2002.5 Peugeot 307 Break lights

YOUR 307 IN DETAIL69
Voice commands
The voice commands make it possible to use prerecorded words or phrases to control a certain number of functions of the
RT3 audio/telephone.
Activation of the voice commands
Press the button on the end of the lights stalk to activate this function.
Example: to recall the radio station stored on button 3, the key words are: "Radio" "Memory" "3" .
To use these key words, you must say the word "Radio", wait for the audible confirmation signal, then say the w ord
"Memory" , wait for the audible confirmation signal, then end wit h the word"3", wait for the audible confirmaton signal which
will carry out the action requested.
Notes:
in the absence of any voice commands, this function will be sw itched off after approximately ten seconds,
if a command is not understood, a double audible signal i s emitted.
Saying the word "Help"displays all of the commands available on the screen.
List of
commands available
To change the source (Radio, CD, CD changer, telephone) : "RADIO" / "CD" / "CHANGER" / "CALL"
For the radio: "LISTEN" / "PREVIOUS" / "FOLLOWING" / "MEMORY" + N° / "AUTOSTORE"
For the CD: "LISTEN" / "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N° / "SHUFFLE" / "SCAN" /
"LOOP"
for the CD changer: "LISTEN"/ "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N° / "PREVIOUS DISC" / "FOL
LOWING DISC" / "DISC NUMBER" + N° / "SHUFFLE" / "SCAN" / "LOOP"
For the telephone: "CALL" / "REPEAT" / " PEUGEOT SERVICE"
For the navigation/card: "STOP GUIDANCE" / "RESTART GUIDANCE" / "REDUCE ZOOM " / "INCREASE ZOOM "
Various: "CANCEL" / "HELP"
09-09-2002

09-09-2002
YOUR 307 IN DETAIL
72
SATELLITE NAVIGATION SYS
TEM
Introduction
The satellite navigation system
guides you, by means of vocal and
visual instructions (graphics), to
your chosen destination.
The heart of the system lies in the
use of a map data base and GPS
(Global Positioning System). With
this system you can fix the position of
your vehicle by means of a satellite
network.
The system uses the following ele
ments:
– the CDROM drive,
– the configuration CDROM
– the navigation CDROM,
– the last voice message recall control,
– the control keypad
– the CT monochrome screen or the DT colour screen. The CDROM drive
This is part of the RT3 radio/telephone.
1.
Ejection button on CDROM.
2. CDROM housing.
The navigation CD ROM
This contains all the map data.
It must be inserted in the drive, printed face upwards.
Use only CDRoms approved by PEUGEOT.
The last voice message recall control.
Pressing for more than two seconds on the button at the end o f the lights stalk
repeats the last voice information.
Certain functions or services
described may vary depending on
the version of CDROM or the coun try where the vehicle is sold.
For safety reasons, the
inputting of navigation
information by the driver
must be carried out when
the vehicle is stationary.

09-09-2002
CHANGING A BULB
Front lights
Note:on the right–hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the
bulbs with a dry cloth.
1 Dipped beam headlamps (H755W).
2 Main beam headlamps (H155W).
3 Front fog lamps (H155 W). Turn the protective cover corresponding to the faulty
bulb a quarter of a turn and remove it.
Disconnect the connector.
Press the end of the securing clip to free it. Change the
bulb.
When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing clip
is fixed properly.
Reconnect the connector.
Refit the protective cover, positioning it with the arrow
upwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with a
protective coating.
Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product. Use
a sponge and soapy water.
4 Side lights W 5 W. Pull the socket rearwards, remove the bulb and change
it.
5 Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
Change the bulb.
Note : In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
PRACTICAL INFORMATION
148

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
Direction indicator side
repeaters (WY 5W amber). Push the repeater forwards and
release the assembly.
Hold the connector and turn the
lens a quarter turn.
Change the bulb. Rear lights
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W),
left side.
Fog lamp (P 21 W), right side.
3 Brake lights (P 21 W).
4 Side lights (R 5 W).
These 5 bulbs are changed from
inside the boot: Raise and hook up the boot mat,
Remove the boot sill trim, which
is fixed by two plastic nails,
Move aside the boot trim to
access the bulb holder,
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
Press the tab and remove the
bulb holder,
Change the faulty bulb.
When refitting, take care to pass the
trim under the seal.
PRACTICAL INFORMATION 149
Amber coloured bulbs
(direction indicators and
side repeaters), must be
replaced with bulbs of
identical specification and
colour. Third brake light (saloon)
(4 W5W bulbs)
Using a 10 mm box spanner,
unscrew the 2 fixing nuts 1.
Release the lamp unit by pushing
it outwards.
Squeeze the two tabs 2to release
the bulb holder.
Change the faulty bulb.
When refitting, ensure that the
lamp unit seal has been put back
in place correctly.

09-09-2002
PRACTICAL INFORMATION
150
Number plate lights
(W 5 W) Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.

Remove the bulb holder pressing
on the tabs A,
Change the faulty bulb.
Note: f necessary, use the wheel
brace to remove the nuts.
When refitting, take care to position
the bulb holder and the light correct
ly. Third brake light (saloon)
4 W 5 W bulbs
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direc
tion of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
When refitting, ensure that the
light unit tabs are engaged cor
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1 Brake lights (P 21 W).
2 Side lights (R 5 W).
3 Direction indicators (P 21 W).
4 Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by
removing the light: Remove the light fixing nut inside
the boot,
Remove the light fixing nut out
side the boot,
Remove the light,
Unclip the harness,

09-09-2002
PRACTICAL INFORMATION
150
Number plate lights
(W 5 W) Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.

Remove the bulb holder pressing
on the tabs A,
Change the faulty bulb.
Note: f necessary, use the wheel
brace to remove the nuts.
When refitting, take care to position
the bulb holder and the light correct
ly. Third brake light (saloon)
4 W 5 W bulbs
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direc
tion of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C.
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
When refitting, ensure that the
light unit tabs are engaged cor
rectly and that the tailgate upper
trim has been put back in place
correctly.
Rear lights (estate)
1 Brake lights (P 21 W).
2 Side lights (R 5 W).
3 Direction indicators (P 21 W).
4 Reversing light (P 21 W),
left side.
Fog lamp (P 21 W), right side.
These 5 bulbs are changed by
removing the light: Remove the light fixing nut inside
the boot,
Remove the light fixing nut out
side the boot,
Remove the light,
Unclip the harness,

09-09-2002
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch Automatic gearbox starting inhibitor relay
control Manual gearbox reversing lights switch Vehicle speed sen sor
Water in diesel sensor.
2 15 A Canister solenoid valve Fuel pump.
3 10 A Power steering control unit ABS or ESP control unit.
4 10 A Injection control unit Fan unit relay control Additional heating relay control
Automatic gearbox control unit Automatic gearbox sequential cont rol
Automatic gearbox shiftlock relay.
5 15 A Particulate emission filter control unit.
6 15 A Front fog lamps.
7— Not used.
8 20 A Fan unit relay control Engine management control unit supply
Injection pump (Diesel).
9 15 A Left dipped beam.
10 15 A Right dipped beam.
11 10 A Right main beam.
12 10 A Left main beam.
13 15 A Horn.
14 10 A Front and rear headlamp wash pump.
15 30A Oxygen sensors Exhaust gas recirculation solenoid valve Ignition co il
Diesel high pressure regulator Injectors supply (petrol) Preheat co ntrol unit
Air flow sensor (Diesel) Engine management control unit (Diesel)
Injection pump (Diesel) Diesel heater.
16 40A Petrol engine air pump with automatic gearbox.
17 30A Front wiper low/high speed.
18 40A Air conditioning blower.
PRACTICAL INFORMATION
154