Page 916 of 969

BATTERY MAINTENANCE FOR IN±STOCK VEHICLES & PRE±DELIVERY ± PG009-02 September 12, 2002
Page 3 of 4
5. Read STATE OF CHARGE and
BATTERY CONDITION.
a. If battery is at 75% STATE OF
CHARGE or greater, release
vehicle to new owner.
b. If battery is less than 75%
STATE OF CHARGE proceed
to Battery Service Procedure.
Follow the procedures below according to the BATTERY CONDITION results.
BATTERY CONDITION: ªGood return to serviceº (less than 75% State of Charge)
Charge battery using one of the recommended chargers indicated above (or equivalent)
following the Quick Charge instructions accompanying that machine.
BATTERY CONDITION: ªCharge and return to serviceº
Charge battery using one of the recommended chargers indicated above (or equivalent)
following the Quick Charge instructions accompanying that machine.
BATTERY CONDITION: ªCharge and retestº
The battery must be Quick Charged and retested using the After charge test mode.
Carry out the service according to the result of the retest.
BATTERY CONDITION: ªReplaceº
The battery must be replaced. Press the STK#/CODE key to show the warranty code for
the repair order and for the Warranty Battery Label.
If a vehicle battery needs to be replaced
for a warrantable condition, make sure to
complete a Warranty Battery Label and
affix it to the failed battery for proper
warranty parts and claim processing.
Please include the Vehicle
Identification Number and warranty
code on the Warranty Battery Label.Inspection
Procedure
(Continued)
Battery
Service
Procedure
Battery
Replacement
Repair Order No.
Repair Date
Failure Code
WARRANTY BATTERY LABEL
ETIQUETA PARA BATERIA DE GARANTIA
Dealer Code
Veh. Date of First Use
Fecha de Primer
Uso del Veh.Original Install Date
Fecha
(Svc. part replacement only/
solamente para el reemplazo
de partes de servicio)Battery Mos. In Svc.
N–mero de meses que
Bater‹a est€ en servicio
00404±BTTRY±LABEL (Please Print / Ll‡nese con Letra de Molde Por Favor)
Vehicle Identification Number (VIN)
(NIV)
08/02
Page 918 of 969
Lexus Supports ASE CertificationPage 1 of 6
Title:
FAILURE TO INITIALIZE CAN
INTERFACE MODULE
Models:
'04 ± '05 Applicable Models
Technical Service
Information Bulletin
March 11, 2005
SS001-05
TSIB REVISION NOTICE:
June 23, 2005: The ªRequired SSTsº section has been updated.
The previous TSIB should be discarded.
If the Diagnostic Tester fails to initialize CAN±based communication with on±board
vehicle controllers, a damaged cable or inoperative CAN Interface Module may be at
fault. This bulletin provides test procedures to check the integrity of the Diagnostic Tester
cables and the CAN Interface Module.
2004 ± 2005 model year CAN±equipped vehicles including 2004 model year LS 430
and 2005 model year GX 470 and LS 430.
OP CODEDESCRIPTIONTIMEOFPT1T2
N/ANot Applicable to Warranty±±±±
SPECIAL SERVICE TOOLS
Introduction
Applicable
Vehicles
Warranty
Information
Page 919 of 969
FAILURE TO INITIALIZE CAN INTERFACE MODULE ± SS001-05 Revised March 11, 2005
Page 2 of 6
ITEM
NO.SPECIAL SERVICE TOOLS (SSTs)PART NUMBERQTYDRW**
1Diagnostic Tool Set*LEX22003618
COMPONENT(S) OF KIT/SET Tester
(P/N 02002019)
14/26 Pin DLC Cable
(P/N 02001637) 12 Megabyte Program Card Kit
(P/N 01002593±005) with version 12.2a Software
(or later)
14 Pin DLC Self Test Adapter
(P/N 02001607)
Four (4) components from this kit/set are required:
2CAN Module Kit*0100274418
COMPONENT(S)
OF KIT/SETNOTE:
All components from this kit/set are required
Module box cannot be ordered separately
J1962 OBD2±II (CAN DLC)
(P/N 02003180)
* Essential SSTs.
** Refers to drawer number in SST Storage System.
NOTE:
Additional Diagnostic Tool Sets, CAN Module Kits, Program Cards, or other SSTs may
be ordered by calling SPX/OTC at 1-800-933-8335. Required
SSTs
Page 924 of 969

Page 1 of 6Lexus Supports ASE Certification
Title:
IMMOBILIZER KEY CODE RESET
Models:
Applicable ES 300, GS 430, GS 300,
IS 300, & LX 470
Technical Service
Information Bulletin
August 26, 2002
SS002-01
TSIB REVISION NOTICE:
August 26, 2005: The model years for each model have been specifically defined in
the ªApplicable Vehiclesº section. The ªRequired SSTsº section has been updated.
February 11, 2003: Model years for LX 470 revised to apply to 2001 and 2002 only.
August 26, 2002: ES 300, GS 300, and IS 300 models added. Model years for GS 430
and LX 470 vehicles expanded to include 2002 and later. Diagnostic Tester software
in Required Tools & Material updated to version 9.01a (or later).
Previous versions of this TSIB should be discarded.
Immobilizer Reset is a new feature that allows the registration of a new Master Key even
if all original Master Keys are lost. Once the Immobilizer system is reset, all previously
registered keys will be erased.
MODEL YEARMODELENGINE MODEL
2001 ± 2005*GS 4303UZ±FE
2001 ± 2002*LX 4702UZ±FE
2002 ± 2003*ES 3001MZ±FE
2002 ± 2005*GS 3002JZ±GE
2002 & Later*IS 3002JZ±GE
* Immobilizer Key Code Reset procedure is not available for prior model years.
NOTE:
Refer to TIS (Technical Information System) for the most current applicable
vehicle information.
PREVIOUS PART NUMBERCURRENT PART NUMBERPART NAME
N/AModel SpecificReplacement Key (Master or Sub)
OP CODEDESCRIPTIONTIMEOFPT1T2
N/ANot Applicable to Warranty ±±±±
SPECIAL SERVICE TOOLS
Introduction
Applicable
Vehicles
Parts
Information
Warranty
Information
Page 925 of 969