2004 YAMAHA YZF-R1S diagram

2-30
LUBRICATION DIAGRAMSSPEC
1Intake camshaft
2Exhaust camshaft
3Oil filter cartridge
4Oil level switch
EAS00034
LUBRICATION DIAGRAMS
ProCarManuals.com

2-31
1Intake camshaft
2Exhaust camshaft
3Crankshaft
4Oil cooler
5Oil pipe
6Oil strainer
7Oil pump
8Relief valve
LUBRICATION DIAGRAMSSPEC
ProCarManuals.com

2-32
1Oil cooler
2Oil filter cartridge
3Oil level switch
4Oil strainer
5Oil pump
6Oil pipe
LUBRICATION DIAGRAMSSPEC
ProCarManuals.com

2-33
1Main axle
2Oil delivery pipe
3Drive axle
LUBRICATION DIAGRAMSSPEC
ProCarManuals.com

2-34
1Cylinder head
2Crankshaft
LUBRICATION DIAGRAMSSPEC
ProCarManuals.com

2-44
K Pass the water hose lower side
of the thermostat, and between
the ground lead and the neutral
switch.
L Install the leads so that the en-
gine ground lead is positioned
lower and the battery negative
lead to be upper. Install the pro-
trusion of each lead to be above
the vehicle.
M Route the crankshaft position
sensor lead under the wire har-
ness.
N To the fuel pump
O Clamp the wire harness winding
in and insert it to the frame hole.A Pass the wire harness through
the clamp inserted to the radiator
stay.
B To the headlight lead
C Clamp the lead between three
protrusions of the pipe (the first
and second parts from the ve-
hicle front). Point the tip of the
clamp (excessive part) to the in-
side of the vehicle.
D To the vehicle right side diagram
E To the engine
F Clamp the lead between three
protrusions of the pipe (the in-
side and outside of the vehicle).G Point the tip of the clamp (exces-
sive part) to the inside of the ve-
hicle.
H All hoses and leads should be
routed over the vehicle’s upper
side above the heat protector.
I To the starter motor
J Fasten the wire harness, clank
shaft position sensor lead, rear
brake light switch lead and
speed sensor lead with a clamp.
Then, point the tip of the clamp
(cut the tip of the clamp leaving 2
to 4 mm (0.08 to 0.16 in).) to the
inside of the vehicle.
CABLE ROUTINGSPEC
ProCarManuals.com

7-2
FUEL INJECTION SYSTEMFI
7
WIRING DIAGRAM
ProCarManuals.com

7-47
AIR INDUCTION SYSTEMFI
A To cylinder #1 and #2
B To cylinder #3 and #41 Air cut-off valve
2 Plate
3 Reed valve assembly
4 Reed valve cap
5 To air filter case
EAS00509
AIR INDUCTION SYSTEM DIAGRAMS
ProCarManuals.com