2003 MITSUBISHI SHOGUN jacking

[x] Cancel search: jacking

Page 200 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) Cautions on handling of 4WD
vehicles
EI49A-Xa
Tyre and disc wheelsSince the driving torque can be applied to
the 4 wheels, the performance of the
vehicle when operating in 4WD is greatly
affected by t

Page 299 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) For emergencies
If the vehicle breaks down .................................... 8- 2
Operation under adverse driving
conditions .......................................................... 8- 2
Tools an

Page 306 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) N21D090A
2. With the snap pin (C) pushed, insert theinside handle until it is locked.
Jacking up the vehicle
EN22AXSc
1. Park the vehicle on a level and stableground.
2. Activate the hazard flashers a

Page 307 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) N22A200A
5. Place the jack under one of the jack-
ing points shown in the illustration. Use
the jacking point closest to the tyre to be
changed.
C-Front jacking point
N22A201A
D-Rear jacking point
NOT

Page 308 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) N22A205A
To raise the vehicle1. Remove the jack and jack handle.
2. Using the jack handle, turn the release
valve (F) clockwise until it reaches a
stop.
N22A206A
3. Insert the jack handle in the brack

Page 312 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) N22A172A
2. Position the vehicle on a flat, hard sur-
face and apply the parking brake. To
prevent the vehicle from rolling when it
is raised on the jack, chock the wheel
(A) diagonally opposite to th

Page 313 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) N24A285A
4. Loosen the wheel nuts with the wheel
nut wrench. Do not remove the wheel
nuts yet.
5. Refer to the section entitled“Jacking up
the vehicle”to select a jacking point near
the flat tyre

Page 382 of 392

MITSUBISHI SHOGUN 2003  Owners Manual (in English) Accessory boxes ................................................ 6-62
Accessory socket ............................................... 6-61
Additional equipment .......................................