BO47Q±03
H24383Clip
H16718
Clip
H16719
4 Clips
± BODYSEAT BELT PRETENSIONER
BO±163
3716 Author: Date:
2005 SEQUOIA (RM1146U)
SEAT BELT PRETENSIONER
REMOVAL
NOTICE:
If the wiring connector of the supplemental restraint
system is disconnected with the ignition switch at ON
or ACC, diagnostic trouble codes will be recorded.
Never use SRS parts from another vehicle. When re-
placing parts, replace them with new parts.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE
Remove the 4 screws and front door scuff plate.
3. REMOVE FRONT DOOR OPENING TRIM WEATH-
ERSTRIP
4. REMOVE REAR DOOR SCUFF PLATE
(a) Remove the 3 screws.
(b) Using a screwdriver, remove the rear door scuff plate.
HINT:
Tape the screwdriver tip before use.
5. REMOVE REAR DOOR OPENING TRIM WEATH-
ERSTRIP
6. REMOVE LOWER CENTER PILLAR GARNISH
(a) Remove the front seat outer belt floor anchor.
(b) Using a screwdriver, remove the lower center pillar gar-
nish.
HINT:
Tape the screwdriver tip before use.
BO47U±03
H20749
BO±172
± BODYSEAT BELT PRETENSIONER
3725 Author: Date:
2005 SEQUOIA (RM1146U)
INSTALLATION
NOTICE:
Never use seat belt pretensioner from another ve-
hicle. When replacing parts, replace them with new
parts.
Make sure that the front seat outer belt is installed to
the specified torque.
If the front seat outer belt has been dropped, or there
are cracks, dents or other defects in the case or con-
nector, replace the front seat outer belt with a new
one.
When installing the front seat outer belt, take care that
the wiring does not interfere with other parts and is
not pinched between other parts.
1. Other front seat outer belts:
INSTALL RETRACTOR OF FRONT SEAT OUTER BELT
(a) Install the retractor of front seat outer belt with the 2 bolts.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
(b) Connect the pretensioner connector as shown in the il-
lustration.
2. INSTALL LOWER CENTER PILLAR GARNISH
(a) Install the lower center pillar garnish.
(b) Install the front seat outer belt floor anchor.
Torque: 42 N´m (430 kgf´cm, 31 ft´lbf)
3. INSTALL REAR DOOR OPENING TRIM WEATH-
ERSTRIP
4. INSTALL REAR DOOR SCUFF PLATE
5. INSTALL FRONT DOOR OPENING TRIM WEATH-
ERSTRIP
6. INSTALL FRONT DOOR SCUFF PLATE
7. CONNECT CABLE TO NEGATIVE BATTERY TERMI-
NAL
8. PERFORM INITIALIZATION (See page IN±20)
Some systems need initialization when disconnecting the cable
from the negative battery terminal.
