2004 MITSUBISHI ENDEAVOR steering wheel

1. Align the mating marks of the clock spring.
Fig. 253: Aligning Mating Marks Of Clock Spring

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Turn the clock spring clockwise fully. Then turn it back approximately 3-
3/4 turns counterclockwise to align the mating marks.
2. Turn the front wheels to the straigh
t-ahead position. Then install the clock WARNING:Ensure that the clock spring's mating marks are
properly aligned. If not, the steering wheel may not
rotate completely during a turn, or the flat cable in
the clock spring could be damaged, This would
prevent normal SRS operation and possibly cause
serious injury to the driver.

2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor

spring to the column switch.
2. Align the mating marks of the steering wheel sensor as follows.
Fig. 254: Connecting Steering Wheel Sensor Connector

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Turn the steering wheel sensor clockwise fully. Then turn it back
approximately 2-3/4 turns counterclockwise to align the mating marks.
2. Ali
gn the matin
g marks on the clock s
prin
g and the steerin
g wheel sensor, CAUTION: Ensure that the steering wheel sensor's mating
marks are properly aligned. If not, the steering
wheel sensor could be damaged.

2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor

and install the steering wheel sensor to the column switch assembly.
3. Connect the steering wheel sensor connector.
SPECIFICATIONS FASTENER TIGHTENING SPECIFICATION FASTENER TIGHTENING SPECIFICATION SERVICE SPECIFICATIONS SERVICE SPECIFICATION ITEM
SPECIFICATION
Brake tube flare nut
15 +/- 2 N.m (12 +/- 1 ft-lb)
ITEM
STANDARD VALUE
Wheel speed sensor internal resistance kohm
1.24 - 1.64

2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor