Fig. 144: Installing Input Shaft Speed Sensor And Output Shaft Speed Sensor
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
104. Press Face "A" of the air breather to be even with Face "B" of the transmission
case as shown in the drawing. 105. Apply ATF on the both sides of the new gasket and threads of the eyebolts, and
then tighten to the specified torque.
Tightening torque: 24 +/- 3 N.m (18 +/- 2 ft-lb) 106. Tighten the oil cooler feed pipe clamp bolt to the specified torque.
Tightening torque: 11 +/- 1 N.m (95 +/- 8 in-lb) 107. Install the oil di
pstick.
2004 Mitsubishi Endeavor XLS
2004 TRANSMISSION Automatic Transaxle Overhaul - Endeavor
108. Install the cable support bracket.
Tightening torque: 23 +/- 3 N.m (17 +/- 2 ft-lb) 109. Install the roll stopper brackets.
Tightening torque: 70 +/- 10 N.m (51 +/- 7 ft-lb)
Fig. 145: Identifying Air Breather
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
110. Install the torque converter, and secure it so that the shown dimension "A"
meets the reference value.
CAUTION: Apply ATF to the oil pump drive hub before
installing the torque converter. Be careful not to
damage the oil seal lip when installing the torque
converter.
2004 Mitsubishi Endeavor XLS
2004 TRANSMISSION Automatic Transaxle Overhaul - Endeavor
