2004 DACIA SUPERNOVA climate control

81
REAR AND INTERIOR LIGHTING
81 - 7
A.
FOR VEHICLES MANUFACTURED TILL 01.06.2001
The fuses are protecting the following electric circuits:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Clock, radio, STOP contact, climate blower relay control
Reverse driving contact
UCE decoder, speed transducer, instrument panel supply, diagnostic
socket, AC starting button, UCE anti intrusion
Turning and hazard lights
Front/rear parking lights, lighting: switches, instrument panel, climate
control, documents compartment, cigarette lighter, ashtray, radio
Cigarette lighter, instrument panel (anti-starting indicator), front right
ceiling lamp, UCE anti intrusion, anti intrusion indic
ator, diagnostic socket
Windscreen wiper-washing switch, windscreen wiper timer
Rear window defrosting
Climate blower
Left fo g lamp
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10 15A
5A
15A
7,5A
5A
15A
15A
20A
15A
5A
COCKPIT FUSE BOX
vnx.su

81
REAR AND INTERIOR LIGHTING
B. FOR VEHICLES MANUFACTURED AFTER 01.06.2001
AND VEHICLES RESPECTING EURO 2000 POLLUTION NORM
The fuses are protecting the following electric circuits:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Clock, radio, STOP contact, climate blower relay control
Reverse driving contact
UCE decoder, speed transducer, instrument panel supply, diagnostic
socket, AC starting button, UCE anti intrusion.
Turning and hazard lights
Front/rear parking lights, lighting: switches, instrument panel, climate
control, documents compartment, cigarette lighter, ashtray, radio.
Cigarette lighter, clock, instrum
ent panel (anti-starting indic ator), front right
ceiling la mp, UCE anti intrusion, anti intrusion indicator, diagnostic socket.
UCE decoder, FLASH relay, anti starting bushing
Rear window defrosting
Climate blower
Left fo g lamp
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10 15A
5A
15A
7,5A
5A
15A
15A
20A
15A
5A
81 - 9
COCKPIT FUSE BOX
vnx.su

82B
HORN - ENGINE IMMOBILISER
82B - 41
GENERALITIES
DESCRIPTION
The a nti intrusion system has t he purpose of peripheral prot ection of the ve hicle a nd the
volumetric protecti on of the passengers compartment (cockpit) and has the following components:
The ECU anti intrusion (1) is located under the central console, being attached under the
climate control unit and receives information from the volumetric sensors and from the contacts
of: front doors, engine hood and tail hatchback.
In case of an intrusion into the vehicle, when the system is activated, ECU will start t he siren
combined with intermittent lightening of the turning lamps.
The volumetric sensors (2) are fixed on the upholstery of the left and right upper part of the
pillars. After the activation of the anti intrusion system with the remote control, the sensors c an
supply information to the ECU concerning the interior volume of the cockpit, which, in case of its
modification will produce the siren starting and the intermittent lightening of the turning lamps.
The siren (3) is fixed on a frame, being located in the climate control unit and it is controlled by
the ECU anti intrusion.
The intrusion LED indicator (4) is located on the dashboard, on the left side and it indicates if
the system is activated or not and in case of an aggression on the vehicle, the indicator will show
the type of aggression.
The contacts of the front and rear doors (5), of the e ngine hood (6) a nd of the hatchback (7)
are supplying information concerning their opening, to the ECU anti intrusion, when the system is
activated.
1 3
6
4
7
5
2
vnx.su

82B
HORN - ENGINE IMMOBILISER
82B - 51
If after a complete checking of the anti intrusion system,
the replacement of the E.C.U. anti
intrusion is required, proceed as follows:
- remove from the central console the tape recorder’s frame and the tape recorder pulling
backward but without disconnecting the tape recorder from the vehicle’s wiring;
- dismount by detaching the aeration grill located on the right side of the central console ;
- dismount the t wo screws attaching t he E CU support i n t he ri ght side of the climate
control unit;
- take off the anti intrusion ECU together with its support through the central zone of the
central console; - disconnect the 24 ways connector from the anti intrusion ECU proceeding as follows:
remove towards exterior the two blocking clips of the connector and then carefully pull out the
connector; - dismount carefully the two way connector from the anti intrusion ECU;
- dismount the two screw attaching the anti intrusion ECU on its support;
- proceed the in reverse order of the dismounting;
- check the proper operation of the anti intrusion system. DISMOUNTING – REMOUNTING
OF THE ANTI INTRUSION ECU
vnx.su

83
INSTRUMENT PANEL
DISMOUNTING
Disconnecting battery.
Dismounting flexible shaft( speedometer cable) from the gearbox.
Dismounting control cable from the recyclin g flap.
Dismounting steering wheel and the steering wheel casing.
Dismountin g dashboard lower fairing.
Dismountin g documents compartment.
Disconnect documents compartment lamp.
Dismountin g central console.
Dismounting flaps control cables from the climate control unit.
Discon necting: cigarette lighter, climate control lighting, ashtray lighting, climate control switch .
Dismounting headlamps adjustment control from the dashboard.
Dismounting dashboard from the windscreen lower cross bar.
Disconnecting flexible shaft (speedometer cable) from the instrument panel.
Disconnecting air conducting ducts to aerators.
Disconnecting front wiring from the instrument panel and from the dashboard wiring.
Dismounting instrument panel attachmen t clamps from the dashboard.
Dismountin g clamps from the instrument panel.
Mounting clamps on the new instrument panel.
Mounting instrument panel with clamps on dashboard.
Connecting flexible shaft to the instrument panel.
Connecting front wiring to the instrument panel and to the dashboard wiring.
Positioning and fixing air conducting ducts.
IN
STRUMENT PANEL REPLACEMENT
83-5
vnx.su

83
INSTRUMENT PANEL
Positioning and fixing flaps control cables to the climate control unit.
Connecting dashboard wirin g to: cigarette lighter, climate contro l lighting, climate control switch,
ashtray lighting.
Connecting documents compartment lamp.
Mounting documents compartment.
Mounting central console.
Mounting dashboard lower fairing.
Mounting steering wheel casing and steering wheel.
Mounting flexible shaft to the gearbox.
Mounting control cable to the recycling flap.
Connecting battery.
Functional tests.
REMOUNTING
Perform the dismounting operations in the reverse order.
83-6
IN
STRUMENT PANEL REPLACEMENT
vnx.su

85
WINDSCR EEN WIPERS
85-1
DISMOUNTING-REMOUNTING OF TH E WINDSCREEN
WIPER MECHANISM
The windscreen wiper mechanism is mounted into the climate control box. This one, and his
components too, are in the next detailed drawing.
DISMOUNTING Disconnect the battery.
Release the protectors (A) from the axles.
Di smount the attachment nut ( B) of the
windscreen wiper mechanism’s arms and blades.
Dismount the attachment nut (C) of the axles from the windscreen’s lower frame; recuperate
the ruber gaskets and retaining washers.
Disconnect the wirring connectors from the windscreen wiper electric motor.
Dismount the mechanism’s attachment screw on the lower traverser windscreen.
Get off the mechanism.
REMOUNTING
Perform the dismounting operations in the reverse order.
NOTE:
When mounting the windscreen wiper mechanism’s arms the windscreen wiper
electric motor will be aligned in“stopped at fix point”.
WINDSCREEN WIPER MECHANISM
vnx.su

87
ELECTRICAL ASSISANCE EQUIPEMENT
WINDSCREEN WASHING ASSEMBLY
It is located in the left part of the climate control box, being attached with an attachment strap (3)
and the windscreen washing electric pump (2) is attached on the reservoir ( 1) by means of clips.
In the drawing, the following elements may be identified:
1. Windscreen washing reservoir.
2. Electric pump
3. Attachment strap
4. Sustaining clip
5. Piping
6. Nozzles
7. T connector
DISMOUNTING
Disconnect the battery;
Disconnect the electric connectors from the electric pump.
Disconnect the pipe connected to the electric pump.
Dismount the washing reservoir, releasing the attachment strap.
REMOUNTING
Perform the dismountin g operations in reverse order.
Check the nozzles adjustment, in order to obtain correct windscreen washing.
87 - 1
WINDSCREEN WASHING
vnx.su