2001 NISSAN ALMERA engine

ACCESSORY POWER SUPPLY Ð IGNITION SW. IN ªACCº OR ªONºNJEL0313S02
HEL360B
POWER SUPPLY ROUTING
Wiring Diagram Ð POWER Ð/Sedan With Diesel Engine (Cont'd)
EL-22

IGNITION POWER SUPPLY Ð IGNITION SW. IN ªONº AND/OR ªSTARTºNJEL0313S03
HEL361B
POWER SUPPLY ROUTING
Wiring Diagram Ð POWER Ð/Sedan With Diesel Engine (Cont'd)
EL-23

HEL362B
POWER SUPPLY ROUTING
Wiring Diagram Ð POWER Ð/Sedan With Diesel Engine (Cont'd)
EL-24

HEL016B
POWER SUPPLY ROUTING
Wiring Diagram Ð POWER Ð/Sedan With Diesel Engine (Cont'd)
EL-25

ENGINE ROOM HARNESSNJEL0008S02
HEL440B
GROUND
Ground Distribution (Cont'd)
EL-44

ENGINE CONTROL HARNESS/QG ENGINE MODELSNJEL0008S03
HEL443B
GROUND
Ground Distribution (Cont'd)
EL-48

ENGINE CONTROL HARNESS/YD ENGINE MODELSNJEL0008S09
HEL444B
GROUND
Ground Distribution (Cont'd)
EL-50

SEL918W
SEL921W
Bulb ReplacementNJEL0015The headlamp is a semi-sealed beam type which uses a replace-
able halogen bulb. The bulb can be replaced from the engine com-
partment side without removing the headlamp body.
+Grasp only the plastic base when handling the bulb. Never
touch the glass envelope.
1. Disconnect the battery cable.
2. Disconnect the harness connector from the back side of the
bulb (two-bulb type).
Pull off the rubber cap (four-bulb type).
3. Pull off the rubber cap (two-bulb type).
Disconnect the harness connector from the back side of the
bulb (four-bulb type).
4. Remove the bulb retaining ring.
5. Remove the headlamp bulb carefully. Do not shake or rotate
the bulb when removing it.
6. Install in the reverse order of removal.
CAUTION:
Do not leave headlamp reflector without bulb for a long period
of time. Dust, moisture, smoke, etc. entering headlamp body
may affect the performance of the headlamp. Remove head-
lamp bulb from the headlamp reflector just before a replace-
ment bulb is installed.
HEADLAMP
Bulb Replacement
EL-64