2003 MITSUBISHI SHOGUN suspension

G52E058DEA99AOIb
1- Front seat
•To adjust forward or backward→P.3-6
•To recline the seatback→P.3-7
•To adjust seat cushion height*→P.3-7
•Lumbar support adjustment (driver’s side only)*→P.3-9
•To get in and out of the rear seat
(3-door models,passengers seat only)→P.3-9
•Heated seats*→P.3-10
•Suspension seat*→P.3-11
2- Rear seat (3-door models)*/
Second seat (5-door models)*
•To recline the seatback→P.3-12
•To get in and out of the third seat (5-door models)→P.3-13
•Armrest→P.3-13
•Folding the rear (3-door models)/second (5-door models)
seatback forward→P.3-15
•Folding the rear seat (3-door models)/
second seat (5-door models)→P.3-17
3- Third seat (5-door models)*
•To recline the seatback→P.3-14
Seat and seat belts
3-2Div:
Out put date:

CAUTION
(5) Turn the heater off immediately
if it appears to be malfunction-
ing during use.
NOTE
(1) Do not place heavy objects on the seat
or stick pins, needles, or other pointed
objects into it.
(2) When cleaning the seat, do not use
benzene, gasoline, alcohol, or other
organic solvents; this might damage the
surface of the seat, but also the heater
element.
(3) If water or any other liquid is spilled on
the seat, allow it to dry thoroughly
before attempting to use the heater.
G21D091A
Suspension seat*
EG01BOS
When the vehicle is driven over rugged ter-
rain or along rough roads, this seat absorbs
the vehicle vibrations caused by the road
surface, reducing driver fatigue and pro-
viding a comfortable ride.
To adjust seat spring tension
Turn the adjusting dial (A) to get the desired
spring tension. The height and bounce of
the seat can be adjusted by using this dial.
1- Softer
2- Harder
G21D092A
To stop the suspension function
To stop the seat suspension function, set
the lever (B) to the lock position (3).
To start the seat suspension function again,
replace the lever (B) to the unlock posi-
tion (4).
NOTE
If it is hard to set the lever (B) to the lock
position (3), turn the adjusting dial (A) to a
softer position.
Seat and seat belts
3-11
Div:
Out put date:

mm
3-door models 5-door models
1 512.5 794
2 526*
1, 476*
2
526*
1, 476*
2
3 15*
1, 35*
2
15*
1, 35*
2
4 124 179
5 131 131
644 44
755 55
8 - 149
9 86*
1, 136.8*
2
75*
1, 125.3*
2
10 516.5*
1, 465.7*
2
531*
1, 480.3*
2
11 499.7 499.7
12 538 538
13 - 547
14 576.3 576.3
*1: Towing bar (higher type)
*2: Towing bar (lower type)
Item 8, 13: 5-door models only
Item 10: at kerb weight
NOTE
The values under Item 10 are applicable to
unladen vehicles. These values can also be
varied depending on the tyre size, optional
equipment and suspension conditions.
Operating hints(1) Do not let the clutch slip (vehicles with
a manual transmission only) and do not
increase the engine speed more than
necessary when starting.
(2) Be sure that the driving speed does not
exceed the 100 km/h (62 mph) for
trailer operation.
It is also recommended that you obey
the local regulations in case driving
speed with a trailer is limited to less
than 100 km/h (62 mph).
(3) To prevent shocks from the overrun
brake, depress the brake pedal lightly
at first and then more strongly.
(4) To make full use of engine braking,
change to a lower gear before
descending a slope.
(5) The body, brakes, clutch, and chas-
sis will be under additional strain when
towing a trailer.
(6) The heavier weight and higher rolling
and air resistance will increase fuel
consumption.Additional precautions for vehicles
equipped with an automatic transmis-
sion
The 2nd gear (in sports mode) is recom-
mended on slopes or at low speed. Use the
1st gear (in sports mode) in mountainous
areas in order to make better use of engine
braking and to assist the brake system.
However, be sure that the speed does not
exceed the maximum speed limit for the
selected gear.
Starting and driving
5-10Div:
Out put date:

Other specifications
EP01IOE
Item 2500 models 3200 models 3500 models
Fuel systemCombustion typeIn-direct injection Direct Injection Gasoline Direct Injection
Fuel injection
pumpElectronically controlled Electric motor type
Clutch Dry single disc clutch with diaphragm spring, hydraulic action
Steering system Rack & pinion type, power assisted
SuspensionFront Independent type, double wishbone, coil spring
Rear Independent type, multi-link, coil spring
Service brakesType Hydraulic, front and rear split double circuit system with power assistance, anti-lock brake*
Front Ventilated disc brakes
Rear Drum in ventilated disc brakes
Parking brakes Parking brake acts mechanically on rear wheels
*: Optional equipment
Specifications
10-11
Div:
Out put date: