SR0Z6-01
F09913
F09914
SR-18
- STEERINGTILT STEERING COLUMN
1481 Author: Date:
2001 AVALON (RM808U)
INSPECTION
1. INSPECT STEERING LOCK OPERATION
Check that the steering lock mechanism operates properly.
2. IF NECESSARY, REPLACE KEY CYLINDER
(a) Place the ignition key at the ACC position.
(b) Push down the stop pin with a screwdriver, and pull out
the key cylinder.
(c) Install a new key cylinder.
HINT:
Make sure the ignition key is at the ACC position.
3. INSPECT IGNITION SWITCH (See page BE-16)
4. IF NECESSARY, REPLACE IGNITION SWITCH
(a) Remove the 2 screws and ignition switch.
(b) Install a new ignition switch with the 2 screws.
5. INSPECT KEY UNLOCK WARNING SWITCH
(See page BE-16)
6. IF NECESSARY, REPLACE KEY UNLOCK WARNING
SWITCH
(a) Slide the key unlock warning switch out of the column up-
per bracket.
(b) Slide a new key unlock warning switch in the column up-
per bracket.
7. INSPECT KEY INTERLOCK SOLENOID
(See page AX-16 and AX-18)
8. IF NECESSARY, REPLACE KEY INTERLOCK SOLE-
NOID
(a) Remove the 2 screws and key interlock solenoid.
(b) Install a new key interlock solenoid with the 2 screws.
9. Column shift:
INSPECT SHIFT LOCK SOLENOID, SHIFT LOCK
SWITCH AND SHIFT LOCK CONTROL ECU
(See page AX-18)
10. Column shift:
IF NECESSARY, REPLACE SHIFT LOCK SOLENOID,
SHIFT LOCK SWITCH AND SHIFT LOCK CONTROL
ECU
11. w/ Engine immobiliser system:
INSPECT TRANSPONDER KEY COIL
(See page BE-181)
12. w/ Engine immobiliser system:
IF NECESSARY, REPLACE TRANSPONDER KEY
COIL
SR0Z4-01
F08825
Torx ScrewScrew Case
F08826
Airbag Connector
Correct Wrong
F08827
Matchmarks
SST SR-12
- STEERINGTILT STEERING COLUMN
1475 Author: Date:
2001 AVALON (RM808U)
REMOVAL
1. REMOVE STEERING WHEEL PAD
NOTICE:
If the airbag connector is disconnected with the ignition
switch at ON or ACC, DTCs will be recorded.
(a) Place the front wheels facing straight ahead.
(b) Remove the 2 steering wheel lower No. 2 covers.
(c) Using a torx socket wrench, loosen the 2 torx screws.
HINT:
Loosen the 2 screws until the groove along the screw circumfer-
ence catches on the screw case.
(d) Pull out the wheel pad from the steering wheel and dis-
connect the airbag connector.
CAUTION:
When storing the wheel pad, keep the upper surface
of the pad facing upward.
Never disassemble the wheel pad.
NOTICE:
When removing the wheel pad, take care not to pull the air-
bag wire harness.
2. REMOVE STEERING WHEEL
(a) Disconnect the connector.
(b) Remove the steering wheel set nut.
(c) Place matchmarks on the steering wheel and main shaft
assembly.
(d) Using SST, remove the steering wheel.
SST 09950- 50012 (09951- 05010, 09952- 05010,
09953-05020, 09954-05020)
