2003 MITSUBISHI SHOGUN ignition

Active traction control systemThe active traction control system main-
tains traction on slippery road surfaces by
automatically controlling the engine out-
put and applying the brakes so the driv-
ing wheels are prevented from spinning.
The active traction control system auto-
matically turns ON when the ignition switch
is turned to the“ON”position.
CAUTION
If the temperature in the braking sys-
tem increases excessively due to
continuous brake control on a slip-
pery road surface, a warning buzzer
will sound intermittently to warn the
driver. If driving continues in spite of
the buzzer and the temperature in the
braking system increases further, the
lamp will illuminate, the warn-
ing buzzer will sound continuously
for approximately 3 seconds, and
active traction control system opera-
tion will be suspended to protect the
braking system. (Normal operation of
the vehicle will not be affected.) If the
vehicle is stopped and the
lamp
goes off, the active traction control
system will start operating again.NOTE
(1) When the engine starts, a click is heard
from the engine compartment. This is
only the sound of the active traction
control system being checked. It does
not indicate a fault.
(2) When the active traction control sys-
tem operates, you may feel vibration
and/or hear the active traction control
system’s operating noise, which indi-
cates that the active traction control
system is working normally. They do
not indicate a fault.
(3) The active traction control system does
not operate while the ABS warning
lamp is illuminated.
I19B001A
Example indication: active traction con-
trol system controlling front−right wheelActive traction control system
operation indication lampThe
lamp (1) should illuminate when
the ignition switch is turned to the“ON”
position and should go off after a few sec-
onds.
If the indication lamp stays on or does not
illuminate when the ignition switch is turned
to the“ON”position, please contact your
nearest authorized MITSUBISHI dealer for
inspection.
When the active traction control system
operates, the active traction control sys-
tem operation indication lamp (1) flashes
and the indication lamp for the wheel (2)
being subjected to antispin control also
flashes.
Starting and driving
5-60Div:
Out put date:

NOTE
In the event of a fault in the active stabil-
ity control system, the
and
lamps
illuminate. As a result, an indication of the
active traction control system operation is
limited to flashing of the indication lamp for
the wheel (2) being subjected to antispin
control.
I19B007A
CAUTION
If the vehicle is towed with the igni-
tion switch in the“ON”position and
only the front wheels or only the rear
wheels raised off the ground, the
active traction control system may
operate, resulting in an accident.
When towing the vehicle with the
front wheels raised, keep the igni-
tion switch in the“LOCK”or“ACC”
position. When towing the vehicle
with the rear wheels raised, keep the
ignition switch in the“ACC”posi-
tion.
Refer to“Towing”on page 8-17.
Starting and driving
5-61
Div:
Out put date:

H11A363D
UKW/MW/LW electronic tuning radio with tape
player*
EH30A-Pa
The audio system can be used when the ignition switch is in the
“ON” or “ACC” position.
A-Display window
B-Audio system
C-Multi centre display
D-RV meter
NOTE
(1) A CD player or a CD autochanger can be connected to this
audio system. The CD player or the CD autochanger can be
operated by the switch on the audio body. Refer to
“Connection of a CD player or a CD autochanger” on page
6-15.
(2) To listen to the audio system while the engine is stopped, turn
the ignition switch to the “ACC” position.(3) When a cellular phone is used inside the vehicle, noise may
be produced from the audio equipment. This does not mean
that something is wrong with the audio equipment. In such a
case, use the cellular phone at a place as far as possible from
the audio equipment.
(4) In case of misuse (entry of a foreign object or water, smoke
or odour, etc.), immediately turn off the audio system and have
it checked at an authorized MITSUBISHI dealer. Never try to
repair it by yourself. Avoid continuous usage without inspec-
tion by a qualified person.
(5) The audio system’s control panel can be removed to deter
thieves. For details, refer to section entitled “Audio system
anti-theft feature” on page 6-32.
For pleasant driving
6-2Div:
Out put date:

H11A204A
Emergency broadcasts
If an emergency broadcast is caught while
receiving a UKW broadcast or playing back
a cassette tape with the ignition switch in
“ACC”or“ON”position, the display will
show“ALARM”and the emergency broad-
cast will interrupt the current program. The
volume level is set separately for listen-
ing to normal audio programs and for lis-
tening to emergency broadcasts. The
volume level will therefore change auto-
matically to that set when an emergency
broadcast was last received. When the
emergency broadcast is over, the radio will
return to the previously received program
and to the corresponding volume level.
For pleasant driving
6-12Div:
Out put date:

H11A363D
UKW/MW/LW electronic tuning radio with CD
player*
EH30A-Qa
The audio system can be used when the ignition switch is in the
“ON”or“ACC”position.
A-Display window
B-Audio system
C-Multi centre display
D-RV meter
NOTE
(1) A CD autochanger can be connected to this audio system. The
CD autochanger can be operated by the switch on the audio
body. Refer to“To listen to a CD”on page 6-28.
(2) To listen to the audio system while the engine is stopped, turn
the ignition switch to the“ACC”position.(3) When a cellular phone is used inside the vehicle, noise may
be produced from the audio equipment. This does not mean
that something is wrong with the audio equipment. In such a
case, use the cellular phone at a place as far as possible from
the audio equipment.
(4) In case of misuse (entry of a foreign object or water, smoke
or odour, etc.), immediately turn off the audio system and have
it checked at an authorized MITSUBISHI dealer. Never try to
repair it by yourself. Avoid continuous usage without inspec-
tion by a qualified person.
(5) The audio system’s control panel can be removed to deter
thieves. For details, refer to the section entitled“Audio sys-
tem anti-theft feature”on page 6-32.
For pleasant driving
6-17
Div:
Out put date:

H11A204A
Emergency broadcasts
If an emergency broadcast is caught while
receiving a UKW broadcast or playing back
a cassette tape with the ignition switch in
“ACC ”or “ON ”position, the display will
show “ALARM ”and the emergency broad-
cast will interrupt the current program. The
volume level is set separately for listen-
ing to normal audio programs and for lis-
tening to emergency broadcasts. The
volume level will therefore change auto-
matically to that set when an emergency
broadcast was last received. When the
emergency broadcast is over, the radio will
return to the previously received program
and to the corresponding volume level.
For pleasant driving
6-27
Div:
Out put date:

To change the order of tracks
played back (For CD player)Press the RDM button (11), and the RDM
indicator (16) will light and will be ran-
domly selected, tracks for playback. To
release, press the button again.To change the order of discs
played back (For CD autochanger)Press the RDM button (11), and the RDM
indicator (16) will light and tracks for play-
back will be selected randomly from all
discs loaded into the changer.
To release, press the button again.How to use the SCAN buttonUse the SCAN button (9) to search for a
particular track, etc. When this button is
pressed, the first 10 seconds of each track
on the disc will be played.
The disc will advance at fast-forward speed
between each 10-second play. When a
track you want to listen to is played in this
way, press the SCAN button again, that
track will then be played from its begin-
ning. After completion of this scanning of
tracks, the disc will begin ordinary play.
H11C004A
CD (Compact-Disc) player*
EH11C-Fe
The CD player can be used when the igni-
tion switch is in either the“ON”or“ACC”
position.
NOTE
(1) The CD player can be used when the
PWR (on-off) switch, which is on the
radio is off.
(2) To listen to the CD player while the
engine is stopped, turn the ignition
switch to the“ACC”position.
(3) When a disc is inserted, the CD player
will automatically begin playing and the
radio or tape player will be switched off.(4) Use the radio controls to adjust the vol-
ume, tone and left/right sound bal-
ance.
(5) When a cellular phone is used inside
the vehicle, noise may be produced
from the audio equipment. This does
not mean that something is wrong with
the audio equipment. In such a case,
use the cellular phone at a place as far
as possible from the audio equip-
ment.
(6) Do not oil any part of the player and do
not insert any object other than com-
pact discs into the slot, or the CD
player may be damaged.
(7) In case of misuse (entry of a foreign
object or water, generation of smoke or
odor, etc.), immediately stop the opera-
tion and have the audio system
checked at an authorized MITSUB-
ISHI dealer. Never try to repair it by
yourself. Avoid continuous usage with-
out inspection by a qualified person.
1- Eject button
2- Disc-loading slot
For pleasant driving
6-30Div:
Out put date:

NOTE
(1) When the first disc has played to the
end, the second disc will start to play
automatically. When the second, third,
fourth, fifth, and sixth disc have each
played to the end, the sequence will
begin again from the first disc.
(2) The current setting of the disc selec-
tion button (1) will be stored in memory
even if the engine has been turned off.How to eject a discPress one of the disc selection buttons (1)
to select the disc number which you would
like to eject.
Then press the eject button (4) to eject that
disc.
NOTE
When a disc is ejected when in CD mode
(single player or autochanger), the sys-
tem automatically switches to the radio.
H11F032A
Audio system anti-theft feature
EH11F-Ed
To prevent theft of the audio system, the
control panel can be removed. Always
remove the control panel when you leave
the vehicle.Removing the control panelTurn the ignition switch to the OFF posi-
tion. Then, slide the release button (A) to
the left and remove the control panel from
the audio system. (When sliding the release
button, place one hand on the control panel
to prevent it from falling out.) The lamp (B)
will start flashing.
H11F033A
Refitting the control panelInsert the control panel into the latches at
the right-hand side of the cutout on the
audio system. Then, press the left-hand
side of the control panel into the cutout until
it locks in position. The lamp (B) will stop
flashing. Next, turn the ignition switch to the
ON position.
NOTE
(1) Do not leave the control panel in any
place where it may become hot (for
example, the dashboard) or in any
place where it may become wet.
(2) If you lose the control panel, contact an
authorized MITSUBISHI dealer.
For pleasant driving
6-32Div:
Out put date: