2003 MITSUBISHI SHOGUN display

NOTE
(1) When the system cannot provide a defi-
nite value for the driving range, the dis-
play shows“
km”.
(2) The driving range varies depending on
road conditions, the manner of driv-
ing and other related factors. Conse-
quently, the display should be used
only as a guide. It is recommended that
fuel be added as soon as the low fuel
indication lamp in the instrument clus-
ter illuminates.
(Refer to“Low fuel indication lamp”on
page 4-9.)
(3) The driving range displayed is based on
previous fuel consumption data. Since,
disconnecting the battery cable will
result in the deletion of existing fuel
consumption date, which will affect the
unit’s calculations.
(4) The driving range figure can occasion-
ally increase if the vehicle is stopped on
an incline. This is because the fuel has
moved in the tank because of the
incline and is not considered a fault.
D92K012A
Climate information
ED92K-G
The climate information display consists of:
outside temperature display (1) barom-
eter (2) altimeter (3) and compass (4).1. Outside temperature display
This displays the outside temperature while
the vehicle is moving.
Instruments and controls
4-47
Div:
Out put date:

D92K013A
A- Road surface freeze warning symbol
When the outside temperature drops below
about 3°C, the alarm sounds and the road
surface freeze warning symbol (A) flashes
for about 10 seconds.
CAUTION
There is a danger the road might be
frozen even when the symbol (A) is
not illuminated, so please take care
when driving.
D92K014A
Even when a display other than climate
information has been selected, the out-
side temperature is still shown in the
top-right-hand corner of the screen.
NOTE
(1) The display can show outside tempera-
ture from -40°Cto50°C.
(2) Under certain driving conditions, the
display may show a different tempera-
ture from the real outside tempera-
ture.2. Barometer
This displays the air pressure at the vehi-
cle’s current position.
NOTE
The barometer displays air pressure to the
nearest 2 hPa.
Instruments and controls
4-48Div:
Out put date:

D92A058A
3. Altimeter
This displays the altitude at the vehicle’s
current position.
Changing the unit: pressing the selection
button (A) for more than 3 seconds
changes the altimeter unit between metres
and feet.NOTE
(1) The altimeter displays altitude to the
nearest 50 metres (200 feet). When the
vehicle is below sea level, the alti-
tude is shown as 0 metres (0 feet).
(2) The altimeter works by using changes
in atmospheric pressure. This means it
may be affected by changes in the
weather and other conditions, and
show a figure different from the real alti-
tude.
(3) Fluctuations in air pressure may change
the figure displayed even when the
vehicle remains in the same place. This
does not mean a fault with the sys-
tem.
D92K015A
4. Compass
This compass shows the direction of the
vehicle by the 16 azimuth system.
is the direction of travel.Instruments and controls
4-49
Div:
Out put date:

NOTE
(1) This system uses the earth’s mag-
netic field, and so may not show the
correct direction depending on the trafic
condition or in the following places
where the earth’s magnetic field is dis-
rupted.

Car parks located in buildings and
tunnels

Expressways and underground
cables

Area over the subway

Transforming station

Areas along the railroad
In these cases, the correct direction will
be displayed once the vehicle returns
to a place where the earth’s magnetic
field is stable.
(2) Do not install ski racks, antennas, etc.
which are attached to the vehicle by
means of a magnet. They affect the
operation of the compass.
D92K016A
Adjusting the compass
The compass is usually adjusted automati-
cally when the vehicle is moving. How-
ever, when it needs manual intervention, a
message will appear on the display for
about 7 seconds, and the direction indica-
tor will blink. In this case, adjust the com-
pass by the following steps.
D92A060A
1. Press the selection button for
“CAL.COMP.”.
Instruments and controls
4-50Div:
Out put date:

D11C087B
Setting the declination
The declination is the difference between
true north (the direction of the geo-
graphic north pole) and where a com-
pass needle points to. Since the declination
varies from place to place, it needs to be
set for each region. Otherwise the com-
pass will not show the correct direction.
Set the declination by the following steps:NOTE
(1) The declination differs from area to area
and is distributed roughly as shown in
the illustration.
(2) The declination can be set at inter-
vals of 5 degrees, from 20 degrees
west (W20) to 20 degrees east (E20).
D92A060A
When the screen is showing the climate
information press the“ADJ”button to dis-
play the selection buttons. This display will
disappear automatically after about 10 sec-
onds.
1. Press the selection buttons for
“DEV.ADJ.”.
Instruments and controls
4-52Div:
Out put date:

D92A061A
2. Press the selection button for“
”or
“
”to get the desired declination.
Pressing“
”or“
”for more than
1 second makes the value change rap-
idly.
D92A062A
3. When the declination adjustment has
been completed, press the“SET”func-
tion button.
NOTE
For safety, these operations can only be
carried out when the vehicle is moving at
less than 3 km/h (2 mph).
D92K032A
Date and time
ED92N-Da
The date and time display shows the time
(A) and the date (B).Instruments and controls
4-53
Div:
Out put date:

D92K033A
When the screen is set to a display other
than the date-time display, only the time (A)
is displayed in the top-left corner.
Instruments and controls
4-54Div:
Out put date:

Adjusting the date and timeFollowing modes are available for clock adjustment:
•MITSUBISHI genuine audio:
“Auto mode” and “Manual mode”
• Non genuine audio:
“Manual mode” only
The selected mode is shown on the audio display.
“CT” displayed: Auto mode
“CT” not displayed: Manual mode
For manual time adjustment, please refer to “Manual mode ”below.
Auto mode
(MITSUBISHI genuine audio only)The automatic adjustment mode can set the local time automati-
cally by using the signal from the local RDS stations. In this mode,
“CT” (A) (Clock Time: sent with the RDS signal) is shown in the
audio display.
Instruments and controls
4-55
Div:
Out put date:
G15B093D