4. CHECKER
1) Completely close door glass.
2) Remove trim panel.
3) Remove sealing cover.
4) Remove attaching bolt to body.
5) Loosen two nuts securing checker, and take out
checker through access hole in underside.
S5M0363A
6) Install in the reverse order of removal.
Tightening torque:
T1: 7.5
±2.0 N´m (0.75±0.2 kg-m, 5.4±1.4
ft-lb)
T2: 32
±10 N´m (3.3±1.0 kg-m, 23.9±7.2
ft-lb)
5. INNER REMOTE
1) Remove trim panel.
2) Remove sealing cover.
3) Disconnect joints of two rods.
4) Unlatch rod holder.
5) Remove inner remote assembly.
S5M0186
6) Install in the reverse order of removal.
NOTE:
If rear door is equipped with child safety lock,
check that child lock lever moves without dragging.
6. DOOR LATCH AND OUTER HANDLE
1) Completely close door glass.
2) Remove door trim panel.
3) Remove inner remote assembly.
4) Remove sealing cover around latch service
hole.
5) Remove latch and actuator assembly (A):
(1) Turn rod holder to disconnect joint between
key lock and rod.
(2) Turn rod holder to disconnect joint between
outer handle and rod.
(3) Turn rod holder to disconnect joint between
crank and rod.
(4) Loosen screws securing both latch and
actuator, then remove latch and actuator
assembly through service hole in bottom.
S5M0189A
(5) Install in the reverse order of removal.
Tightening torque (screw):
6.4
±2.0 N´m (0.65±0.2 kg-m, 4.7±1.4 ft-lb)
NOTE:
ICheck operation of each part.
ICheck each sliding part for proper lubrication.
CAUTION:
After installation, be sure lock mechanism
operates normally.
16
5-2[W2A4]SERVICE PROCEDURE
2. Door
