2002.5 Peugeot 307 Break parking brake

REAR PARKING AID
(ESTATE)
This system, installed in the rear
bumper, detects any obstacle
(person, vehicle, tree, barrier,
kerb...) situated behind the vehi
cle.
Activation
With the engine running, the sys
tem is activated when reverse
gear is engaged. A bleep indi
cates that it is active.
The proximity information is given
by an audible signal, consisting of
bleeps which become faster as
the vehicle approaches the
obstacle.
When the distance between the
rear of the vehicle and the obsta
cle is less than approxi
mately twentyfive cen
timetres, the audible sig
nal becomes continuous.
When you switch to neu
tral, the system becomes
inactive again.
Storing a speed
When you reach the required
speed, press button
2or 3. The
speed is stored and will be main
tained automatically.
Note: it is possible to accelerate
temporarily without deactivating
the cruise control.
Deactivating the stored speed
If you wish to deactivate the
stored speed:  press button 4or the brake or
clutch pedal.
Recalling the stored speed
Following deactivation, press but
ton 4. Your vehicle will return to
the last speed stored.
Cancelling the stored speed  Place knob 1in the OFFposi
tion or switch off the ignition.
Do not use the
cruise control on
slippery roads or
in heavy traffic.
09-09-2002
131130
10YOUR 307 AT A GLANCE
CRUISE CONTROL
The cruise control makes it possi
ble to maintain, at a constant rate,
the vehicle speed programmed by
the driver, irrespective of the pro
file of the road and without any
action on accelerator or brake
pedal.
To be stored, the vehicle speed
must be in excess of approxi
mately 25 mph.
Activation Place knob 1in the ON
position.
You may store a speed.  Place knob 1in the OFFposi
tion to deactivate the system.

Moving Off
With the engine running, to move
off from position P:
➜ It is essential to press the
brake pedal to exit position P,
➜ Select the required function(R ,D or M) then gradually
release the pressure on the
brake pedal; the vehicle will
move off immediately.
You can also move off from posi
tion N:
➜ Release the handbrake, with
your foot on the brake.
➜ Select the required function ( R,
D or M) then gradually release
the pressure on the brake
pedal; the vehicle will move off
immediately.
When the engine is idling
with the brakes not
applied, if function R, D or
M is selected, the vehicle
moves without the accel
erator being pressed.
For this reason, do not
leave children unsuper
vised inside the vehi
cle, with the engine
running.
126
1212YOUR 307 AT A GLANCE
AUTOMATIC GEARBOX
'PORSCHE TIPTRONIC SYSTEM'
The four speed automatic gearbox offers a choice between the comfort of
automatic integral regulation enhanced by a sportand snow pro
gramme, or the pleasure of manual gear changing.
Gear selection gate ➜ Move the lever in the gate to select one of the functions.
Once the function is selected, the indicator light for that function illumi
nates on the instrument panel display.
S: sport programme.


: snow programme.
Park: forparking or forstarting the
engine, with the handbrake on or off.
Reverse: to reverse ; select this function with
the vehicle stationary and the engine at idle.
Neutral: for starting the engine or for parking ,
with the handbrake on.
Note: if function Nis engaged by mistake while
the car is moving, allow the engine to return to
idling speed before engaging function Dto accel
erate.
D rive: for automatic gear changing.
Manual: for manual gear changing.
To change the four gears manually:
➜ Push the lever to the +symbol to change up to the next gear and pull
the lever towards the –symbol to change down to the next gear.
Note: the Ssport and snow programmes do not operate in manual mode.
09-09-2002

09-09-2002
Only use products
approved by Automobiles
PEUGEOT.
To ensure best perfor
mance from components
as important as the power steering
and the braking system,
PEUGEOT selects and offers quite
specific products.
CHECKS
Battery
At the start of winter, have your bat
tery checked by a PEUGEOT dealer.
Air filter and pollen filter
Have the filter elements replaced
regularly. If you drive in dusty con
ditions, change them twice as
often.
Brake pads
Brake pad wear depends on the style
of driving, in particular for vehicles
which are used in town, over short
distances. It may be necessary to
check the thickness of the pads,
even between services.
Parking brake
Where the parking brake travel is too
great or there is a reduction in the
performance of the system, the
handbrake should be adjusted, even
between services.
Have the system checked by a
PEUGEOT dealer. Manual gearbox
This does not need an oil change.
Check the level, according to the
manufacturer's servicing schedule.
Automatic gearbox
This does not need an oil change.
Have the level checked by a
PEUGEOT dealer, according to the
manufacturer's servicing schedule.
Oil filter
Change the filter regularly, in accor
dance with the servicing schedule.
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is
necessary to reprime the circuit:
1.4 litre HDI engine
fill the fuel tank with at least five
litres of diesel,
operate the manual repriming pump, under the bonnet, until fuel
appears in the transparent pipe
under the bonnet,
operate the starter until the engine starts.
2 litre HDI engine
fill the fuel tank with at least five litres of diesel,
operate the manual repriming pump, under the bonnet, until
you feel resistance during the
manoeuvre,
operate the starter until the engine starts.
PRACTICAL INFORMATION 141

09-09-2002
CHANGING A WHEEL
(SALOON)
Parking the vehicle Park the vehicle on level, stable
and nonslippery ground.
Apply the handbrake, switch off
the ignition and engage first or
reverse gear (position Pfor the
automatic gearbox) .
Access to the spare wheel and
the jack in the boot Lift the floor using the handle and
secure it by hooking the cords to
the hooks of the parcel shelf. Tools
The following tools are located in a
polystyrene holder in the centre of
the spare wheel:
1
Wheelbrace.
2 Centralising tool.
3 Removable chock.
4 Jack with handle.
5 Removable towing eye.
6 Alloy wheel bolt trim remover. Removing the wheel
Place the holder and the chock
3(or chock 3 on its own if neces
sary) under the wheel diagonally
opposite to the one to be
changed.
Remove the trim, using the
wheelbrace 1, pulling at the valve
passage hole.
Loosen the wheel bolts (for vehi
cles fitted with alloy wheels,
remove the chrome trim first. See
paragraph on 'Special features of
alloy wheels').
PRACTICAL INFORMATION
142

09-09-2002
PRACTICAL INFORMATION
144
Tools
The following tools are located:
– in the righthand trim of the boot,
1 Wheelbrace.
2 Removable towing eye.
3 Socket for antitheft bolts.
– in the holder in the centre of the spare wheel,
4 Jack with handle.
5 Centralising tool.
6 Bolt cover tool.
7 Removable chock. Parking the vehicle
As far as possible, park the vehi
cle on level, stable and nonslip
pery ground.
Apply the handbrake, switch off
the ignition and engage first or
reverse gear (position Pfor the
automatic gearbox). Access to the spare wheel
Open the boot.
Open the flap using the lug to
release the winch and gain
access to its control nut.
Unscrew the nut fully, using the
wheelbrace 1, to unroll the winch
cable.
CHANGING A WHEEL (ESTATE)

09-09-2002
PRACTICAL INFORMATION
152
Fuse no. Rating
Functions
9 30 AElectric windows Press operation windows (incompatible with nonp ress operation windows)
Sunroof.
10 15 A Diagnostic socket 12 volt rear socket.
11 15 A Audio equipment Multi–function display Steering wheel cont rols Automatic gearbox.
12 10 A Front right and rear right side lights Number plate and trai ler lighting Central locking switches light
ing/ alarm/hazard warning lights Air conditioning/ashtray ligh t Automatic gearbox switches lighting
Lighter Headlamp beam corrector.
14 30 A Door opening/closing controls Deadlocking controls.
15 30 A Rear windows.
16 5 A Engine fuse box Alarm Particulate emission filter Steering whee l controls Air bags.
17 10 A Rear right brake light, 3rd brake light.
18 10 A Diagnosic socket Steering wheel controls Brake pedal (stop) and cl utch switches Coolant level
switch Second brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights
Number plate and trailer lighting.
23 15 A Alarm siren Interior alarm control unit.
24 15 A Instrument panel Audio equipment Multifunction display Air conditioning Rear parking aid.
26 30 A Heated rear screen.