2005 MITSUBISHI 380 Interior

FRONT SEAT TRIM COVER
INTERIOR52A-44
FITMENT
.
1. Locate the new trim onto the pad by aligning the Velcro strip
with the grooves. Use an intersection in order to align both
directions. Whenever possible work from the centre of the
trim toward the outside.
2. Push the Velcro strips into place along all the grooves.

FRONT SEAT TRIM COVER
INTERIOR52A-45
3. Pull the cover over the outside of the pad and reattach the
retaining clips where required.
NOTE: It may be necessary to make some adjustment and
work the cover into position to remove creases. Reassemble
seat and fit to vehicle.

REAR SEAT CUSHION TRIM COVER
INTERIOR52A-46
REAR SEAT CUSHION TRIM COVER
REMOVAL AND FITMENT
REAR SEAT CUSHION TRIM REMOVAL
.
1. Remove rear seat cushion from vehicle.
2. Release the trim cover draw string.
3. Release all outer cover attachment points.
4. Peel cover away from the foam pad.
NOTE: Place a finger on the Blue Velcro strip when peeling
the cover to prevent the strip being pulled out of the foam
pad.

REAR SEAT CUSHION TRIM COVER
INTERIOR52A-47
REAR SEAT CUSHION TRIM FITMENT
.
1. Locate the new trim onto the pad by aligning the Velcro strip
with the grooves. Use an intersection in order toalign both
directions. Whenever possible work from the centre of the
trim toward the outside.
2. Pull the cover around the sides of the pad.
3. Pull trim through the seat belt slots as shown and attach to
wires

REAR SEAT CUSHION TRIM COVER
INTERIOR52A-48
4. Pull draw string and attach to the centre wire as shown.
5. Reattach all outer points.
6. Work the trim into all the grooves and adjust if necessary to
remove creases as shown.

REAR SEAT BACK TRIM COVER
INTERIOR52A-49
REAR SEAT BACK TRIM COVER
REMOVAL AND FITMENT
REAR SEAT BACK TRIM REMOVAL
.
1. Remove rear seat back from the vehicle, and remove arm
rest and arm rest pivot bushes from rear seat back.
2. Release the draw string.
3. Release all outer attachment points. Release all the centre
clips.

REAR SEAT BACK TRIM COVER
INTERIOR52A-50
4. Peel cover away from the foam pad.
NOTE: Place a finger on the Blue Velcro strip when peeling
the cover to prevent the strip being pulled out of the foam
pad.

REAR SEAT BACK TRIM COVER
INTERIOR52A-51
REAR SEAT BACK TRIM FITMENT
.
1. Fit the trim over the lower wire brackets.
2. Locate the new trim onto the pad by aligning the Velcro strip
with the grooves. Use an intersection in order to align both
directions. Whenever possible work from the centre of the
trim toward the outside.
3. When all the grooves are aligned pull the cover over the
pad.