1999 NISSAN PICK-UP remote control

ID Code Entry Procedure
Note:
A maximum of four remote controllers can be entered. Any attempt to enter a remote controller will
erase all ID codes previously entered. Therefore, be sure to receive all remote controllers from the
vehicle owner when any ID code entry is performed.
Enter the identity (ID) code manually when:
lremote controller or control unit is replaced.
lan additional remote controller is activated.
To enter the ID code, follow the procedures below.
PROCEDURE
Close all doors and lock driver side door.
Insert and remove the key from the ignition more than seven times within 10 seconds.
Turn ignition key switch to ``ACC'' position. (The hazard warning lamps will then flash twice.)
Turn ignition key switch to ``OFF'' and remove the key from the ignition.
Push any button on the new remote controller once. (The hazard warning lamps will then flash
twice.)
At this time, the new ID code is entered and all previous ID memory is completely erased.
b
Do you want to enter any additional remote controller ID codes?
A maximum four ID codes may be entered. (After 4th ID code is entered, the registration
mode is ended.)
No Yes
ADDITIONAL ID CODE ENTRY
Release the door lock, then lock again with
driver side knob lock switch.
Open driver side door.
END.
After entering the identity (ID) code, check the operation of multi-remote control system.
NOTE:
lIf you need to activate more than two additional new remote controllers, repeat the procedure
``Additional ID code entry'' for each new remote controller.
lAny ID codes cannot be entered after termination of the ``setting mode''.
.
.
.
.
.
.
.
.
MULTI-REMOTE CONTROL SYSTEM
EL-2139

Use the chart below to find out what each wiring diagram code
stands for.
Refer to the wiring diagram code in the alphabetical index to find
the location (page number) of each wiring diagram.
Code Section Wiring Diagram Name
AAC/V EC IACV-AAC Valve
ABS BR Anti-lock Brake System
A/C, M HA Manual Air Conditioner
A/C, A HA Auto Air Conditioner
AT/IND EL A/T Indicator
AUDIO EL Audio
BACK/L EL Back-up Lamp
BA/FTS ATBATT/A/T Fluid Temperature Sensor
and TCM Power Supply
CHARGE EL Charging System
CHIME EL Warning Chime
CHOKE EC Automatic Choke
CIGAR EL Cigarette Lighter
CLOCK EL Clock
CMPS EC Camshaft Position Sensor
COOL/F LC Cooling Fan Control
DEF ELRear Window Defogger and Mirror
Defogger
DIMDIP ELHeadlamp Ð With Dim-dip Lamp
System
D/LOCK EL Power Door Lock
DTRL ELHeadlamp Ð With Daytime Light
System
ECTS ECEngine Coolant Temperature
Sensor
EGRC/V EC EGRC Ð Solenoid Valve
ENGSS AT Engine Speed Signal
FCUT EC Fuel Cut Solenoid Valve
F/HEAT EC Fuel Heater System
FICD EC IACV-FICD Solenoid Valve
FIPOT EC ISC-FI Pot
FPCM EC Fuel Pump Control Module
F/PUMP EC Fuel Pump
GLOW EC Quick-glow System
H/AIM EL Headlamp Aiming Control
HEATER HA Heater
H/LAMP EL Headlamp
HLC EL Headlamp Washer
HO2S EC Heated Oxygen Sensor
HORN EL Horn
H/SEAT EL Heated SeatCode Section Wiring Diagram Name
IGN EC Ignition System
IGN/SG EC Ignition Signal
ILL EL Illumination
INJECT EC Injector
INT/L EL Spot Lamp
KS EC Knock Sensor
LOAD EC Electric Load Signal
LPSV AT Line Pressure Solenoid Valve
MAFS EC Mass Air Flow Sensor
MAIN EC, ATMain Power Supply and Ground Cir-
cuit
METER ELSpeedometer, Tachometer, Temp.
and Fuel Gauges
MIL/DL ECMIL and Data Link Connector For
CONSULT
MIRROR EL Power Door Mirror
MULTI EL Multi-remote Control System
NATS EL Nissan Anti-theft System
NONDTC AT Non-detectable Items
OVRCSV AT Overrun Clutch Solenoid Valve
P/ANT EL Power Antenna
PGC/V ECEVAP Canister Purge
Control Solenoid Valve
PLA EC Partial Load Advance Control
PNP/SW EC Park/Neutral Position Switch
POWER EL Power Supply Routing
PST/SW EC Power Steering Oil Pressure Switch
R/FOG EL Rear Fog Lamp
ROOM/L EL Interior Room Lamp
SHIFT AT Shift Lock System
SSV/A AT Shift Solenoid Valve A
SSV/B AT Shift Solenoid Valve B
SRS RS Supplemental Restraint System
S/SIG EC Start Signal
START EL Starting System
STOP/L EL Stop Lamp
SWL/V ECSwirl Control Valve Control Solenoid
Valve
TAIL/L EL Parking, License and Tail Lamps
TCV ATTorque Converter Clutch Solenoid
Valve
WIRING DIAGRAM CODES (CELL CODES)
EL-2171

Harness layout...........................................EL-2146
Hazard warning lamp ................................EL-2038
Headlamp ..................................................EL-2018
Headlamp washer......................................EL-2092
Headlining - See Roof trim........................BT-2010
Heated oxygen sensor (HO2S) ................EC-2010
Heated seat ...............................................EL-2106
HEATER - Wiring diagram........................HA-2003
Height (Dimensions)...................................GI-2007
HLC - Wiring diagram................................EL-2092
Horn ...........................................................EL-2093
HORN - Wiring diagram ............................EL-2093
HSEAT - Wiring diagram ...........................EL-2106
I
IACV-AAC valve........................................EC-2011
ILL - Wiring diagram ..................................EL-2043
Illumination.................................................EL-2043
In vehicle sensor .......................................HA-2082
Instrument panel........................................BT-2004
INT/L - Wiring diagram ..............................EL-2048
Intake door control linkage
adjustment .............................................HA-2061
Intake sensor ............................................HA-2088
Interior .......................................................BT-2007
Interior lamp...............................................EL-2047
J
Jump seat ..................................................BT-2012
K
Keyless entry system - See
Multi-remote control system ..................EL-2129
L
Length (Dimensions) ..................................GI-2007
License lamp .............................................EL-2030
Location of electrical units .........................EL-2143
Lubricants .................................................MA-2003
M
MAFS - Wiring diagram ............................EC-2008
MAIN - Wiring diagram .............................EC-2005
Main drive gear (M/T) ...............................MT-2003
Mainshaft (M/T).........................................MT-2003
Mass air flow sensor (MAFS) ...................EC-2008
Meter..........................................................EL-2049
METER - Wiring diagram ..........................EL-2052
MIL & Data link connectors circuit ............EC-2019Mode door control linkage adjustment .....HA-2051
Mode door motor ......................................HA-2051
MULTI - Wiring diagram ............................EL-2131
Multi-remote control system ......................EL-2129
N
NATS - Wiring diagram .............................EL-2140
Neutral position switch ..............................EC-2012
O
Oil change (capacity)................................MA-2003
P
P/ANT - Wiring diagram ............................EL-2103
Park/neutral position switch (M/T) ............MT-2002
Parking lamp..............................................EL-2030
PGC/V - Wiring diagram ...........................EC-2013
PNP/SW - Wiring diagram ........................EC-2012
POWER - Wiring diagram .........................EL-2005
Power door mirror......................................EL-2104
Power supply routing .................................EL-2004
Power window ...........................................EL-2108
Propeller shaft ...........................................PD-2004
PST/SW - Wiring diagram ........................EC-2016
R
R/FOG - Wiring diagram ...........................EL-2036
Rear fog lamp ............................................EL-2036
Rear window defogger ..............................EL-2096
Reverse idler shaft (M/T) ..........................MT-2003
Reverse lamp switch (M/T) - See
Back-up lamp switch (M/T) ...................MT-2002
Reverse main gear (M/T) .........................MT-2003
Road wheel size.........................................GI-2007
Roof trim ....................................................BT-2010
Room lamp ................................................EL-2047
ROOM/L - Wiring diagram.........................EL-2047
S
S/SIG - Wiring diagram.............................EC-2014
Seat belt pre-tensioner .............................RS-2004
Seat belt pre-tensioner disposal ...............RS-2012
Shift control components (M/T) ................MT-2006
Shift fork (M/T) ..........................................MT-2006
Shift lever ..................................................MT-2006
Side trim ....................................................BT-2007
SMJ (super multiple junction) ....................EL-2173
Spiral cable ...............................................RS-2008
Spot lamp ..................................................EL-2048
ALPHABETICAL INDEX
IDX-2003

DIAGNOSTIC PROCEDURE 11 (Models for Europe
and with multi-remote control system)
SYMPTOM: SRS does not enter Diagnostic mode.
Disconnect both battery cables and check
battery voltage using circuit tester.
lIs battery voltage more than 9V?
Yes
cNo
Charge battery.
Remove driver's door switch and check
continuity between driver's door switch
connector terminals
V01andV03under the
following conditions.
Yes
cNo
Replace driver's door
switch.
Check harness continuity between driver's
door switch connector terminal
V03and
body ground.
lDoes continuity exist?
Yes
cNo
Replace or repair harness.
Replace diagnosis sensor unit.
Go to DIAGNOSTIC PROCEDURE 1
(RS-2025).
Condition Continuity
Door switch is depressed
(Door is closed).NO
Door switch is released
(Door is open).YES
SRS058
SRS736
SRS737
.
.
.
.
TROUBLE DIAGNOSES Ð Supplemental Restraint System (SRS)
Trouble Diagnoses for Air Bag Warning
Lamp (Cont'd)
RS-2038