2004 Acura RL 3.5 Owner's Manual

µ
µ µ
ÓÓµ
µ´
The display allows you to
see up to ten characters in an artist’s
name or song title. XM’s system is
setuptotransmitupto16characters.
Press the MORE button to see
additional characters.
To listen to satellite radio, turn the
ignition switch to ACCESSORY (I)
or ON (II). Push the PWR/VOL
knob to turn on the audio system,
and press the SAT Radio button.
Adjust the volume by turning the
volume knob. The last channel you
listened to will show in the display.
To change bands (XM1 or XM2),
press the SAT button again. To
return to the AM and FM radio,
press the AM/FM button. Each time you press and release the
DISP button, the display changes in
the f ollowing sequence: channel
name, channel number, category,
artist name, and music title.
You may experience periods when
XM Radio does not transmit the
artist’s name and the song title
inf ormation. If this happens, there is
nothing wrong with your system.
To switch between the
channelmodeandthecategory
mode, press the DISP button until
themodechanges.
In the channel mode, you can receive
all of the available channels. In the
category mode, such as Jazz, Rock,
Classical, etc., you can receive only
the channels within that category. Turn the Tune knob lef t or
right to select channels. In the
category mode, you can only select
channels within that category.
In the
category mode, press either button
to select another category.
Audio System
Comf ort and Convenience Feat ures
Operating Satellite Radio MORE
DISP TUNE
CAT EGORY ( or )
174

µµ
The SCAN f unction gives
you a sampling of all channels while
in the channel mode. In the category
mode, only the stations within that
category are scanned. To activate
SCAN, press the SCAN button. The
system plays each channel in
numerical order f or a f ew seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again. Pick the preset button you want
f or that channel. Press and hold
the button until you hear a beep.
Repeat steps 2 to 3 to store the
f irst six channels.
Youcanstoreupto12
preset channels using the six preset
buttons. Each button stores one
channel f rom the XM1 band and one
channel f rom the XM2 band. To store a channel:
To store a channel: Press the SAT Radio button until
XM1 or XM2 appears in the
display.
Once a channel is stored, simply
press and release the proper preset
button to tune to it.Press the SAT Radio button again.
The available XM band will show.
Store the next six channels using
steps 2 through 3.
The presets will be lost if your car’s
battery goes dead, is disconnected,
or the radio f use is removed.
In the category mode, only channels
within that category can be selected.
In the channel mode, all channels
can be selected. Use the TUNE knob, or the
CATEGORY or SCAN buttons to
tune to a desired channel.
1.
2. 3.
4.
5.
CONT INUED
Audio System
Comf ort and Convenience Feat ures
SCAN
Preset
175

The XM satellites are in orbit over
the equator; therefore, objects south
of the vehicle may cause satellite
reception interruptions. To help
compensate f or this, ground-based
repeaters are placed in major
metropolitan areas.
Satellite signals are more likely to be
blocked by tall buildings and
mountains the f arther north you
travel from the equator.
Audio System
Comf ort and Convenience Feat ures176
SATELLITEGROUND
REPEATER
Signal may be
blocked by
mountains or
large obstacles
to the south.

Depending on where you drive, you
may experience reception problems.
Interf erence can be caused by any of
these conditions:Driving on the south side of an
east/west mountain road If your XM Radio service has expired
or you purchased your car f rom a
previous owner, you can listen to a
sampling of the broadcasts available
on XM Satellite Radio. With the
ignition switch in the ACCESSORY
(I) or ON (II) position, push the
PWR/VOL knob to turn on the audio
system and press the SAT Radio
button. A variety of music types and
styles will play.
Driving on the north side of a
large commercial truck on an
east/west road
Driving in tunnels
Driving on a road beside a vertical
wall, steep clif f or hill to the south
of you
Driving on the lower level of a
multi-tiered road
Driving on a single lane road
alongside dense trees taller than
50 f t. (15 m) to the south of you
There may be other geographic
situations that could af f ect satellite
radio reception.As required by the FCC: Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
CONT INUED
Audio System
Comf ort and Convenience Feat ures
Receiving Satellite Radio Service
177

Two controls f or the audio system
are mounted in the steering wheel
hub. These let you control basic
f unctions without removing your
hand f rom the wheel.
If you decide to purchase XM
Satellite Radio service, contact XM
Radio at www.xmradio.com, or at
1-800-852-9696. You will need to give
them your radio I.D. number and
your credit card number. To get your
radio I.D. number, turn the TUNE
knob until ‘‘0’’ appears in the display.
Your I.D. will appear in the display.
After you’ve registered with XM
Radio, keep your audio system in the
SAT Radio mode while you await
activation. This should take about 30
minutes.
While awaiting activation, make sure
your vehicle remains in an open area
with good reception. Once your
audio system is activated, ‘‘category’’
or ‘‘CH’’ will appear in the display
andyou’llbeabletolistentoXM
Radio broadcasts. XM Radio will
continue to send an activation signal
to your vehicle for at least 12 hours
from activation request. If the
service has not been activated after
36 hours, contact XM Radio.
Audio System
Comf ort and Convenience Feat ures
Remote Audio Controls
178
AUDIO/CH
BUTTON

ÛÝ
The top and bottom buttons adjust
thevolumeup( )ordown( ).
Press the proper button and hold it
until the desired volume is reached,
then release it.
The AUDIO/CH button has f our
f unctions, depending on whether you
are listening to the radio or XM
satellite radio, or playing a cassette
or CD.
If you are listening to the radio, use
the AUDIO/CH button to change
stations. Each time you press this
button, the system advances to the
next preset station on the band you
are listening to. You will see the
number of the selected Preset button
in the display. To change bands,
press the AM or FM button (without
Navigation System), or AM/FM
button (with Navigation System) on
the audio system’s f ront panel. If you are playing a cassette, use the
AUDIO/CH button to advance to the
next selection. You will see ‘‘FF’’
blinking in the display when you
press the AUDIO/CH button. The
system f ast f orwards until it senses a
silent period, then goes back to
PLAY.
If youareplayingaCD,thesystem
skips to the beginning of the next
track each time you push the
AUDIO/CH button. You will see the
disc and track number in the display.
If you are listening to satellite radio,
you can also use the AUDIO/CH
button to change channels. Each
time you press this button, the
system advances to the next preset
channel on the band you are
listening to. You will see the number
of the selected Preset button in the
display. To change bands (XM1 or
XM2), press the SAT Radio button
on the audio system’s f ront panel.
U.S. Cars only
Audio System
Comf ort and Convenience Feat ures179

You will have to store your favorite
stations in the Preset buttons after
the system begins working. Your
original settings were lost when
power was disconnected.
Your car’s audio system will disable
itself if it is disconnected f rom
electrical power f or any reason. To
make it work again, the user must
enter a specif ic f ive-digit code in the
Preset buttons. Because there are
hundreds of number combinations
possible f rom f ive digits, making the
system work without knowing the
exact code is nearly impossible.
Youshouldhavereceivedacardthat
lists your audio system’s code
number and serial number. It is best
tostorethiscardinasafeplaceat
home. In addition, you should write
the audio system’s serial number in
this Owner’s Manual. If you should
happen to lose the card, you must
obtain the code number f rom your
Acura dealer. To do this, you will
need the system’s serial number. If you make a mistake entering the
code, do not start over or try to
correct your mistake. Complete the
f ive-digit sequence, then enter the
correct code. You have three tries to
enter the correct code. If you are
unsuccessful in three attempts, you
must then leave the system on for
one hour bef ore trying again. If your car’s battery is disconnected
or goes dead, or the radio f use is
removed, the audio system will
disable itself . If this happens, you
will see ‘‘ ’’ in the f requency
display the next time you turn on the
system. Use the Preset buttons to
enter the f ive-digit code. If it is
entered correctly, the radio will start
playing.
Thef t Protection
Audio System
Comf ort and Convenience Feat ures180

Once the security system is set,
opening any door (without using the
key or the remote transmitter), or
the hood, will cause it to alarm. It
also alarms if the radio is removed
f rom the dashboard or the wiring is
cut.With the system set, you can still
open the trunk with the master key
or the remote transmitter without
triggering the alarm. The alarm will
sound if the trunk lock is f orced, or
the trunk is opened with the trunk
releasebuttononthedriver’sdoor.
The security system sets auto-
matically fifteen seconds after you
lock the doors, hood, and trunk. For
the system to activate, you must lock
the doors f rom the outside with the
key, lock tab, door lock switch, or
remote transmitter. The security
system light next to the driver’s door
lock starts blinking immediately to
show you the system is setting itself . Do not attempt to alter this system
or add other devices to it.
The security system helps to protect
your car and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
carorremovetheradio.Thisalarm
continues f or two minutes, then the
system resets. To reset an alarming
system bef ore the two minutes have
elapsed, unlock either f ront door
with the key or the remote
transmitter.
The security system will not set if
the hood, trunk, or any door is not
f ully closed. If the system will not set,
check the Door and Trunk Open
Monitor on the instrument panel
(see page ), to see if the doors
and trunk are f ully closed. Since it is
notpartofthemonitordisplay,
manually check the hood.
61
Comf ort and Convenience Feat ures
Security System
181
SECURITY SYSTEM LIGHT