2001 Acura RL 3.5 Owner's Manual

Indicator Lights

The instrument panel has many indicators to give you important
information about your car.
Seat Belt Reminder Light
This indicator lights when you turn the ignition switch ON (II). It is a
reminder to you and your passengers
to protect yourselves by fastening
the seat belts. A beeper also sounds
if you have not fastened your seat

belt.

If you do not fasten your seat belt,
the beeper will stop after a few seconds but the light stays on until
you do. Both the light and the beeper stay off if you fasten your seat belt
before turning on the ignition. Low Oil Pressure
Indicator
The engine can be severely damaged if this light flashes or stays on when
the engine is running. For complete
information, see page 285.

Charging System
Indicator
If this light comes on when the
engine is running, the battery is not
being charged. For complete
information, see page 286.
U.S.


Canada

Parking Brake and Brake System
Indicator
This light has two functions:
1. This indicator comes on when you turn the ignition switch ON (II). It
is a reminder to check the parking
brake. Driving with the parking
brake not fully released candamage the brakes and tires.
2. If the indicator remains lit after you have fully released theparking brake while the engine isrunning, or if it comes on whiledriving, it can indicate a problem
in the brake system. For complete
information, see page 289 .
Instruments and Controls
BRAKE

Indicator Lights

Lights On Indicator
(U.S. models only)

On cars with automatic lighting (see
page 64)

This indicator reminds you that the exterior lights are on. It comes on
when the light switch is in either the or position. If you turn the
ignition switch to ACCESSORY (I)
or LOCK (0) without turning off the
light switch, this indicator will
remain on. A reminder chime willalso sound when you open the driver's

door.

This indicator will also come on
when the light switch is in AUTO and the lights turn on automatically.
Cruise Control Indicator
This lights when you set the cruise control. See page 73 for information

on operating the cruise control.
Immobilizer System
Indicator
This indicator comes on for a few seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page 78).
This indicator also blinks several times when you turn the ignitionswitch from ON (II) to ACCESSORY (I) or LOCK (0).
Malfunction Indicator
Lamp

See page 287.
Supplemental Restraint
System Indicator

This indicator lights when you turn the ignition switch ON (II). If itcomes on at any other time, it
indicates a potential problem with
your front airbags. This light will also alert you to a potential problem
with your side airbags, passenger's side airbag automatic cutoff system
or automatic seat belt tensioners.
For complete information, see page
45.

Side Airbag Indicator
This indicator lights when you turn the ignition switch ON (II). If itcomes on at any other time, it
indicates that the passenger's side airbag has automatically shut off.
For complete information, see page
47.

Instruments and Controls

SRS

SIDE
AIRBAG

CRUISE

CONTROL

Indicator Lights

Vehicle Stability Assist
(VSA) System Indicator
This indicator normally comes on for a few seconds when you turn the
ignition switch ON (II).
If this light comes on and stays on at
any other time, or it does not come
on when you turn the ignition switch
ON (II), there is a problem with the
VSA system. Take the car to your dealer to have it checked. Without
VSA, your car still has normal driving ability, but will not have VSA
traction and stability enhancement. See page 191 for more informationon the VSA system. VSA Activation Indicator
This indicator has three functions:
1. It comes on as a reminder that you have turned off the VehicleStability Assist (VSA) system.
2. It flashes when VSA is active (see
page 191).
3. It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on for a few seconds when you turn the
ignition switch ON (II). See page 191 for more information on the

VSA system.
U.S.


Canada

Anti-lock BrakeSystem (ABS)
Indicator

This light normally comes on for a few seconds when you turn theignition switch ON (II), and when
the ignition switch is turned to START (III). If this light comes on at
any other time, there is a problem in
the ABS. If this happens, take the car to your dealer to have it checked.
With the light on, your car still has normal braking ability but no anti-
lock. For complete information, see
page 189.

Instruments and Controls

VSA

A
B S

Indicator Lights

Door and Brake Lamp Monitor
The appropriate light comes on in this display if the trunk or any door
is not closed tightly. If a brake light
does not work, the BRAKE LAMP
indicator comes on when you push
the brake pedal with the ignition switch ON (II).
A burned out brake light is a hazard when drivers behind you cannot tell
you are braking. Have your brake lights repaired right away.
All the lights in the monitor display come on for a few seconds when you
turn the ignition switch ON (II). Turn Signal and
Hazard Warning
Indicators
The left or right turn signal light blinks when you signal a lane changeor turn. If the light does not blink or
blinks rapidly, it usually means one of the turn signal bulbs is burned out (see page 250 ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
When you turn on the Hazard
Warning switch, both turn signal lights blink. All turn signals on theoutside of the vehicle should flash.
Low Fuel Indicator
This light comes on as a reminder that you must refuel soon. High Beam Indicator
This light comes on with the high beam headlights. See page 63 forinformation on the headlight

controls.

On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights (DRL) are on (see page 65 ).
"Daytime Running
Lights" Indicator

Canadian models only

This indicator lights when you turn the ignition switch to ON (II) with
the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may also be a problem with the high
beam headlights.

Instruments and Controls
D R L

Gauges

The gauges illuminate when you turn the ignition switch ON (II).

Speedometer

U.S. Models

This shows your speed in miles per hour (mph). The smaller inner
numbers are the speed in kilometers
per hour (km/h).

Canadian Models

This shows your speed in kilometers per hour (km/h). The smaller innernumbers are the speed in miles per
hour (mph).
Tachometer
The tachometer shows the engine speed in revolutions per minute (rpm). To protect the engine from
damage, never drive with the
tachometer needle in the red zone.

Instruments and Controls
TACHOMETER

SPEEDOMETER
TEMPERATURE
GAUGE
SELECT
BUTTON

MAINTENANCE

REQUIRED INDICATOR
ODOMETER

FUEL GAUGE

TRIP METER/OUTSIDE

TEMPERATURE INDICATOR
RESET

BUTTON

Gauges

Odometer
The odometer shows the total dis- tance your car has been driven. It
measures miles in U.S. models and
kilometers in Canadian models.
It is illegal under U.S. federal law andCanadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles or kilometers

indicated.
Trip Meter/Outside Temperature

Indicator

The trip meter and the outside temperature indicator use the samedisplay. To switch the display
between the trip meter and the outside temperature, press the
Select button. When you turn the
ignition switch to ON (II), what you
last selected is displayed.
Trip Meter

The trip meter shows the number of
miles (U.S.) or kilometers (Canada)driven since you last reset it.
There are two trip meters, Trip A and Trip B. Switch between these
and the outside temperature display
by pressing the Select button repeatedly. Each trip meter works
independently, so you can keep track
of two different distances.
To reset a trip meter, display it and then press the Reset button until you
hear a beep. Both trip meters will re-set if the car's battery goes dead or
is disconnected.

CONTINUED

Instruments and Controls

SELECT
BUTTON

RESET

BUTTON

Gauges

Outside Temperature Indicator
This indicator displays the outside temperature in Fahrenheit in U.S.
models, and in Centigrade inCanadian models.
The temperature sensor is located in the front bumper. Therefore, the
temperature reading can be affected
by heat reflection from the road sur-
face, engine heat, and the exhaust
from the surrounding traffic. This can cause the temperature reading
not to be correct when your speed is
under 19 mph (30 km/h).
In certain weather conditions,
temperature readings near freezing (32°F, 0°C) could mean that ice is
forming on the road surface.
Temperature Gauge

This shows the temperature of the
engine's coolant. During normal

operation, the pointer should rise

from the bottom white mark to about
the middle of the gauge. In severe
driving conditions, such as very hot

weather or a long period of uphill
driving, the pointer may rise to near

the upper white mark. If it reaches
the red (Hot) mark, pull safely to the
side of the road. Turn to page 283 for

instructions and precautions on

checking the engine's cooling
system.
Fuel Gauge

This shows how much fuel you have. It is most accurate when the car is on
level ground. It may show slightly
more or less than the actual amount
when you are driving on curvy or
hilly roads.

The gauge stays at the same fuel level reading after you turn off the
ignition. When you add fuel, the
gauge slowly changes to the new
reading after you turn the ignitionswitch back ON (II).

Instruments and Controls

Gauges

Maintenance Required Indicator
This indicator reminds you that it is time to take your car in for scheduled maintenance.
Refer to the Maintenance Schedules
for Normal and Severe Driving Conditions on pages 208— 212
For the first 6,000 miles (9,600 km)
after the Maintenance Required
Indicator is reset, it will come on for
two seconds when you turn the ignition switch ON (II). Between 6,000 miles (9,600 km) and
7,500 miles (12,000 km) this
indicator will light for two seconds
when you first turn the ignition switch ON (II), and then flash for
ten seconds.
If you exceed 7,500 miles (12,000
km) without having the scheduled
maintenance performed, this
indicator will remain on as a constant reminder. Your dealer will reset this indicator
after completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator as follows.
1. Turn off the engine.
2. Press and hold the select and reset buttons next to the instrument pan-
el, then turn the ignition switch
ON (II).
3. Hold the buttons for
approximately ten seconds until

the indicator resets.

Instruments and Controls

SELECT

BUTTON

RESET

BUTTON

MAINTENANCE REQUIRED INDICATOR