2004 MITSUBISHI ENDEAVOR engine oil

Fig. 48: Applying Engine Oil To Camshaft Oil Seal Lip (Right Bank)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Use special tools MD998713 and MB991559 to press-fit the camshaft oil seal.
>>B<< CAMSHAFT SPROCKET INSTALLATION 1. Use special tools MD998715 and MB990767 in the same way as during
removal to install the camshaft sprocket.
2. Tighten the camshaft sprocket mounting bolt to the specified torque.
Tightening torque: 88+/-10 N.m (65+/-7 ft-lb)
2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 50: Removing/Installing Camshaft And Valve Stem Seal (Left Bank)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Required Special Tools:
MB990767: End Yoke Holder MD998443: Auto-lash Adjuster Holder MB991559: Camshaft Oil Seal Adapter Installer MD998713: Camshaft Oil Seal Installer MD998715: Crankshaft Pulley Holder Pin MD998772: Valve Spring Compressor MD998774: Valve Stem Seal Installer
< RIGHT BANK >
2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Required Special Tools:
MB990767: End Yoke Holder MD998443: Auto-lash Adjuster Holder MB991559: Camshaft Oil Seal Adapter Installer MD998713: Camshaft Oil Seal Installer MD998715: Crankshaft Pulley Holder Pin MD998772: Valve Spring Compressor MD998774: Valve Stem Seal Installer
REMOVAL SERVICE POINTS << A >>ROCKER ARM AND SHAFT ASSEMBLY REMOVAL 1. Install special tool MD998443 as shown in the illustration so that the lash
adjusters will not fall out.
CAUTION: Never disassemble the rocker arm and shaft
assembly.

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 53: Removing Camshaft Sprocket

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
<< C >>CAMSHAFT OIL SEAL REMOVAL 1. Make a notch in the oil seal lip section with a knife, etc.
CAUTION: Be careful not to dama
ge the camshaft and the

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 54: Removing Camshaft Oil Seal

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Cover the end of a flat-tipped screwdriver with a shop towel and insert into the
notched section of the oil seal, and pry out the oil seal to remove it.
<< D >> VALVE SPRING RETAINER LOCK REMOVAL Use special tool MD998772 to compress the valve spring, and remove the valve
sprin
g retainer locks.
cylinder head.
CAUTION: When removing valve spring retainer locks, leave the
piston of each cylinder in the TDC (Top Dead Center)
position. The valve may fall into the cylinder if the
piston is not properly in the TDC position.

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 57: Identifying Installation Position Of Valve Spring Compressor Special Tool

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
INSTALLATION SERVICE POINTS >>A<< VALVE STEM SEAL INSTALLATION 1. Apply a small amount of engine oil to the valve stem seal.
2. Use special tool MD998774 to fill a new valve stem seal in the valve guide
using the valve stem area as a guide. NOTE: Installation position of valve sprin
g compressor special tool
(MD998772) is different between exhaust side and intake
side.
CAUTION:
Valve stem seals cannot be reused. Special tool MD998774 must be used to
install the valve stem seal. Improper
installation could result in oil leaking past the
valve guide.

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 63: Checking Notches In Each Rocker Shaft Are Facing Directio
n
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
>>E<< CAMSHAFT OIL SEAL INSTALLATION 1. Apply engine oil to the camshaft oil seal lip.
Fig. 64: Identifying Installation Of Camshaft Oil Seal (Left Bank)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor

Fig. 65: Identifying Installation Of Camshaft Oil Seal (Right Bank)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Use special tools MD998713 and MB991559 to press-fit the camshaft oil seal.
>>F<< CAMSHAFT SPROCKET INSTALLATION 1. Use special tools MD998715 and MB990767 in the same way as during
removal to install the camshaft s
procket.

2004 Mitsubishi Endeavor Limited
2004 ENGINE Engine - Endeavor