Page 72 of 328

yellowblue
2-30
Running Your Engine While You're
Parked (Automatic Transmission)
It's better not to park with the engine running. But if
ever you have to, here are some things to know.
CAUTION:
Idling the engine with the climate control system
off could allow dangerous exhaust into
your vehicle (see the earlier Caution under
ªEngine Exhaustº).
Also, idling in a closed-in place can let deadly
carbon monoxide (CO) into your vehicle even if
the fan switch is at the highest setting. One place
this can happen is a garage. Exhaust
-- with
CO
-- can come in easily. NEVER park in a
garage with the engine running.
Another closed-in place can be a blizzard.
(See ªBlizzardº in the Index.)
CAUTION:
It can be dangerous to get out of your vehicle
without the parking brake firmly set. Your
vehicle can roll. If you've left the engine running,
the vehicle can move suddenly. You or others
could be injured. To be sure your vehicle won't
move, even when you're on fairly level ground,
always set your parking brake.
Follow the proper steps to be sure your vehicle
won't move.
Windows
Manual Windows
Turn the hand crank on each door to raise or lower
the window.
ProCarManuals.com
Page 79 of 328

yellowblue
2-37
Setting Cruise Control
CAUTION:
If you leave your cruise control switch on when
you're not using cruise, you might hit a button
and go into cruise when you don't want to. You
could be startled and even lose control. Keep the
cruise control switch off until you want to use it.
1. Move the cruise control switch to ON.
2. Get up to the speed you want.
3. Press in the SET button at the end of the lever and
release it.
4. Take your foot off the accelerator pedal.Resuming a Set Speed
Once you're going about 30 mph (48 km/h) or more,
you can move the cruise control switch from ON to
R/A (Resume/Accelerate) for about half a second.
The vehicle will return to your chosen speed and
stay there.
If you hold the switch at R/A longer than half a second,
the vehicle will keep going faster until you release the
switch or apply the brake, so unless you want to go
faster, don't hold the switch at R/A.
If the switch is held at R/A for longer than 200 seconds,
the cruise control will automatically turn off. The cruise
control function will be made available again the next
time the engine is restarted.
ProCarManuals.com
Page 80 of 328

yellowblue
2-38
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
Use the accelerator pedal to get to the higher speed.
Press the button at the end of the lever, then release
the button and the accelerator pedal. You'll now
cruise at the higher speed.
Move the cruise switch from ON to R/A. Hold it
there until you get up to the speed you want, and
then release the switch. To increase your speed in
very small amounts, move the switch to R/A for less
than half a second. Each time you do this, your
vehicle will go about 1 mph (1.6 km/h) faster.
If the switch is held at R/A for longer than
200 seconds, the cruise control will automatically
turn off. The cruise control function will be made
available again the next time the engine is restarted.Reducing Speed While Using Cruise Control
Press in the button at the end of the lever until you reach
the lower speed you want, then release it.
To slow down in very small amounts, tap the button for
less than half a second. Each time you do this, you'll go
1 mph (1.6 km/h) slower.
If the button is held for longer than 15 seconds, the
cruise control will automatically turn off. To make
cruise control available again, the cruise switch must be
moved to OFF then back to ON.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
ProCarManuals.com
Page 84 of 328
yellowblue
2-42
Let up on the accelerator before you turn on your rear
axle differential lock.
NOTICE:
Activating the rear-axle differential lock when
the rear wheels are actually spinning freely, as
they might on ice or snow, can cause you to lose
control of the vehicle. It can also damage the axle.
Turn on this control only when the wheels are not
spinning freely.
Engine Air Control (If Equipped)
If your vehicle has this control, the handle is located on
the instrument panel just to the right of the steering
wheel. The control is activated by pulling the handle out
and turning slightly in either direction to lock it.
ProCarManuals.com
Page 85 of 328
yellowblue
2-43
When the handle is pulled out, the engine air intake
supply is closed off from the front scoop and an under
hood air supply is opened. This control is intended only
for use in cold weather (32 F (0 C) or below) where
snow and ice might plug the external intake.
At temperatures above 32 F (0 C), keep the control
handle pushed in.
NOTICE:
Operating this vehicle with the engine air control
on when outside temperatures are above 32F
(0C), could lead to costly repairs not covered by
your warranty. It will also degrade fuel economy
and the engine will not run smoothly.
Exterior Lamps
Headlamps
The lamp switches are on the left side of your
instrument panel.
ProCarManuals.com
Page 96 of 328
yellowblue
2-54
Engine Speed Governor
All gasoline engines have a electronic engine speed
governor. The engine governed speeds range between
3600 and 4000 rpm depending on model, engine size
and option content.
Engine Road Speed Governor (Gasoline Engine)
This system controls maximum vehicle speed
automatically and reduces engine power until vehicle
speed gets down to maximum governed speed.
A 75 mph (120 km/h) road speed governor is
standard, but is optionally available in 60 or 65 mph
(97 or 105 km/h) speeds, depending on model.Tachometer (If Equipped)
Gasoline Engine Diesel Engine
This gage shows the engine speed in revolutions per
minute (rpm).
ProCarManuals.com
Page 97 of 328

yellowblue
2-55
Warning Lights, Gages and Indicators
This part describes the warning lights and gages that
may be on your vehicle. The pictures will help you
locate them.
Warning lights and gages can signal that something is
wrong before it becomes serious enough to cause an
expensive repair or replacement. Paying attention to
your warning lights and gages could also save you or
others from injury.
Warning lights come on when there may be or is a
problem with one of your vehicle's functions. As you
will see in the details on the next few pages, some
warning lights come on briefly when you start the
engine just to let you know they're working. If you are
familiar with this section, you should not be alarmed
when this happens.
Gages can indicate when there may be or is a problem
with one of your vehicle's functions. Often gages and
warning lights work together to let you know when
there's a problem with your vehicle.When one of the warning lights comes on and stays on
when you are driving, or when one of the gages shows
there may be a problem, check the section that tells you
what to do about it. Please follow this manual's advice.
Waiting to do repairs can be costly
-- and even
dangerous. So please get to know your warning lights
and gages. They're a big help.
Safety Belt Reminder Light (Option)
When the key is turned to
RUN or START, a light will
come on for about eight
seconds to remind people
to fasten their safety belts.
Safety Belt Reminder Tone (Option)
When the key is turned to RUN or START, a tone will
sound for about eight seconds to remind people to fasten
their safety belts.
ProCarManuals.com
Page 98 of 328

yellowblue
2-56 Charging System Indicator Light
CAUTION:
If your vehicle has an electric/hydraulic parking
brake, do not drive if the charging system light is
on. If the battery drains too much, the parking
brake can suddenly come on and stop the vehicle.
This can cause severe injury to you and others.
The charging system light is
located in the center of the
instrument cluster just
above the odometer.
It should come on briefly when you turn on the ignition,
before the engine is running, as a check to show that it
is working.If it stays on, or comes on while you are driving, have it
checked right away. You could have a loose generator
drive belt or some other problem.
Driving while this light is on could drain your battery. If
you must drive a short distance with the light on, turn
off your radio and other accessories.
Sustained driving with a generator failure could result in
a lack of back
-up braking if the engine quits or the
power steering pump should fail.
Voltmeter
When your engine is
running, the voltmeter gage,
at the lower left of the
instrument cluster, shows
the charging system voltage.
Readings in either warning zone indicate a possible
problem in the electrical system.
ProCarManuals.com