2004 HONDA CR-V Owners Manual

To unlatch the detachable anchor
bef ore f olding the seat-back, insert
the latch plate into the slot on the
side of the anchor buckle and allow
the seat belt to retract. Store the
detachable anchor and seat belt latch
plates in the retractor housing.When the seat-back is returned to its
upright position, be sure to latch the
detachable anchor by lining up the
triangle marks on the small latch
plate and anchor buckle, then insert
the plate into the buckle. Tug on the
seat belt to verify that the detachable
anchor is securely latched. Make
sure the seat belt is not twisted.
Seats
Inst rument s and Cont rols85
ANCHOR BUCKLE
LATCH PLATE SMALL LATCH
PLATE
TRIANGLE
MARKS

µµ
Turn the ignition switch to ON (II)
toraiseorloweranywindow.To
open the window, push the switch
downandholdit.Releasetheswitch
when you want to stop the window.
Pull back on the switch and hold it to
close the window. To open/close the driver’s
window, push the window switch
f irmly down or up to the second
detent, and release it. The window
will automatically go up or down all
the way. To stop the window, pull/
push on the window switch brief ly.
If the MAIN switch is OFF, the
passenger windows cannot be raised
or lowered. Keep the MAIN switch
off whenyouhavechildreninthe
vehicle so they do not injure
themselves by operating the
windows unintentionally. If the driver’s
window runs into any obstacle while
it is closing automatically, it will
reverse direction and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.
AUTO AUTO REVERSE
Power Windows
Inst rument s and Cont rols86
DRIVER’S WINDOW SWITCH
MAIN SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.

If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window f use is removed, the
AUTO f unction will be disabled. The
power window system needs to be
reset af ter reconnecting the battery
or installing the f use.Start the engine. Push down and
hold the driver’s window switch
until the window is f ully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
f or a second or two more.
If the power windows do not operate
properly af ter resetting, have your
vehicle checked by a Honda dealer. Open the glove box by pulling the
bottom of the handle. Close it with a
f irm push. Lock or unlock the glove
box with the master key.
The glove box light comes on only
when the instrument panel indicators
are on.
1.
2.
Glove Box
Inst rument s and Cont rols
Power Windows, Glove Box
87
Lock
An open glove box can cause
serious injury to your passenger
inacrash,evenifthe
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.

The moonroof can be tilted up in the
back f or ventilation, or it can be slid
back into the roof. Use the switch
under the lef t dashboard vent to
operate the moonroof .To tilt up the back of the moonroof ,
press and hold the center button
( ). To close the moonroof ,
press and hold the top of the switch
( ). To open the moonroof ,
press and hold the bottom of the
switch ( ).
On EX model in the U.S., and EX-L
model in Canada
Moonroof
Inst rument s and Cont rols88
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it. If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.

Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.Move the selector switch to L
(driver’s side) or R (passenger’s
side).Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
3.
1. 2.
Mirrors
Inst rument s and Cont rols
Adjusting the Power Mirrors
89
TAB
SELECTOR SWITCH
ADJUSTMENT SWITCH

The outside mirrors are heated to re-
move fog and frost. With the ignition
switch in the ON (II) position, turn
on the heaters by pressing the but-
ton. The light in the button comes on
as a reminder. Press the button
again to turn the heaters off.
On EX and EX-L models in Canada
Power Mirror Heaters
Mirrors
Inst rument s and Cont rols90

Î
Î
Î
Î
Î
Interior Convenience Items
Inst rument s and Cont rols91
COAT HOOK
DASH BOARD POCKET
BEVERAGE HOLDERS BEVERAGE HOLDERSSTORAGE BOX
CENTER TABLE
BUILT-IN TABLE
1 : M/T model only
2 : A/T model only CENTER
POCKET
BEVERAGE HOLDERS /
COIN TRAY
ACCESSORY POWER SOCKET
DRIVER’S POCKETACCESSORY POWER SOCKET
2
2
1

The cargo area floor can be taken
out and used as a table.To remove the table, pull up the
carpet. Lif t and pull on the handle to
slidethetableout.
Be caref ul when you are using the
beverage holder. A spilled liquid that
is very hot can scald you or your
passengers. Spilled liquids can also
damage the upholstery, carpeting,
and electrical components in the
interior.
Beverage Holder, Built-in Table
Inst rument s and Cont rols
Built-in T able
Beverage Holders
92
HANDLE