2004 MITSUBISHI ENDEAVOR Transmission fluid

[x] Cancel search: Transmission fluid

Page 470 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual 1. Remove the transfer and O-ring < W4A5A >  
2. Use a dial gauge to measure the input shaft end play.  
3. Remove the torque converter.  
4. Remove each bracket.  
5. Remove the dipstick.  
6. Remove

Page 475 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 18: Identifying Manual Control Shaft Detent
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
12. Disconnect the solenoid valve harness from the valve by undoing the fluid 
tem
perature sensor an

Page 590 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual Fig. 136: Installing Valve Body Mounting Bolts
 
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA. 
96. Attach the solenoid valve harness to the valve body by connecting the fluid 
tem
perature sensor an

Page 1097 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual SOLENOIDS & SOLENOID VALVES SOLENOIDS & SOLENOID VALVES LOCATION Photo Sensor
Top front center of dash.Fig. 58
 .
Right Bank Heated Oxygen Sensor 
(Front)
On inlet of right catalytic 
converter.Fig. 4

Page 1098 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual SWITCHES SWITCHES LOCATION MISCELLANEOUS MISCELLANEOUS LOCATION Low & Reverse Solenoid Valve
In transaxle. See Fig. 74
 .
Overdrive Solenoid Valve
In transaxle.Fig. 74
 .
Second Solenoid Valve
In tran

Page 1915 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual AXLE SHAFTS Removal & Installation For removal and installation of axle shafts, see Fig. 4
 .  NOTE: Before removing axle shaft, remove front cover and side 
under cover, and drain automatic transmiss

Page 3717 of 3870

MITSUBISHI ENDEAVOR 2004  Service Repair Manual 2004 Mitsubishi ENDEAVOR 04 - Electrical Equipment > EQUIPMENT : 
ELECTRICAL [Part 353000 ] 
TSB No: 93 NHTSA ID: , May 01, 2003 : Replacement:  
Summary: whip antenna shipping location and installati