2004 DACIA SUPERNOVA low beam

80
BATTERY - FRONT HEADLIGHTS
BULBS REPLACEMENT80 - 6
HEADLAMP BULB REPLACEMENT
DISMOUNTING
Disconnect the connector (1).
Disconnect the supply wires of the parking bulb and remove the parking bulb.
Remove the rubber protector (2).
Release t he attachment clamps (3) and remove the low-main beam bulb.
REMOUNTING
Perform the dismounting operations in the reverse order.
NOTE:
In case the headlamp is equipped with a halogen bulb, do not touch its glass balloon
directly by hand.
FRONT TURNING BULB REPLACEMENT
DISMOUNTING
Disconnect the bulb supply wires
Rotate the holder (4) and remove it.
Remove the burnt bulb from the holder.
REMOUNTING
Pe rform the dismounting operations in the reverse orde r, with the checking of the correct
holder (4) positioning to avoid dust and humidity penetration in the headlamp assembly .
The turning lamps are using orange color bulb; when replacing the bulb, use the same bulb type.
vnx.su

80
BATTERY - FRONT HEADLIGHTS
80 - 7
HEADLAMPS ADJUSTMENT
MEETING LIGHTS ADJUSTMENT (LOW BEAM) This is performed by acting upon the V screw
(vertically p lane adjustment) or H (horizontally
p lane adjustment). By screwin g, t he lighting beam
is ”lowering” and by unscrewing is “ascending”.
Check if the lighted area i s centered on the
vertical axis and if the optical separation at 15°
coincide with the headlamp lighting. An error
of 1 cm is admissible.
A lighting beam displaced towards left has
the aspect shown in ( pict.a) and a lighting beam
displaced towards right has the aspect shown
in (pict.b).
RO AD LIGHTS ADJUSTMENT (LONG BEAM)
Check the position to coincide with the
adjustment performed for low beam a nd with
the lighting beam distributed between the two
vertical lines on the panel. When checking the long beam, the lighting
center of the ellipse, must be located on the
cross marking the screen center.
If a m ajor de viation c ompared with t he low be am i s noticed, i t is re commended t he bul b
replacement, this one being in most of the cases, responsible for such defect.
pict.a
pict.b
vnx.su

REAR AND INTERIOR LIGHTING
81
81 - 2
BULBS
Hugh/low beam lights Two phases bulb R2-12V-40/45 W
He adl a mp swith flange holder P45t41
Parking lights Bulb 12V-4W with holder BA 9s
Front turning lamp Bulb 12V-21W (colored) with holder BAU 15s
Fog lamps Halogen bulb H3, 12V-55W with holder Pk22s
Rear Parking, stop lights Bulb 12V-21/5W with holder BAY 15d
lamps Turning and reverse driving Bulb 12V-21W with holder BA15s
Rear fog lamps Bulb 12V-21W with holder BA 15s
Lamps: side signaling, trunk lighting Bulb 12V-5W with holder W2,1x9,5
License plate, ceiling, document compartment Bulb SOFIT 10 x 35 type AS02; 12 V-5W
lamps with holder Sv 8,5
Lamp STOP-S3 on the ceiling Bulb 12V-21W type C21W with holder Sv 8,5
Instrument panel Bulb 12V-1,2W holderW 2 x 4,6d BULBS
vnx.su

REAR AND INTERIOR LIGHTING
81
81 - 8
On the fuse box, 6 fuses modules are attached, protecting the following consumers:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Left high beam
Right high beam, high be
am indicator
Left lo w b e am
Right low beam, low beam indicator
UCE decoder, FLASH relay, anti starting bushing
Radio, windscreen wiper motor.
10A
10A
10A
10A
15A
10A
F11
F12
F13
F14
F15
F16
COCKPIT FUSE BOX
vnx.su

REAR AND INTERIOR LIGHTING
81
81 - 10
Pe cutia de siguran
e sunt fixate 6 module siguran
e fuzibile ce protejeazã urmãtorii consumatori:
FUSE
NUMBER FUSE
TYPE
PROTECTED CIRCUIT
Left high beam
Right high beam, high be
am indicator
Left lo w b e am
Right low beam, low beam indicator
Windscreen wiper-washing switch, windscreen wiper
timer
Radio, windscreen wiper motor.
10A
10A
10A
10A
15A
10A
F11
F12
F13
F14
F15
F16
COCKPIT FUSE BOX
vnx.su

83
INSTRUMENT PANEL
CONNECTOR C
1. Instrum ent panel lighting
2. Ground
3. Anti starting indicator
4. Supply (+ IC)
5. Free
6. Injection failure indicator
CO NNECTOR D
1. Battery charging circuit failure indicator
2. Fuel minimum level warning
3. Free
4. Free
5. Free
6. Free
7. Free
8. Free
83-2
The corresponden
ce between the positions from A,B,C,D connectors of the instrument panel
and the components of the vehicle electric equipment is the following :
CONNECTOR A
1. Free
2. Rear window defrosting indicator
3. RPM
4. Cooling fluid temperature indicator
5. Oil pressure warning
6. Cooling fluid temperature warning
7. Left turning indicator
8. Left turning indicator
9. Hazard lights indicator
10. Instrument panel ground
CONNECTOR B
1. High beam indicator
2. Free
3. Free
4. Right turning indicator
5. Right turning indicator
6. Supply ()+DC)- after contact
7. Hand brake, braking system failure warning
8. Brake pads wear indicator
9. Free CO
NNECTORS ( until 01.06.2001)
vnx.su

83
INSTRUMENT PANEL
83-4
CO
NNECTOR X
1. Low beam indicator
2. Anti starting indicator
3. Supply(+IC) anti starting indicator
4. Injection failure indicator
5. Oil pressure warning
6. Water temperature indicator
NOTE
In case of the interventions on the instrument panel, check the existence of the
rubbe r i solati ng ele ments on the windsc re en lower c ross bar, pl ac e d behi nd the
instrument panel. For the vehicles corresponding to the pollution norm EURO 2000, at the X c onnector,
position 4 is “ OBD anti-pollution failure indicator”. The i nstrument panel is provided with thre e connectors having the following pl ugs
correspondence:
CONNECTOR V
1. Instrum ent panel lighting
2. Ground
3. Rear window defrosting indicator
4. High beam indicator
5. RPM
6. Supply (+DC) after contact
7. Free
8. Ground
9. Right turning indicator
10. Left turning indicator CONNECTOR Z
1. Hazard indicator
2. Water temperature warning
3. Supply (+DC) after contact
4. Ground
5. ICP and handbrake warning
6. Brake pads wear warning
7. Fuel level indicator
8. Fuel level minimum warning
9. Battery charging indicator
CO
NNECTORS(after 01.06.2001)
vnx.su

84
CONTROLS - SIGNALLING
FOG LAMPS SWITCH84-5
FOG PROJECTORS SWITCH FOG LAMPS SWITCH
Pos Destination2 Fog lamp
4 High beam, low beam
5+ parking lights
6 Mass
7 Fog lamp
9 Fog lamp relay control
Pos Destination
1 + Parking lights
2 Fog lamps relay control
3 + Parking lights
4 Mass
vnx.su