2000 MITSUBISHI CARISMA wheel

FOR EMERGENCIES
8–11
N24A206a
7. Place the spare wheel and then install
the wheel nuts with the tapered ends
facing inward, then tighten by hand
until the wheel is no longer loose.
NOTE
(1)Flange nuts (2) can be temporarily
used on the steel wheel, but return to
the original wheel and tyre as soon as
possible.
(2)If all four wheels on vehicles with
flange nuts (2) are changed to steel
wheels, use tapered nuts (1).
CAUTION
Never apply oil to either wheel bolts or
nuts as it will cause them to over-
tighten.
N24A014a
8. Lower the vehicle slowly and then
tighten the nuts diagonally in two or
three steps until each nut has been
tightened to the specified torque.
Tightening torque:
98 to 117 Nm
(Achieved by applying force of
approx. 390 to 450N at end of
wheel nut wrench supplied with
vehicle)
CAUTION
Never use extra force with your foot
on the wheel nut wrench or by using
a pipe extension as you can over-
tighten the nut.
9. Lower and remove the jack and stow
the jack, bar, wheel nut wrench and flat
tyre wheel. Have the flat tyre repaired
as soon as possible.

FOR EMERGENCIES
8–12
N24A071a
10. Check tyre inflation pressure. The
inflation pressure specification is
shown on the label. See illustration.
CAUTION
(1) Compact spare tyre is used tem-
porarily when the standard tyre
flows out. Repair the flown tyre as
soon as possible to replace the
compact spare tyre with the stan-
dard tyre.
(2) After changing the tyre, drive the
vehicle approximately 1000 km
and retighten the wheel nuts to
make sure that they are not loose.
CAUTION
(3) If the steering wheel vibrates
when driving after change of the
tyre, have the tyre checked for
balance at your MITSUBISHI
dealer.
(4) For the safe operation of your ve-
hicle, make sure you avoid mix-
ing one type of with another or
using tyres other than the speci-
fied size.
TowingEN25AIDf
Your vehicle may be towed either by another
vehicle with a rope, or by a tow truck.
The regulations concerning towing may
differ from country to country. It is recom-
mended that you obey the regulations of the
country where you are driving your vehicle.
CAUTION
(1) In the following cases, please
contact the MITSUBISHI dealer.

The engine runs but the ve-
hicle does not move.
Or abnormal noise is pro-
duced.

No automatic transmission
fluid is in the transmission.
(2) If the transmission is malfunc-
tioning or damaged, transport the
vehicle using a tow truck. (Refer
to the paragraph “Towing the ve-
hicle by a tow truck”.)

FOR EMERGENCIES
8–13
Front
N25A200a
Towing with a rope
1. For vehicles with automatic transmis-
sion check the automatic transmis-
sion fluid level. (Refer to “Automatic
transmission fluid” on page 9–4.)
If the fluid level is low, transport the ve-
hicle with all wheels off the ground.
CAUTION
If the vehicle is out of automatic trans-
mission fluid, the transmission could
be damaged.
2. The towing hooks (A) are located as
shown in the illustrations. Attach the
tow rope to the towing hooks.
Rear
N25A057a
NOTE
(1) Using any part other than the desig-
nated towing hooks (A) could result in
damage to vehicle body.
(2) Use care that the towing rope is kept as
horizontal as possible.
An angled towing rope can damage the
vehicle body.
(3) Never attempt to tow out a ditched ve-
hicle because the towing rope cannot
be kept horizontal.
3. Turn the ignition switch to the “ACC” or
“ON” position to unlock the steering
wheel.
CAUTION
(1) As the engine is not running, the
brake booster and power steer-
ing pump do not operate. This
means higher brake depression
force and higher steering effort
are required. Therefore vehicle
operation is more difficult than
usual.
(2) Do not leave the key in the
“LOCK” position. If the key is re-
moved while driving, the steering
will be locked causing loss of
control.
4. Turn on the hazard warning lamps.
5. Move the gearshift lever (manual
transmission) or the selector lever (au-
tomatic transmission) to Neutral or the
“N” position.
6. During towing make sure that close
contact is maintained between the
drivers of both vehicles, and that the
vehicles travel at low speed. Avoid
abrupt starting or stopping which
might subject the vehicles to shock.

FOR EMERGENCIES
8–15
Towing the vehicle by a tow truck
CAUTION
(1) This vehicle cannot be towed by
a tow truck using Type A equip-
ment to prevent the bumper from
deformation. If this vehicle is
towed, use Type B, Type C, Type
D or Type E equipment.
(2) In case the vehicle with automatic
transmission must be towed far-
ther than 30 km, transport the ve-
hicle with all wheels off the
ground (Type B or C) or with front
wheels off the ground (Type D).
(3) If the transmission is not operat-
ing, transport the vehicle with all
wheels off the ground (Type B or
C).
Towing with front wheels off the
ground (Type D)
Release the parking brake. Place the gear-
shift lever (manual transmission) or the se-
lector lever (automatic transmission) in the
“N” (NEUTRAL) position.
Towing with rear wheels off the
ground (Type E)
Place the gearshift lever (manual trans-
mission) or the selector lever (automatic
transmission) in the “N” (NEUTRAL) posi-
tion.
Turn the ignition key to the “ACC” position
and secure the steering wheel in a straight-
ahead position with a rope, etc.
Never place the ignition key in the “LOCK”
position. It is dangerous as the steering
wheel may lock.
Engine overheatingEN26A - Ub
If the water temperature gauge indication re-
mains in the overheating zone for a long
time, the engine may be overheating. If this
occurs, take the following corrective
measures :
1. Stop the vehicle in a safe place.

Maintenance
Engine oil 9–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Automatic transmission fluid* 9–4. . . . . . . . . . . . . .
Engine coolant 9–5. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Battery 9–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Brake fluid 9–8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Power steering fluid 9–9. . . . . . . . . . . . . . . . . . . . . . .
Clutch fluid* 9–10. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Washer fluid 9–10. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Wheel condition 9–11. . . . . . . . . . . . . . . . . . . . . . . . .
Tyre inflation pressure 9–12. . . . . . . . . . . . . . . . . . . .
Tyre rotation 9–13. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Snow tyres 9–14. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Tyre chains 9–15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fuel, engine coolant, oil and exhaust gas
leakage 9–16. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Exterior and interior lamp operation 9–16. . . . . . . .
Meter, gauge and indication/ warning lamp
operation 9–16. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Clutch pedal free play* 9–17. . . . . . . . . . . . . . . . . . . .
Brake pedal free play 9–17. . . . . . . . . . . . . . . . . . . . .
Parking brake lever stroke 9–17. . . . . . . . . . . . . . . .
Hinges and latches lubrication 9–18. . . . . . . . . . . . .
Wiper blades 9–18. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ventilation slots 9–19. . . . . . . . . . . . . . . . . . . . . . . . . .
Weatherstripping 9–19. . . . . . . . . . . . . . . . . . . . . . . . .
Additional equipment
(For regions where snow is encountered) 9–19. . .

MAINTENANCE
9–11
M32A001a
Wheel conditionEM32A-Bj
1-Location of tread wear indicator
2-Tread wear indicator
Check the tyres for cuts, cracks and other
damage. Replace the tyres if there are deep
cuts or cracks. Also check each tyre for
pieces of metal or pebbles.
The use of worn tyres can be very danger-
ous because of the greater chance of skid-
ding or hydroplaning. The tread depth of the
tyres must exceed 1.6 mm in order for the
tyres to meet the minimum requirement for
use.
If there are tread wear indicators on the tyres,
they will appear in six places on the surface
of the tyre as the tyre wears, thereby indicat-
ing that the tyre no longer meets the mini-
mum requirement for use. When these wear
indicators do appear, the tyres must be re-
placed with new ones.Be sure that the wheel nuts are tightened
correctly. Refer to the section entitled “For
emergencies” for information concerning re-
placement of the tyres.
NOTEThe mark and the location of the tyre tread
wear indicators are different depending on
tyre manufacturers.

MAINTENANCE
9–13
Type 1
M40A027a
Tyre rotationEM60A-Vc
Tyre wear varies with vehicle conditions,
road surface conditions and individual
driver’s driving habits. To equalize the
wear and help extend tyre life, it is recom-
mended to rotate the tyres immediately
after discovery of abnormal wear, or when-
ever the wear difference between the front
and rear tyres is recognizable.
Type 2
M40A043a
When rotating tyres, check for uneven
wear and damage. Abnormal wear is
usually caused by incorrect tyre pressure,
improper wheel alignment, out of balance
wheel, or severe braking. Consult your
authorized MITSUBISHI dealer to deter-
mine the cause of irregular tread wear.
Type 3
M40A049a
CAUTION
(1) A compact spare tyre can be
fitted temporarily in place of a tyre
that has been removed during the
tyre rotation. However, it must not
be included in the regular tyre
rotation sequence.

MAINTENANCE
9–14
Front
M40A035a
CAUTION
(2) If the tyres have arrows (A) indi-
cating the correct direction of
rotation, swap the front and rear
tyres on the left–hand side of the
vehicle and the front and rear
tyres on the right–hand side of
the vehicle separately. Keep each
tyre on its original side of the ve-
hicle. When fitting the tyres, make
sure the arrows point in the direc-
tion in which the wheels will turn
when the vehicle moves forward.
Any tyre whose arrow points in
the wrong direction will not per-
form to its full potential.
CAUTION
(3) Avoid the combined use of differ-
ent types of tyres and disk
wheels. This can affect driving
safety.
Snow tyresEL12AMDe
The use of snow tyres is recommended for
driving on snow and ice. To preserve driving
stability, mount snow tyres of the same size
and tread pattern on all four wheels.
Snow tyres worn more than 50% are no
longer suitable for use as snow tyres.
Snow tyres which do not meet specifications
must not be used.
CAUTION
(1) Observe permissible maximum
speed for your snow tyres and the
legal speed limit.
(2) If snow tyre must be used,
change to following tyres:

195/60R15 snow tyre (M+S)

175/65R15 snow tyre (M+S)

195/55R15 snow tyre (M+S)
Also remember that in order to
guarantee safety, the vehicle must
never be driven at speeds in ex-
cess of 160 km/h, when 175/65R15
snow tyres are being used.