2003 MAZDA MODEL 6 Owners Manual (in English)

6-21
Interior Comfort
Au d i o S y s t e m
Form No. 8R29-EA-02I
•
Do not insert any objects, other than
CDs, into the slot.
•
The CD revolves at high speed within
the unit. Defective (cracked or badly
bent) CDs should never be used.
•
Do not use non-conventional discs such
as heart-shaped, octagonal discs, etc.
The CD player/changer could be
damaged.•
A new CD may have rough edges on its
inner and outer perimeters. If a disc
with rough edges is used, proper
setting will not be possible and the CD
player/changer will not play the CD.
Remove the rough edges in advance by
using a ball-point pen or pencil as
shown below. To remove the rough
edges, rub the side of the pen or pencil
against the inner and outer perimeter of
the CD.
•
When driving over uneven surfaces, the
sound may jump.
•
The CD player/changer has been
designed to play CDs bearing the
identification logo as shown. No other
discs can be played.
shuseizumi_J56J_8R29_EA_02I.book Page 21 Wednesday, October 16, 2002 9:51 AM

6-22
Interior Comfort
Audio System
Form No. 8R29-EA-02I
•
Be sure never to touch the signal
surface when handling the CDs. Pick
up a CD by grasping the outer edge or
the edge of the hole and the outer edge.
•
Do not stick paper or tape on the CD.
Avoid scratching the reverse side (the
side without a label).
•
Dust, finger smudges, and dirt can
decrease the amount of light reflected
from the signal surface, thus affecting
sound quality. If the CD should
become soiled, gently wipe it with a
soft cloth from the center of the CD to
the edge.
•
Do not use record sprays, antistatic
agents, or household spray cleaners.
Volatile chemicals such as benzine and
thinner can also damage the surface of
the CD and must not be used. Anything
that can damage, warp, or fog plastic
should never be used to clean CDs.
•
CDs, like traditional audio records, are
made of plastic. To avoid warping,
keep the CDs in their cases and do not
store them where they will be exposed
to direct sunlight.
•
The CD player/changer ejects the CD if
the CD is inserted upside down. Also
dirty and/or defective CDs may be
ejected.
•
8 cm (3 in) CDs and CD accessories
(e.g. 8 cm disc adapter) cannot be used
in the CD player/changer.•
Do not insert cleaning discs in the CD
player/changer.
•
Do not insert any disc with a peel-off
or seal on it.
shuseizumi_J56J_8R29_EA_02I.book Page 22 Wednesday, October 16, 2002 9:51 AM

6-23
Interior Comfort
Au d i o S y s t e m
Form No. 8R29-EA-02I
Power/Volume/Sound Controls ............................................................................................. 6-24
Operating the Radio .............................................................................................................. 6-28
Operating the Cassette Tape Player ....................................................................................... 6-30
Operating the Mini Disc (MD) Player ................................................................................... 6-32
Operating the Compact Disc (CD) Player ............................................................................. 6-34
Operating the In-Dash CD Changer ...................................................................................... 6-36
Error Indications .................................................................................................................... 6-39
Au d i o S e t
CD Player In-dash CD Changer
Cassette Tape Player Mini Disc (MD) PlayerIllustration is of a representative audio unit.
shuseizumi_J56J_8R29_EA_02I.book Page 23 Wednesday, October 16, 2002 9:51 AM

6-24
Interior Comfort
Audio System
Form No. 8R29-EA-02I

Power/Volume/Sound Controls
Power ON/OFF
Turn the ignition switch to the ACC or
ON position.
Press the power/volume dial to turn the
audio system on.
Press the power/volume dial again to turn
the audio system off.Vo l u m e a d j u s t m e n tTo adjust the volume, turn the power/
volume dial.
Turn the power/volume dial to the right to
increase volume, to the left to decrease it.
Audio control dial Power/Volume dial
NOTE
To prevent the battery from being
discharged, do not leave the audio
system on for a long period when the
engine is not running.
shuseizumi_J56J_8R29_EA_02I.book Page 24 Wednesday, October 16, 2002 9:51 AM

6-25
Interior Comfort
Au d i o S y s t e m
Form No. 8R29-EA-02I
Audio sound adjustment
1. Press the audio control dial to select
bass, mid-range, treble, fade, balance
or automatic level controls. The
selected function will be indicated.
*1Depending on the model, this
function, may not be available.
*2Depending on the mode selected, the
indication changes.
2. Turn the audio control dial to adjust the
selected functions as follows:
Indication Turn Left Turn Right
Decrease
bassIncrease
bass
Decrease
mid-
rangeIncrease
mid-range
Decrease
trebleIncrease
treble
Shift the
sound
to the
frontShift the
sound
to the rear
Shift the
sound
to the leftShift the
sound
to the right
Select
modeSelect
mode
*
*
NOTE
About 5 seconds after selecting any
mode, the volume function will be
automatically selected. To reset bass,
mid-range, treble, fade, balance and
automatic level control, press the audio
control dial for 2 seconds. The unit
will beep and "CLEAR" will be
displayed.
shuseizumi_J56J_8R29_EA_02I.book Page 25 Wednesday, October 16, 2002 9:51 AM

6-26
Interior Comfort
Audio System
Form No. 8R29-EA-02I
Automatic Level Control (ALC)
The automatic level control is a feature
that automatically adjusts audio volume
and sound quality according to the vehicle
speed.
The volume increases in accordance with
the increase in vehicle speed, and
decreases as vehicle speed decreases.
The following four modes are available.
Select the desired mode.
Turn the audio control dial to select the
ALC OFF, ALC LEVEL1~3 mode. The
selected mode will be indicated.
Mode Volume change
No change
Minimum
Medium
Maximum
shuseizumi_J56J_8R29_EA_02I.book Page 26 Wednesday, October 16, 2002 9:51 AM

6-27
Interior Comfort
Au d i o S y s t e m
Form No. 8R29-EA-02I
shuseizumi_J56J_8R29_EA_02I.book Page 27 Wednesday, October 16, 2002 9:51 AM

6-28
Interior Comfort
Audio System
Form No. 8R29-EA-02I

Operating the Radio
Radio ON
Press a band selector button ( , or
) to turn the radio on.
Band selection
Select a band by pressing the FM1 button
( ), FM2 button ( ) or AM button
().
The selected mode will be indicated. If
FM stereo is being received, "ST" will be
displayed.Tuning
The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
Manual tuning
Turning the manual tuning dial will
change the frequency higher or lower.
Manual tuning dial Channel preset buttonsScan button
Auto
memory
button Band selector buttons
Seek tuning
button
NOTE
If the FM broadcast signal becomes
weak, reception automatically changes
from STEREO to MONO for reduced
noise, and the "ST" indicator will go
out.
NOTE
If the power supply is interrupted (fuse
blows or the battery is disconnected),
the preset channels will be canceled.
shuseizumi_J56J_8R29_EA_02I.book Page 28 Wednesday, October 16, 2002 9:51 AM