7B -- 26 MANUAL CONTROL HEATING, VENTILATION, AND AIR CONDITIONING SYSTEM
DAEWOO M-150 BL2
D18B530B
D18B531A
DTighten the bracket nut to 5 NSm (44 lb-in) (2).
DTighten the bolt securing the A/C low pressure pipe
line at the compressor to 23 NSm (17 lb-ft) (3).
2. Evacuate and recharge the system. Refer to “Dis-
charging, Adding Oil, Evacuating, and Charging Pro-
cedure for A/C System” in this section.
3. Connect the negative battery cable.
D108B532
D108B533
EVAPORATOR UNIT AND DRAIN
HOSE
(Left -- Hand Drive Shown, Right -- Hand
Drive Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Discharge and recover the refrigerant. Refer to “Dis-
charging, Adding Oil, Evacuating, and Charging Pro-
cedures for A/C System” in this section.
3. Loosen the high pressure pipe line (receiver dry-
er→evaporator) nut and the low pressure pipe line
(evaporator→compressor) nut.
4. Remove the glove box. Refer toSection 9E, Instru-
mentation/Driver information.
5. Remove the evaporator unit.
DRemove the drain hose (1).
DDisconnect the thermistor connector (2).
DRemove the screws (3).
DRemove the evaporator backward slowly (4).
WIPERS/WASHER SYSTEMS 9D–11
DAEWOO M-150 BL2
D19D537A
3. Raise and suitably support the vehicle.
4. Remove the front RH wheelhouse splash shield.
Remove the screws (1).
Remove the clips (2).
Remove the wheelhouse splash shield (3).
D109D538
5. Remove the washer reservoir assembly.
Drain the washer fluid.
Disconnect the washer hose connector (1).
Disconnect the washer pump electrical connector
(2).
Remove the bolts (3).
Remove the washer reservoir assembly (4).
D109D539
Installation Procedure
1. Install the washer reservoir assembly with the bolts.
2. Connect the washer pump electrical connector.
3. Connect the washer hose connector.
4. Install the front RH wheelhouse splash shield with the
screws and the clips.
5. Lower the vehicle.
6. Install the washer reservoir with the bolt.
7. Connect the negative battery cable.
D109D540
WASHER PUMP
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the washer reservoir assembly. Refer to
“Washer Reservoir” in this section.
3. Drain the washer fluid.
4. Remove the wiper motor from the washer reservoir
assembly.
a. Washer pump.
