N24A119A
Type 2On the aluminium wheel type vehicle (Type
2), temporarily tighten the wheel nuts by
hand until the flanges of the wheel nuts
come into contact with the wheel.
NOTE
(1) Flange nuts (Type 2) can be tempo-
rarily used on the steel wheel, but
return to the original wheel and tyre as
soon as possible.
(2) If all four wheels on vehicles with flange
nuts (Type 2) are changed to steel
wheels, use tapered nuts (Type 1).
CAUTION
Never apply oil to either wheel bolts
or nuts, as it will cause them to over-
tighten.
N24A286A
9. Lower the vehicle slowly and then
tighten the nuts crisscross in two or
three steps until each nut has been
tightened securely.
Tightening torque:
98 to 118 Nm
(Achieved by applying a force of 370 to
430 N at the end of the wheel nut
wrench supplied with the vehicle)
CAUTION
Never use extra force by your foot to
the wheel nut wrench or by using a
pipe extension as you can over-
tighten the nut.
10. Lower and remove the jack and stow
the jack, jack handle, wheel nut wrench
and flat tyre wheel. Have the flat tyre
repaired as soon as possible.
N24A100A
11. Check tyre inflation pressure. The infla-
tion pressure specification is shown on
the label. Refer to the illustration.
For emergencies
8-16Div:
Out put date:
