2001 Acura RL 3.5 Owner's Manual

Required Maintenance Record (for Normal and Severe Schedules)

Maintenance

Owner Maintenance Checks
You should check the following items at the specified intervals. If
you are unsure of how to perform any check, turn to the page given. Engine oil level — Check every
time you fill the fuel tank. See page 171.
Engine coolant level — Check the
radiator reserve tank every time
you fill the fuel tank. See page 172 .

Windshield washer fluid — Check the level in the reservoir monthly.
If weather conditions cause you to
use the washers frequently, check
the reservoir each time you stop
for fuel. See page 227 . Automatic transmission — Check
the fluid level monthly. See page
228.
Brakes — Check the fluid level
monthly. See page 230 . Tires — Check the tire pressure
monthly. Examine the tread for
wear and foreign objects. See page
245.

Lights — Check the operation of
the headlights, parking lights,
taillights, high-mount brake light,
turn signals, brake lights, and
license plate lights monthly. See

page 250.

Maintenance

Fluid Locations

AUTOMATIC
TRANSMISSION
FLUID DIPSTICK

(Yellow loop)

POWER STEERING

FLUID

(Red cap)
RADIATOR CAP BRAKE FLUID
(Gray cap)
ENGINE OIL
FILL CAP
ENGINE
COOLANT
RESERVOIR

WASHER FLUID (Blue cap)
ENGINE OIL DIPSTICK

(Orange loop)

Maintenance

Engine Oil
Adding Oil
To add oil, unscrew and remove the engine oil fill cap on top of the left
valve cover. Pour in the oil, and replace the engine oil fill cap.
Tighten it securely. Wait a few minutes and recheck the oil level. Do
not fill above the upper mark; you
could damage the engine. Recommended Oil
Oil is major contributor to your
engine's performance and longevity.
Always use a premium-grade detergent oil displaying the API
Certification Seal. This seal indicates
the oil is energy conserving, and that
it meets the American Petroleum
Institute's latest requirements. It is
highly recommended that you use Honda Motor Oil in your vehicle for
as long as you own it. Make sure the API Certification Seal
says "For Gasoline Engines."
API CERTIFICATION SEAL
CONTINUED

Maintenance

ENGINE OIL FILL CAP

Engine Oil
The numbers on the container's label tell you the oil's viscosity or weight.Select the oil for your car according
to this chart.

An oil with a viscosity of 5W-30 is
preferred for optimum fuel economy

and year-round protection in your

Acura. You may use a 10W-30 oil if
the temperature in your area never

goes below 20°F(—7°C).
Synthetic Oil
You may use a synthetic motor oil if it meets the same requirements
given for conventional motor oil: it displays the API Certification Seal,
and it is the proper weight as shown
on the chart. When using synthetic
oil, you must follow the oil and filter
change intervals given in the
maintenance schedule. Additives
Your Acura does not need any oiladditives. Purchasing additives for
the engine or transmission will not increase your car's performance or
longevity. It only increases the cost of operating your car.
Maintenance
Ambient Temperature

Engine Oil

Changing the Oil and Filter
Always change the oil and filter according to the time and distance (miles/kilometers) recommenda-
tions in the maintenance schedule.
The oil and filter collect contami- nants that can damage your engine if
they are not removed regularly.
Changing the oil and filter requires
special tools and access from
underneath the car. The car should
be raised on a service station-type
hydraulic lift for this service. Unless
you have the knowledge and proper equipment, you should have this
maintenance done by a skilled

mechanic.
1. Run the engine until it reaches
normal operating temperature,
then shut it off.

2. Open the hood and remove the

engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.

3. Remove the oil filter and let the

remaining oil drain. A special
wrench (available from your Acura
dealer) is required to remove the
filter.

CONTINUED

Maintenance

OIL DRAIN BOLT

WASHER
OIL FILTER

Engine Oil

4. Install a new oil filter according to
instructions that come with it.

5. Put a new washer on the drain bolt,

then reinstall the drain bolt.
Tighten it to:
33 lbf.ft (44 N.m , 4.5 kgf.m)

6. Refill the engine with the recom-

mended oil.
Engine oil change capacity
(including filter):
4.9 US qt (4.6 , 4.0 Imp qt)

7. Replace the engine oil fill cap.

Start the engine. The oil pressure
indicator light should go out within
five seconds. If it does not, turn off
the engine and reinspect your
work.

8. Let the engine run for several

minutes and check the drain bolt
and oil filter for leaks.

9. Turn off the engine, let it sit for

several minutes, then check the oil
level. If necessary, add oil to bring the level to the upper mark on the
dipstick.

Improper disposal of engine oil can be
harmful to the environment. If you
change your own oil, please dispose ofthe used oil properly. Put it in a sealed
container and take it to a recycling center. Do not discard it in a trash bin
or dump it on the ground.
Maintenance
NOTICE

Cooling System

Adding Engine Coolant
If the coolant level in the reserve
tank is at or below the MIN line, add
coolant to bring it up to the MAX line.
Inspect the cooling system for leaks.
This coolant should always be a mixture of 50 percent antifreeze and
50 percent water. Never add straight
antifreeze or plain water.
Always use Honda All Season
Antifreeze/Coolant Type 2. This coolant is pre-mixed with 50 percent
antifreeze and 50 percent water. It
does not require any additional

mixing.

If it is not available, you may use
another major-brand non-silicate
coolant as a temporary replacement.
Make sure it is a high-quality coolant
recommended for aluminum engines.
However, continued use of any non-
Honda coolant can result in
corrosion, causing the cooling system to malfunction or fail. Have
the cooling system flushed and
refilled with Honda antifreeze/ coolant as soon as possible.
If the reserve tank is completely
empty, you should also check the
coolant level in the radiator.
1. Make sure the engine and radiator
are cool.

CONTINUED

Maintenance
RESERVE TANK

Removing the radiator cap
while the engine is hot can cause the coolant to spray out,
seriously scalding you.
Always let the engine and radiator cool down before
removing the radiator cap.