.DI-60, "
Power Supply and Ground Circuit Inspection"
2.DI-61, "Front Door Switch (Driver Side) Inspection"
3.DI-62, "Lighting Switch Input Signal Inspection"
Replace time control unit, found normal function in the above inspections.
Key reminder warning chime does not activate. Perform key reminder system trouble diagnosis.
Refer to BL-54, "
SYMPTOM CHART" .
Seat belt warning chime does not activate.Perform seat belt warning system trouble diagnosis.
Refer to SB-16, "
Trouble Diagnosis Chart by Symptom" .
Unit Power source Fuse No.
Time control unitBattery 28 (10A)
Ignition switch (ON) 5 (10A)
Terminals Ignition switch position
(+)
(–) OFF ON
Connector Terminal (Wire color)
M30 1 (L) Ground Battery voltage Battery voltage
M31 17 (G) Ground 0 V Battery voltage
SKIA9645E
Continuity should exist.
PKIC0614E

MA-4
DESCRIPTION

DESCRIPTIONPFP:00000
Pre-Delivery Inspection ItemsELS000Y5
Shown below are Pre-delivery Inspection Items required for the new vehicle. It is recommended that
necessary items other than those listed here be added, paying due regard to the conditions in each
country.
Perform applicable items on each model. Consult text of this section for specifications.
Install vehicle protection kit
Fit all accessories ordered (if applicable) (e.g. towbar, audio, navigation, air conditioner, styling kit)
UNDER HOOD — engine off
Check coolant level and cooling system for leaks
Charge battery and check terminals for condition
Check drive belts tension (diesel only)
Check fuel filter for water or dust (diesel only) and fuel system for leaks
Check engine oil level and for oil leaks
Check brake and clutch fluid levels and fluid lines for leaks
Check and top up washer reservoirs
Check power steering fluid level and fluid lines for leaks (if applicable)
Check air conditioning system for gas leaks (if applicable)
ON INSIDE AND OUTSIDE
Install transit fuse if removed for vehicle storage
Check instruments, gauges, lamps, horn and accessories for operation
Check wipers and washers for operation and adjustment
Check interior and door mirrors and sun visors for operation
Set radio code and set clock
Check parking brake adjustment
Check clutch pedal adjustment
Check steering lock operation
Check seat adjusters and seat belts for operation
Check all windows for operation and alignment
Check mouldings, trim and fittings for fit and alignment
Check weatherstrips for fit and adhesion
Check hood, trunk lid, door panels and fuel lid for fit and alignment
Check latches, keys, remote key, door locks and remote trunk lid and fuel lid release for operation
Check wheel nut torques
Check tyre pressure (incl. spare tyre)
Check tool kit and jack for operation
Check automatic transmission/transaxle starter inhibitor (if applicable)
Check sunroof for operation and alignment (if applicable)
UNDER BODY
Check manual transmission/transaxle, differential and transfer box for oil level and oil leaks
Tighten bolts and nuts steering linkage and gear box, axle/suspension parts, propeller and exhaust system
Check brake and clutch lines, and oil/fluid reservoirs for leaks
Remove front suspension spacer blocks (if applicable)
Check body mounting torque (if applicable)

IDX-6
ALPHABETICAL INDEX
INJE/PW - Wiring diagram ............. EC-1294, EC-1632
INJECT - Wiring diagram . EC-452, EC-892, EC-1120,
EC-1259
, EC-1298, EC-1476, EC-1598, EC-1636
Injection nozzle(YD22DDTi) ........................... EM-167
Injector ............................................... EC-451, EC-891
Input shaft (FF M/T) .............................. MT-23, MT-41
Intake air temperature sensor ........... EC-159, EC-856,
EC-1088
, EC-1443
Intake door control linkage adjustment ............ ATC-81
Intake door motor ATC-79, ATC-128, MTC-11, MTC-26
Intake manifold(QR20DE-QR25DE) ................. EM-18
Intake manifold(YD22DDTi) ............................ EM-146
Intake sensor ................................................. ATC-117
Intake valve timing control ................. EC-136, EC-636
Intake valve timing control solenoid valve ....... EC-290
Interior ....................... EI-32, EI-34, EI-35, EI-38, EI-39
Interior lamp ...................................................... LT-132
Interior lamp on-off control .................. LT-132, LT-133
ISO 15031-5 Mode 1 - 9 ...................... EC-52, EC-996
IVC - Wiring diagram ....................................... EC-291
J
Joint connector (J/C) .......................................... PG-79
K
Keyless entry system - See Multi-remote control system
BL-74
Knock sensor (KS) ............................. EC-245, EC-688
KS - Wiring diagram ........................... EC-246, EC-689
L
LAN system circuit ........................................... ATC-69
License lamp ..................................................... LT-103
Line pressure test (A/T) ....................... AT-68, AT-260
Liquid gasket application ......................... LU-3, LU-17
Liquid gasket application(QR20DE-QR25DE) ... EM-6,
CO-3
Liquid gasket application(YD22DDTi) . EM-131, CO-26
LOAD - Wiring diagram ...................... EC-481, EC-921
Location of electrical units ................................. PG-69
Lock, door ............................................... BL-91, BL-95
Lubricant (R134a) A/C ........................ ATC-5, ATC-24
Lubrication circuit (engine)(QR20DE-QR25DE) .. LU-5
Lubrication circuit (engine)(YD22DDTi) ............. LU-19
Lubrication oil A/C .......................................... ATC-164
Lubrication-locks, hinges and hood latches ...... MA-46
M
M/T major overhaul ............................... MT-22
, MT-40
M/T removal and installation .............................. MT-19
MAFS - Wiring diagram ... EC-153, EC-646, EC-1077,
EC-1084
, EC-1439
Magnet clutch ................................. ATC-88, ATC-146
MAIN - Wiring diagram .... EC-125, EC-625, EC-1046,
EC-1415
Mainshaft (M/T) ..................................... MT-23, MT-41
Maintenance (engine)(YD22DDTi) ................... MA-29
Major overhaul (Transfer) .................................. TF-59
Malfunction indicator (MI) .. EC-64, EC-568, EC-1001,
EC-1373
Mass air flow sensor (MAFS) ........... EC-151, EC-644,
EC-1075
, EC-1083, EC-1438
Master cylinder (brake) ...................................... BR-14
Master cylinder (clutch) ........................................ CL-9
Meter ..................................................................... DI-4
METER - Wiring diagram ......................... DI-16, DI-19
MIL/DL - Wiring diagram ............... EC-1348, EC-1699
MIRROR - Wiring diagram ............................... GW-87
Mirror defogger ................................................ GW-21
Mirror, door ...................................................... GW-86
Mirror, out side ................................................. GW-86
Misfire .............................................................. EC-239
Mode door control linkage adjustment ........... ATC-75,
ATC-134
, MTC-9, MTC-31
Mode door motor ............................ ATC-73, ATC-134
Molding - See Exterior ................... EI-22, EI-24, EI-25
Mud guard - See Exterior .................................... EI-24
MULTI - Wiring diagram ..................................... BL-77
Multiport fuel injection (MFI) system ... EC-35, EC-548
Multiport fuel injection precautions ....................... GI-6
Multi-remote control system ............................... BL-74
N
NATS - Wiring diagram .................................... BL-111
NATS (Nissan anti-theft system) ..................... BL-108
NATS (Nissan anti-theft system) precautions ....... GI-3
NVH troubleshooting (BR) ................................... BR-5
NVH troubleshooting (Transfer) ........................... TF-9
O
Oil cooler (engine)(QR20DE-QR25DE) ............. LU-11
Oil cooler (engine)(YD22DDTi) .......................... LU-28
Oil filter(QR20DE-QR25DE) .............................. LU-10
Oil filter(YD22DDTi) ........................................... LU-23
Oil pan (engine)(QR20DE-QR25DE) ................ EM-27
Oil pan (engine)(YD22DDTi) ........................... EM-157
Oil pressure (engine)(QR20DE-QR25DE) ........... LU-7
Oil pressure (engine)(YD22DDTi) ...................... LU-20
Oil pump (engine)(QR20DE-QR25DE) .............. LU-13
Oil pump (engine)(YD22DDTi) ........................... LU-30
Oil seal replacement (engine)(QR20DE-QR25DE) .......
EM-46
, EM-70, EM-89
On board diagnostic system . EC-52, EC-565, EC-996
Operating cylinder (clutch) ................................. CL-12
Out side mirror ................................................. GW-86
Overdrive control switch .................... AT-240, AT-327
Overheat ........... EC-352, EC-755, EC-1124, EC-1480
Oversize piston(QR20DE-QR25DE) ............... EM-112
Oversize piston(YD22DDTi) ........................... EM-250