Fig. 67: Tightening Front Suspension Lower Arm Assy LH Bolt
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
12.INSTALL FRONT WHEELS
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
13.ADJUST FRONT WHEEL ALIGNMENT (See ADJUSTMENT
)
14.ADJUST VEHICLE HEIGHT (AIR SUSPENSION) (See ON
-VEHICLE INSPECTION )
15.CHECK ABS SPEED SENSOR SIGNAL (See TEST MODE PROCEDURE
)
REPLACEMENT
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.REMOVE FRONT WHEELS
2.SEPARATE FRONT STABILIZER LINK ASSY LH (See REPLACEMENT
)
b. Install a new cotter pin on the steering knuckle.
14.INSTALL FRONT AXLE HUB SUB-ASSY LH (See step 8 in REPLACEMENT
)
15.INSTALL FRONT DISC (See step 15 in OVERHAUL
)
16.INSTALL DISC BRAKE CYLINDER ASSY LH (See step 21 in OVERHAUL
)
17.INSTALL SKID CONTROL SENSOR WIRE (See step 11 in REPLACEMENT
)
18.INSTALL FRONT STABILIZER LINK ASSY LH (See REPLACEMENT
)
19.INSTALL FRONT WHEELS
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
20.CHECK ABS SPEED SENSOR SIGNAL (See TEST MODE PROCEDURE
)
REPLACEMENT
1.REMOVE FRONT WHEELS
2.REMOVE FRONT STABILIZER LINK ASSY LH
a. Support the suspension lower arm assy with a jack using a wood block to avoid damage.
b. Remove the bolt and nut to separate the front stabilizer link assy LH.
c. Remove the nut and front stabilizer link assy LH.
