2004 MITSUBISHI ENDEAVOR charging

Fig. 10: Locating Soldered Wires

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
ROTOR 1. Check the continuity between the slip rings of the field coil. If the resistance
value is not within 2-5ohm, replace the rotor. See Fig. 11
.
2. Check the continuity between the slip ring and the core. If there is continuity,
re
place the rotor. See Fig. 12
.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 11: Checking Continuity Between Slip Rings & Field Coil

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 12: Checking Continuity Between Slip Ring & Core

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
RECTIFIER 1. Check the continuity between the positive rectifier and the stator coil lead
connection terminal with a tester. If there is continuity between the terminals,
the diode is shorted, so replace the rectifier. See Fig. 13
.
2. Check the continuity between the negative rectifier and the stator coil lead
connection terminal with a tester. If there is continuity between the terminals,
the diode is grounded, so replace the rectifier. See Fig. 14 .
3. Check the continuity of the 3 diodes by connecting an ohmmeter to both ends
of each diode. If there is continuity between the directions, or if there is no
continuit
y, the diode is dama
ged, so re
place the rectifier. See Fi
g. 15
.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 13: Checking Continuity Between Positive Rectifier & Stator Coil

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 14: Checking Continuity Between Negative Rectifier & Stator Coil

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 15: Checking Continuity Of Three Diodes

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STATOR 1. Check the continuity between the coil lead. If there is no continuity, replace the
stator. See Fig. 16
.
2. Check the continuity between the coil and the core. If there is continuity
re
place the stator. See Fig. 16
.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor

Fig. 16: Testing Stator

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
REMOVAL & INSTALLATION GENERATOR For
generator removal and installation
procedures, see Fig. 17
.

2004 Mitsubishi Endeavor Limited
2004 STARTING & CHARGING SYSTEMS Generators & Regulators - Endeavor